Fill in the blank. Refers to the below figure, if PC1 want to send packet to PC2. Write the best bath that will be selected according to the bandwidth? PC1 100 Mbps 1Gbps R2 1Gbps R3 PC2 O General 55:34 Answer: SB

Fill in the blank. Refers to the below figure, if PC1 want to send packet to PC2. Write the best bath that will be selected according to the bandwidth? PC1 100 Mbps 1Gbps R2 1Gbps R3 PC2 O General 55:34 Answer: SB

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Related questions

Q: Question 18 Retransmissions are the data link layer occur because of network congestion. Select one:…

A: Given: 18.) Retransmission are the data link layer Occurr because of network Congestion. As…

Q: In the below picture, how many networks are there? * PCO Switcho PCS Aewitchi PCI PC6 PC2 Switch2…

A: The solution to the given problem is below. ***Note: According to Bartleby policy we are not…

Q: A8X8 Router, where each input runs at 9 Gbps. Assume, the average RTT = 220 msec. What is the rule…

A: According to the information given:- We have to solve and find find the minimum router buffer speed…

Q: Which of the following is used for modulation and demodulation? a. modem b. gateway c. protocols d.…

A: Modulation is a process of changing the properties of a signal Demodulation is a process of…

Q: If there is a computer with the address 4A: 30: 10: 21: 10: 1A Sending a data frame to your…

A: Ethernet,The source address is 6bytes and destination address is also 6 bytes.The source address is…

Q: h) As the mobile units move, they pass from cell to cell, which requires transferring of the call…

Q: When calculating Ethernet (CSMA/CD) backoff time, what do we mean by bit time?

A: Introduction: Gigabit Ethernet is the norm in server rooms and backbones, but since Ethernet speed…

Q: 6. Between two hosts A and B which are connected by a link with the bandwidth 1 Mbps and with a…

A: Given Data : Bandwidth = 1 Mbps RTT = 2 ms Tp = 1 ms = 1 * 10-3 Protocol used: Go Back N…

Q: dont answer by copying from other sources I want accurate answer I will downvote for sure if the…

A: The answer is...

Q: QUESTION 3 which in the following is NOT true about the packet switching (PS) and the circuit…

A: Given :

Q: Use a diagram to illustrate the four-way handshake protocol for channel reservation in IEEE 802.11…

A: Use a diagram to illustrate the four-way handshake protocol for channel reservation in IEEE 802.11…

Q: A thin UTP cable has higher attenuation than a thicker UTP cable. Select one: O True O False

A: In step 2, you will get the answer

Q: In baseband transmission, the required bit rate is proportional to the Bandwidth why?

A: Given that: In baseband transmission, the required bit rate is proportional to the Bandwidth…

Q: 17. A 1 KM 1long CSMA/CD with a propagation 10Mbps delay 5usec has bandwidth. Repeaters are not…

A: Here is the solution with an explanation:-

Q: !!!! R3 What is the maximum end-to-end throughput achieved by each session, assuming both sessions…

A: It is defined as how much data can be transferred from source to destination within a given…

Q: Find the physical address in memory if IP = 1234h, and CS = 1000h

A: given, IP= 1234h CS=1000h formula to find physical address in memory- Physical address = base…

Q: a) Two connecting nodes are transmitting frames using 18-bit sequence numbers. Calculate the maximum…

A: In given question, we are going to find out the Maximum sender window size and receiver window size…

Q: True or untrue, and briefly explain why your answer is correct, please answer the following: The…

A: It is a selective repetition technique used in the OSI model's data connection layer to ensure the…

Q: Consider a channel with spectrum from 3 to 7MHHZ and SNR(dB) = 20dB. What is the maximum theoretical…

A: Channel is noisy as SNR( Signal to Noise Ratio ) is given. Maximum theoretical data (C) is given by:…

Q: Q 1. In asynchronous transfer mode (ATM) (a communications protocol used on backbone networks), data…

A: Q1.

Q: Supposing

A: 11Mbps IEEE 802.11b: The 802.11b standard provides for a maximum transmission speed of 11Mbps.…

Q: 78. Each LAN type has its own strategy in the sending of a. Bits b. Bytes c. Data d. Frames

A: please see the next step for answer.

Q: Why CDMA can make users communicate at the same time using the same frequency band without…

A: In CDMA technique, users are distinguished from each other according to their CDMA codes. CDMA uses…

Q: 1- Difference between CSMA/CD and CSMA/CA. 2- Differentiate CDMA, TDMA and FDMA? 3 - In what…

A: As per guidlines we are suppose to answer 1 question : Answer : 1 CSMA/CD represents Carrier Sense…

Q: QUESTION 12 The cable in the UTP is twisted as pairs to protect the signals from interference. O…

A: Answer : - True

Q: 0 Mbps, the minimum frame size is found to be 512 bits over maximum cable length 2500 m. what should…

A: In a CSMA/CD network with a data rate of 10 Mbps, the minimum frame size is found to be 512 bits…

Q: Which transmission mode should be used to send information from a single point to another point?

A: Transmission mode is Simplex mode Half duplex Full duplex Simplex mode :- Data can be either…

Q: Which is not a feature of circuit switching? O a. Latency is not predicted O b. Packet received in…

A: Circuit switching is a system of implementing a telecommunications network during which two network…

Q: Q3: Choose True of False for all the following: 1. Chanel capacity is a merely specifies a range of…

A: 1. As a result of the operating frequency, the channel capacity is determined. It is evident that…

Q: Assume that, in a Stop-and-Wait system, the bandwidth of the line is 3 Mbps, and 1 bit takes 30…

A: The given bandwidth is 3 Mbps that is 3 Mbps requires 30 milliseconds to complete a round trip.

