According to the video Monuments to Man: The Impact and Influence of Concrete on Civilization, this was the necessary ingredient for successfully making concrete by the Romans. O North African coral O Phoenician sand O París plaster O Mount Vesuvius ash 2- The strain temperature is the specific point in the fabrication and processing of glasses at which below this temperature the glass: O will fracture before the onset of plastic deformation. O has atomic diffused sufficiently rapidly that any residual stresses may be removed within about 15 minutes. O is easily deformed. O piece may be handled without causing significant dimensional alterations. O is fluid enough to be considered a liquid.

According to the video Monuments to Man: The Impact and Influence of Concrete on Civilization, this was the necessary ingredient for successfully making concrete by the Romans. O North African coral O Phoenician sand O París plaster O Mount Vesuvius ash 2- The strain temperature is the specific point in the fabrication and processing of glasses at which below this temperature the glass: O will fracture before the onset of plastic deformation. O has atomic diffused sufficiently rapidly that any residual stresses may be removed within about 15 minutes. O is easily deformed. O piece may be handled without causing significant dimensional alterations. O is fluid enough to be considered a liquid.

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter22: Surfaces

Section: Chapter Questions

Problem 22.44E: Are the following processes examples of homogeneous or heterogeneous catalysis? a Hydrolysis of...

See similar textbooks

Similar questions

Amoxicillin is an antibiotic packaged as a powder. When it is used to treat babies and small animals, the pharmacist or veterinarian must suspend it in water, so that it can be administered orally with a medicine dropper. The label says to dispose of unused suspension after 14 days. It also points out that refrigeration is required. In the context of this chapter, what is implied in the latter two statements?
Use the web to research the elastic modulus and yield strength of carbon fiber composites. How do these materials compare to aluminum, steel, and titanium?
Are the following processes examples of homogeneous or heterogeneous catalysis? a Hydrolysis of immiscible ethyl acetate (l) in an aqueous basic solution. b Conversion of NOX gases to N2 and O2 by platinum metal. c Decomposition of atmospheric ozone by NO gas. d Oxidation of ethyl alcohol, C2H5OH, by the enzyme alcohol dehydrogenase, ADH, to acetaldehyde in the body. e Solid-state conversion of C graphite to C diamond by transition metal additives at high pressure.
A chemical engineer must calculate the maximum safe operating temperature of a high-pressure gas reaction vessel. The vessel is a stainless-steel cylinder that measures 23.0 cm wide and 27.6 cm high. The maximum safe pressure inside the vessel has been measured to be 8.60 MPa. For a certain reaction the vessel may contain up to 0.959 kg of dinitrogen difluoride gas. Calculate the maximum safe operating temperature the engineer should recommend for this reaction. Write your answer in degrees Celsius. Round your answer to 3 significant digits. temperature: ] °C Ox10 ?
A chemical engineer must calculate the maximum safe operating temperature of a high-pressure gas reaction vessel. The vessel is a stainless- steel cylinder that measures 21.0 cm wide and 25.2 cm high. The maximum safe pressure inside the vessel has been measured to be 7.20 MPa, For a certain reaction the vessel may contain up to 1.45 kg of sulfur hexafluoride gas. Calculate the maximum safe operating temperature the engineer should recommend for this reaction. Write your answer in degrees Celsius. Round your answer to 3 significant digits. temperature: °C
A chemical engineer must calculate the maximum safe operating temperature of a high-pressure gas reaction vessel. The vessel is a stainless-steel cylinder that measures 35.0 cm wide and 42.0 cm high. The maximum safe pressure inside the vessel has been measured to be 2.20 MPa. For a certain reaction the vessel may contain up to 0.929 kg of dinitrogen difluoride gas. Calculate the maximum safe operating temperature the engineer should recommend for this reaction. Write your answer in degrees Celsius. Round your answer to 3 significant digits. temperature: [°C x10 X S olo Ar
Which of the following features is internal-intrinsic?A. Iron cube volumeB. NaCl(s) Crystal Weight.C. The molar mass of an atomD. The kinetic energy of oxygen gas
A chemical engineer must calculate the maximum safe operating temperature of a high-pressure gas reaction vessel. The vessel is a stainless-steel cylinder that measures 30.0 cm wide and 36.0 cm high. The maximum safe pressure inside the vessel has been measured to be 1.80 MPa. For a certain reaction the vessel may contain up to 0.834 kg of sulfur tetrafluoride gas. Calculate the maximum safe operating temperature the engineer should recommend for this reaction. Write your answer in degrees Celsius. Round your answer to 3 significant digits. temperature: |C x10, Explanation Check O 2022 McGraw Hill LLC. All Rights Reserved. Terms of Use Privacy Center | Accessibility image_50363137.JPG
A chemical engineer must calculate the maximum safe operating temperature of a high-pressure gas reaction vessel. The vessel is a stainless-steel cylinder that measures 24.0 cm wide and 28.8 cm high. The maximum safe pressure inside the vessel has been measured to be 5.20 MPa. For a certain reaction the vessel may contain up to 0.658 kg of boron trifluoride gas. Calculate the maximum safe operating temperature the engineer should recommend for this reaction. Write your answer in degrees Celsius. Be sure your answer has the correct number of significant digits.
The amount of saturation not only has an effect on the chemical but also the physical properties of the fat. For example, animal fat which is about half saturated and half unsaturated fat is a solid at room temperature but vegetable fat which is about 85 % unsaturated fat is a liquid at room temperature. This is because saturated fats are more linear compared to unsaturated which are nonlinear (bent), meaning that saturated fats are capable of more of what kind of interaction? Hydrogen bonding van der Waals Ionic bonding Covalent bonding
The activation energy for diffusion (Qa) is 80 kJ/mol for carbon diffusing into a-iron. If the Do value is assumed constant, what is the ratio of the diffusion coefficient (D) at 800°C to 500°C? Note: pay attention to units and recall that the ideal gas constant (R) is 8.314 J/mol-K. a. 0.03 b. 32.5 C. 1362 d. 0.0007
1. Railroad tracks made of 1025 steel are to be laid during the time of year when the temperature averages 10°C (50°F). If a joint space of 4.6 mm (0.180 in.) is allowed between the standard 11.9-m- (39-ft-) long rails, (a) what is the hottest possible temperature that can be tolerated without the introduction of thermal stresses? (b) If these tracks were going to be laid in the Australian Outback and see temperatures of 150 °F, what would the stress be?