A coil of 0.5 H inductance and 8 ohms resistance is connected in series with a capacitor across a 200 V, 50 Hz supply. If the current is in phase with the supply voltage, determine the capacitance of th the capacitor and the p.d. across its terminals. Answer: [20.26 µF, 3.928 k]

A coil of 0.5 H inductance and 8 ohms resistance is connected in series with a capacitor across a 200 V, 50 Hz supply. If the current is in phase with the supply voltage, determine the capacitance of th the capacitor and the p.d. across its terminals. Answer: [20.26 µF, 3.928 k]

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PP: Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the...

See similar textbooks

Related questions

Q: 1. R1 1Ω V I 2 A E 24 V R2

A: We need to find out current and voltage for given circuit

Q: The value of form factor

Q: ОP-AMPS Derive the value of Vout in terms of V1, V2, R1, R2, Rf in the circuit below. V1 R1 1k2 1V…

A: In this question, We need to derive the value of Vout in terms of V1, V2, R1 and R2 and Rf .

Q: T-L with Zo=6000 ,ZR = 100 Q. Find the length and location of the single stub terminated by short…

Q: What is the low frequency break point due to the capacitor Cs for this BJT amplifier (Amplifier A)?…

A: According to the given data, the circuit will be as shown below,

Q: For the network function T(s) = the resonant frequency and s +2s +100 bandwidth are respectively.

Q: QV A: For the power system shown, calculate fault current and when a 3-phase fault occurs at point…

Q: Given the discrete time signal x[n] = cos((πn)/3) what are two different contiuous time signals…

Q: A 5 KVA , 240/2400v , 50hz. ,single phase transformer has the maximum value of flux density as 1.2…

Q: Given the analog signal x(t) = sin(480πt)−3sin(720πt) that is sample at 600 times per second, what…

Q: Derive the relationship between the output, and the input for the RLC network circuit shown below:…

Q: Discuss the potential risks to the operation of a DC motor associated with the application of a full…

A: In this solution, the discussion is about DC motor operation.

Q: JA single-phase, 250-kVA, 11-kV/415-V, 50-Hz transformer has 80 turns on the secondary. Calculate…

A: We need to analyse the given transformer .

Q: Compute for the Frequency Resonance of the Circuit

Q: a, (t) = 0.5e(180nt+ ) + 0.5e¬j(180zt+4) is sampled at F, 300 Hz.

Q: Compute for Z, (input impedance) of the given circuit. -022 V 5.6 k2 330 k2 Cc B= 80 T,= 40 k2 Cc Z,…

Q: 4. A superheterodyne receiver is to tune the range 88.1MHZ to 107.1MHZ. The RF circuit inductance is…

A: Since you have posted a question with multiple subparts, we will solve the first three subparts for…

Q: For the network function T(s) =7+2s +100° ,the resonant frequency and bandwidth are respectively.

Q: R1 = R'2 = 0.08 Q X1 = X'2 = 0.2 Q Re = 1000 Q; Xm = 400 Q It is supplied to the load Z' at 240 V, 6…

Q: Electrical Circuit Analysis Lab. 3. Calculate the value of the load for maximum power transter and…

Q: {Q.1} A three-phase induction motor runs at almost 1198 revolutions per minute (rpm) at no load…

Q: The FIR filter which its transfer function H(z)3D can be realized as shown in figure below

A: According to the question, for the circuit shown below We need to find the transfer function.

Q: i, = 3 sin(377t + 60°) R1.2 N XL 1.20 Ω Χ. 20 Xc

Q: 5.09 Transformer A: KVA=10 Transformer B: KVA=5 Re"=0.3 ohm Xe"=0.4 ohm 220:110 v Re"=0.6 ohm…

A: Given: Two transformers have the following parameters: Transformer A: kVA=10, Re''=0.3 Ω, Xe''=0.4…

Q: 2. How is transformer insulation divided? Briefly indicate the insulation arrangement indicating the…

A: Transformer insulation need to withstand very high impulse voltage.

Q: 1-(3coswo)z 1 1-(2coswo)z-1+9z-2 X(2) for the sequence x(n) =(3" coswon)u(n) is

Q: A second order system has damping ratio 0.2. The nature of step response will be a. straight line b.…

A: Given data, A second order system with Damping ratio, ζ=0.2

Q: 2. Express the unit vector å, in spherical components at the point: (a) r = 2, 0 = 1 rad, o = 0.8…

Q: O Presentation5 O File | file:///C:/Users/tphok/Downloads/HW%205.pdf Update : 3 / 4 | 90% +| E O…

Q: Three-phase transmission line 90 km long Line impedance z=(0.4+j0.88) ohm/km, Y=j5*10^- 6 S/Km,lf…

Q: -1,5z X(2) for the sequence x(n) = 2" u(-n - 1)-)" u(-n - 1) is- (z-2)(z

Q: Consider a stable LTI system with input x(n) and output y(n). The zero-pole pattern of y(n) consists…

A: In this question we need to find system function and the system impulse response.

