A benzoic acid and sodium benzoate solution has the concentrations listed below the reaction. What is the hydronium concentration of the solution? HC₂H5O2 + H₂O C7H5O₂ + H3O+ 0.25 M 0.35 M Кансун50, = 6.6 × 10-5 [H+] = [?] x 10) M Exponent (yellow) Coefficient (green) Enter

A benzoic acid and sodium benzoate solution has the concentrations listed below the reaction. What is the hydronium concentration of the solution? HC₂H5O2 + H₂O C7H5O₂ + H3O+ 0.25 M 0.35 M Кансун50, = 6.6 × 10-5 [H+] = [?] x 10) M Exponent (yellow) Coefficient (green) Enter

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

The solubility of borax, which is made up of sodium tetraborate (Na2B4O5(OH)4 8H2O), was analyzed. The dissolution of borax is: Na2B4O5(OH)4 • 8H2O(s) ⇌ 2 Na+(aq) + B4O5(OH)42–(aq) + 8 H2O(l) A 50 mL saturated solution was prepared. After filtration of solution, 5 mL aliquot was transferred to a flask and titrated using 0.432 M HCl. The endpoint was found to be 4.73 mL of the titrant. Tetraborate anion (B4O5(OH)42-) is a weak base which reacts with HCl like the following reaction: B4O5(OH)42–(aq) + 2 H+(aq) + 3 H2O(l) ⇌ 4 H3BO3(aq) What is Ksp expression for the dissolution? What is the tetraborate ions concentration in the filtrate? What is the molar solubility and Ksp of borax if the titration was done at room temperature (298 K)?
A fermenter was filled with 10L of 0.6 mol/L sodium sulfite solution containing 0.003M Cu2+ ion and the air sparger was turned on. After exactly 10 minutes, the airflow was stopped and a 5 mL sample was taken and titrated. The concentration of sodium sulfite in the sample was found to be 0.2 M. Calculate the oxygen uptake
A commercial vinegar was analyzed by titration to determine the percent acetic acid. Briefly, 10.00 mL of vinegar sample was diluted to 100. mL solution in volumetric flask. A 25.00 mL aliquot from the diluted vinegar required 25.55 mL of 0.1005 M NaOH to reach the phenolphthalein endpoint. Which is the correct equation between the analyte and titrant reaction? CH3COOH + NaOH → NaCH3COO + H2O 2CH3COOH + NaOH → NaCH3COO + H2O C20H14O4 + NaOH → NaC20H14O4 + H2O CH3COOH + 2NaOH → NaCH3COO + H2O
TOPIC: GRAVIMETRY SHOW THE SOLUTION The mercury in a 0.7152-g sample was precipitated with an excess of paraperiodic acid, H5IO6, according to the following reactions:5 Hg+2 + 2 H5IO6 ---> Hg5(IO6)2(s) + 10 H+The precipitate was filtered, washed free of precipitating agent, dried and found to weigh 0.3408-g. Calculate the percentage of Hg2Cl2 in the sample. Molar Masses: Hg5(IO6)2 = 1448.75 Hg2Cl2 = 472.09 Answer: 38.82% Hg2Cl2 An iron ore was analyzed by dissolving a 1.1324-g sample in concentrated HCl. The resulting solution was diluted with water, and the iron (III) was precipitated as the hydrous oxide Fe2O3·xH20 by the addition of NH3. After filtration and washing, the residue was ignited at a high temperature to give 0.5394 g of pure Fe2O3. Calculate (a) % Fe, and (b) % Fe3O4 in the sampleMolar Masses: Fe2O3 = 159.69 Fe = 55.847 Fe3O4 = 231.54 Answer: 33.32% Fe and 46.04% Fe3O4
1.1The Ksp of Ca3 (PO4 ) 2 is 1.3 × 10−26 . Estimate the solubility of this salt in units of g. L −1 . You must show any reaction equation(s) that you may think are necessary. 1.2 If a sample of solid Ca3(PO4)2 is stirred into exactly one litre of a 0.550M solution of Na3PO4, how will the solubility of the salt compare with the answer that you have obtained in question 1.1? Explain you answer in a short sentence.
You are supplied with the following: / Jy word voorsien van die volgende: NaCl(Mr= 58,443 g /mol) 2.5MTris-Cl, pH 8 solution /oplossing (1 Litre) EDTA,natriumsout(Mr= 380,2g/mol) 10% sodium dodecyl sulphate solution / natriumdodecyl sulfaat oplossing Proteïnase K solution / oplossing (50 mg dissolved / opgelos in 1 ml ddH2O) You need a digestion buffer consisting of the following: / Jy moet 'n verteringsbuffer op maak wat uit die volgende bestaan: 15m M NaCl 75 mM Tris-Cl,pH 8 16 mM EDTA,pH 8 0.8% sodium sulphate / natrium dodecyl sulfaat 0,75 mg/ml proteïnase K How will you prepare 500 ml of the digestion buffer? Show all your steps and calculations. Remember to explain exactly how you will make it up.
Consider the titration illustrated in Figure 8.] Anhydrous sodium carbonate (Na₂CO₃) is a primary standard. When 0.364 grams of the substance is placed in a conical flask, then 20.00 cm³ of sulphuric acid (H₂SO₄) solution is required to reach the end point of the titration. What is the concentration in mol·dm⁻³ of the sulphuric acid solution? [Give the answer to 3 decimal places. Do not type in the unit. Use a decimal point.] *
Potassium acid phthalate, KHC8H4O4 ( MM=204.2 ), reacts with sodium hydroxide on a 1:1 molar basis. A sample of the acid weighing 0.4823 g was titrated with NaOH, requiring 24.35 mL to reach the endpoint. Calculate the molar concentration of the sodium hydroxide solution.
I have a question. If the solubility product of CaF2 is 1.46 x 10 ^-10 mol3 dm^-9, what mass of calcium fluoride will dissolve in 500 cm3 of 0.10mol dm-3 sodium fluoride solution? The molar mass of CaF2 would be 78.1g mol^-1
50.0 mL of 1.0 M HCl (at 22.0ºC) and 50.0 mL of 1.5 M NaOH (at 22.0ºC) are mixed. The solution temperature rises to 28.9ºC. What is ΔHrxn for the reaction?
Solid aluminum hydroxide (Ksp = 1.3 x 10-33) is added to 3.50 mM Al(NO3)3 solution until there are no solid dissolution. What is the molar solubility of Al(OH)3?
You are asked to make the compound [Ni(en)3]SO4. - By using 2.611 grams of NiSO4*6H2O (s) you dissolve the sample in deionized water completely. - You then add 10ml of 25% en into the solution and mix until a single product forms - When the addition of the en is complete, you then add 15ml of ethanol and mix. - using a bench vaccine and Buchner funnel, you filter the precipitate while carefully breaking up the solid until powder form. - the product is the washed with 15ml of ethanol and 15ml of acetone. Powder the solid and leave to dry Which is the limiting reagent? Write a balanced chemical equation for the reaction. How many miles of the product can you theoretically prepare?