Q: ume that data rate for each input connection in figure above is 5 Mbps. A unit is 1 d the new…

A: 6 b 2 bytes are carried from each frame When there are 4 frame

Q: In the Ethernet packet, the "Data" part is used to contain data send from source to destination and…

A: The minimum data size in Ethernet frame is 46 bytes.

Q: Match the following. Note that even though an answer may be valid for more than one answer, only one…

A: a. Cat 3 UTP - Voice grade phone network cable b. cat 6 UTP…

Q: Supposing you have a packet whose length is 1500 bytes,calculate the transmission delay for the…

A: In given question, we have to first check maximum transmission rate(i.e., Bandwidth) and then find…

Q: A 3000 km long trunk operates at 1536 Mbps and is used to transmit 64 byte frames and uses SWP. If…

A: Introduction

Q: What is the length of a bit in a channel with a propagation speed of 2 x 108 m/s if the channel…

A: The solution to the given problem is below.

Q: . How many check bits? Suppose you want to send 3500 characters of data. a) How many check bits…

A: we will solve this question in step No. 2

Q: Assume we need to download text documents at the rate of 100 pages per second. What is the required…

A: Given: Assume we need to download text documents at the rate of 100 pages per second. What is the…

Q: Physical layer decide the transmission rate in a Network ?

A: Given that: 1. Physical layer decide the transmission rate in a Network ?

Q: What is the correct definition for Forwarding rates? O The number of ports on a single switch out of…

A: As per our guidelines we are supposed to answer only one question. Kindly repost the remaining…

Q: You don’t need to write steps for getting the answers. Just need the answers and if you can label…

A: A subnet which design a strategy to varying different size for a large network is called Variable…

Q: A CDMA sender that wants to transmit the data -1 -1 -1 +1 using the code +1 +1 -1 -1 +1 +1 -1 -1,…

A: Solution : CDMA sender's data = +1 -1 -1 +1 Code used : +1 +1 -1 -1 +1 +1 -1 -1 Now transmitted…

Q: Discussion:- 5- What is the main purpose behind making a cross UTP cat5e cable. 6- The maximum…

A: Here i explain the answer:…

Q: A user in an Internet Café' is trying to download a file. If the download operation has been…

A: Solution : Given time to download the file = 40 minutes =2400 seconds. Link speed or bandwidth =…

Question

100%

Please mr help me ?

Fill in the blank.
Refers to the below figure, if PC1 want to send packet to PC2. Write the best bath that will be selected according to the bandwidth?
PC1
100 Mbps
1Gbps
R2
1Gbps
R3
PC2
O General 55:34
Answer:
SB

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given that:

VIEW

Explanation:

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Do research on the following protocols: Can Bus protocol SPI I2C USB and draw the transmission waveform for each when sending the message "DLSU" where each of the four letters are represented by their uppercase ASCII code.
What is the length of a bit in a channel with a propagation speed of 2 x 108 m/s if the channel bandwidth is 1 Mbps? 10 Mbps? 100 Mbps?
H.W: find the efficiency for this binary symmetric channel P(y\x)= [0.1 0.9 Lo.1 0.9]
Assume we have a memory with access time of 10 nanoseconds. The memory is accessed as 4-byte words. We would like to build a 32 X 32 Router. Assume a fixed length datagram of 1100 bytes? What is the maximum transmission rate for each input (line rate) in. Gbps? What should be the capability of the router to perform address lockup (Kilo lookups per second)? units is K lookups/seconds
a. Assume there are one million books in your campus library. Approximate (to the nearest order of magnitude) how many bytes of data there are if all these books were stored online and accessible across a computer network. b. How long does it take to transfer the entire collection of books if the data rate of the transmission medium is 10 Mbps, the speed of the original Ethernet? How long does it take if we have a line with a speed of 1 Gbps? (This value represents the time needed to download your entire campus library.)
How long does the asynchronous transmission of a 150 KByte (1 KByte = 1024 bytes) file take via a serial null modem cable with a transmission speed of U baud (U bit/sec)? Here, no parity, one start bit, 2 stop bits and eight data bits are to be used. Explain your answer or give the calculation method and determine the transmission time for U = 19,200 baud.
In ethernet, when Manchester encoding is used, baud rate is 106 b/s. Find the bit rate?
A 3000 km long trunk operates at 1536 Mbps and is used to transmit 64 byte frames and uses SWP. If the speed is 6 usec/km, how many bits should the sequence numbers be? Solve it correctly , else i will downvote.
The following frame should be transmitted over a given network (the frame is shown in hexadecimal): 7E DB DD 7E C0 7D DB DC FF C0. a) If the SLIP framing protocol is used; what are the bytes that are sent on the wire (after framing)? Show your work
Suppose you have to send 28,000 packets of 1518 bytes each via a 100 Mbps Ethernet. How long would this take, in seconds? You may assume that the M in Mbps refers to a factor of 1,000,000. Enter a decimal number with millisecond accuracy (3 digits after the decimal point). Answer:
63. Token-Ring because it currently can run at both 4Mbps and 16Mbps. This means that it can be used in any topology a. 8 Kbps b. 16 Kbps c. 32 Kbps d. 64 Kbps
Now suppose there is only one link between source and destination, and there are 10 FDM channels in the link. The MP3 file is sent over one of the channels. What is the end-to-end delay?