Q: Discuss the importance of the capability curve of a synchronous machine. Explain how a capability…

Q: (a) Digital Convolution Consider an LTI system that has an impulse response h[n] given in the figure…

Q: Stepper motors are used to drive the two axes of a component placement machine used for electronic…

A: Stepper Motor: A stepper motor is an electric motor whose fundamental feature is that its shaft…

Q: The z-transform does not exist for the sequence x(n) = 3" u(n) - u(-n- 1) %3D

A: The solution is given below

Q: 28. Write the analytical expression for the waveform of Fig. 86 with the phase angle in degrees.

Q: R1=10 k2, R2=5 k2, R3=10 k2, R4-5 k2, determine the output voltage Vo of the circuit in Fig. 5 (V1…

Q: What is the complex expression for a given alternating current i = 250 sin(wt-25 deg)?

Q: To realize the system function shown below using IIR direct form I, you will need to 5 delay, adder,…

Q: A short single phase transmission line consists of two sections AB and BC. AB is 18km in length and…

A: The solution is given below

Q: *2. Using superposition, determine the current I for each network of Fig. 18.110. R Iz 32 62 E = 10…

Q: d=o 48 need to convert the drawing from a handwritten drawing to a typeface on the computer, please

A: Given, The drawing is,

Q: 2. Using mesh analysis, write the mesh equations for the following network and solve for the current…

Q: The ROC is null for the sequence x(n) = 2" u(n)-)" u(-n - 1)

Q: The figure below shows an electronic PID controller constructed using OP-AMPS. Determine the values…

Q: X(z) for the sequence x(n) = 2n-3 u(n – 3)is z-3. %3D (1-2z-3)

Q: using Laplace Transformation if v(0)=3[V] & v (0)=4[V] i(t) Vs(t) v(t) Solution:

Q: A counter counts in the sequence 1-3-4-5-6-9-8, then repeats. What is the MOD of the counter?

A: Counters are known to be sequential logic circuits. They can be synchronous or asynchronous.

Q: 50. Find the rms value of the periodic waveform in Fig. 101 over one full cycle. I ycle 6 7 $ 9 D 11…

A: We need to find out RMS value for waveform .p

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the inductor, EL, is 104 V, and the circuit has a total impedance, Z, of 20 . The frequency of the AC voltage is 60 Hz. ETITZ20VAPFER78VIRRPEL104VILXLVARsLL
The voltage across a 75 mH inductor is described by the equation νL = (25 V) cos(60t), where t is in seconds.a. What is the voltage across the inductor at t = 0.10 s?b. What is the inductive reactance?c. What is the peak current?
Given the capacitance of four capacitors Ca= 30 µF, Cb = 20 µF, Cc = 40 µF and Cd = 10 µF. If Cb and Cc are connected in parallel and the parallel combination is connected in series with Ca and the combination is further connected in parallel with Cd, calculate (a) the equivalent capacitance (b) the voltage across each capacitor if the circuit is supplied by 240 volts DC source (c) the charge on each capacitor.
A resistance of 10 ohm, an inductor of 300 mH and a capacitor of 50 uF are connected in series. If the AC voltage supplied to the connection is given by v = 300 sin (2 π 50 t + 30), write the equation for the current.
The capacitors are connected in a network as shown below. Compute the equivalent capacitance of the network between points a and b. With Vab=V0 across a and b, compute Vef
A conducting coil, with current i(t) = 4.40e−0.0250t sin(120πt), with i in amperes and t in seconds, is placed next to a second coil, end to end. At t = 0.720 s, a lab tech measures the emf across the second coil, and the result is −3.50 V. What is the mutual inductance (in mH) of the coils?
A 200-Ω resistor is connected in series with a 1.32-uF capacitor. The voltage across the resistor is vR = (1.20 V) cos (3415.59 rad/s)t. Determine the capacitive reactance of the capacitor.
A coil of 50 W resistance and 0.15 H inductance is connected in parallel with a capacitor of unknown capacitance. If the total impedance of the combination is resistance of 100 W, determine the value of the capacitance in uF .
A 30 μF capacitor is connected in parallel with a coil of inductance 50 mH andunknown resistance R across a 120 V, 50 Hz supply. If the circuit has an overallpower factor of unity, find (a) the value of R, (b) the current in the coil, and (c)the supply current.
1. The capacitive network shown in the figure is assembled with initially uncharged capacitors. A potential difference, Vab = +100V, is applied across the network. The switch S in the network is kept open. Assume that all the capacitances shown are accurate to two significant figures. What is potential difference Vcd across the open switch S?
A 40 Ω resistor and a 50 μ F capacitor are connected in series and supplied with analternating voltage v = 283 sin 314 t. The supply is switched on at the instant when the voltageis zero. Determine the expression for the instantaneous current at time t.
What is the instantaneous current at t=1 sec, if a 20 micro-farad capacitor was charged with 10 cos2(377t) joules