Answered: : Find the rms value for the following…

: Find the rms value for the following sinusoidal waveforms a. v = 20 sin 754t b. v = 7.07 sin 377t c. i = 0.006 sin(400t + 20°) d. i = 16 × 10-³ sin(377t - 10°)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.10MCQ: The average value of a double-frequency sinusoid, sin2(t+), is given by (a) 1 (b) (c) Zero

See similar textbooks

Related questions

Q: Create the logic circuit design in Logic.ly 1.X AB + BC(B+C) 2. X=(A+B) C+A (B+C)

Q: Problem 09.001 - DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL PARTS Consider the sinusoidal voltage (t)…

Q: lease resolve the problem above. Same givens above but follow the way of solving in the attached…

A: here we have to find the voltage and currents.

Q: Design a two-pole high pass Butterworth active filter with curoff frequency of 10 kHzand a unity…

A: Low pass filter allow only low frequency to pass and block high frequency. High pass filter allow…

Q: Given the truth table of a set of digital circuits with four inputs (a,b,c and d) and three outputs…

A: Given: To do: Implement the output G using 2:1 multiplexer and one variable as d.

Q: If a motor has a code letter F and is 460 V and requires 11.8 hp when partially loaded when…

Q: Question 3 Find 12 using mesh analysis. Blank 1A 60 V 100 12 02 1₂2 60 12 0

A: it is asked to find I2 using mesh analysis

Q: Problem 3: Determine the controllability and observability of the given dynamic systems 3] B= [01]C…

A: It is asked to determine the controllability and observability of given dynamic systems

Q: The circuit shown in Fig (2) supplied by a voltage source of vs(t) = 50 +100 u(t) volt. Find: 1)…

A: The general expression of inductor current in series RL Circuit is given as…

Q: For the circuit below: 1. What type of filter is this? Plot the gain (vo/is) if R = 122, L = 1 H,…

Q: Find transfer function G(s)-X₂(s)/F(s)

A: The required transfer function can be obtained by writing the differential equations for both the…

Q: answer in 4 decimal places

Q: motor must be selected that provides 10 lb-ft of torque at 713 rpm. The hp required is _____.…

Q: (a) (b) (c) (d) Sketch the spectra of m(t) = cos(2л50t) + 2 cos(27150t) and m(t) = sin (2n50t) sin…

Q: 400° VI ΤΩ Ω -jz Ω Figure 1 20L90°V

A: In this question we need to find the average power absorbed by each of the five elements in the…

Q: 12 mA Figure P7.24 ww Ο εξόδο 6ΚΩ 100 με σκΩ 30 (1)

Q: Q/For the following ANN find the output (sigmoid 0.32 0.19 -0.18- 0.45 0.2 -0.46 -0.22 -0.45 -0.4…

Q: A mod-16 counter is clocked by a waveform having a frequency of 48 kHz What is the frequency of each…

A: The mod 16 counter is clocked. Input frequency is fin=48 kHz. Find the frequency of each of the…

Q: In the circuit shown, calculate the current through the capacitor for t > 0. The capacitor is…

A: The power across any element is product of voltage and current. The inductor is passive element. It…

Q: VG40- VG30 VG20- Vin O VDD t₁ PMOS 24 PMOS Q3 2₂ NMOS 2₁ NMOS - Vout

Q: 6. Problem 4 using mesh current method: In the circuit below, vs(t) = 40 cos(200t +30°) V. Use the…

Q: Given the Cascode Amplifier with Cascode Current Mirror Active Load as well as the following…

Q: Determine Vo (in V). 4 E₁ = 10 Vo + V₁ - R₁ 4.7 ΚΩ Si R₂ Vo 2.2 ΚΩ V, E₂=-5 V

A: In this question We need to determine the voltage Vo as shown the circuit. Assume forward bias…

Q: given the impedance, Z = 7 + j5 the circuit is a. purely resistive b. inductive c. DC d.…

A: It is given that: Z=7+j5

Q: Draw labeled CMOS circuits of both 2 input OR gates

A: The given circuits are as shown below, Let the two inputs in both circuits be p and q.

Q: Find the steady state expression for i.(t) in the circuit below. If V,- 750 Cos(5000t + 0) mV Vs + I…

Q: If the slip of a 2 pole motor is 0.08 the rotor speed is: Answer to the nearest whole number

Q: 4. Find i and Va Η + 30 Ι www 20 Ω 30 Ω + 10 Ω 500 io 40 Ω

A: Note: Kirchoff's Law (KCL and KVL) and Ohm's law is very important to analyze electrical circuits.…

Q: 1-What is the impulse response of a high-pass filter, H, with a cut-off freq. of 2, and with 51…

A: According to the question, we need to find the impulse response of a high pass filter with a cutoff…

Q: Calculate the pulse width, rise time, and fall time of the pulse below. DPS sprayday 88828872220 0 5…

A: Given: To find: Pulse width, rise time, and fall time of the above pulse.

Q: The corona loss on a particular ac system of frequency 60 Hz is 2 kW/phase per km. The corona loss…

A: Given- AC system- Frequency f=60 Hz, Corona loss=2 kW/phase/per km, To Find- The corona loss on the…

Q: Determine Vo (in V). E₁ = 10 Vo + V₁ - R₁ 4.7 ΚΩ ✈ Si Ą R₂ - Vo E₂=-5 V • 2.2 kΩ V, • +51

Q: Assume for t <0, the circuit is in steady state At t = 0, the switch is closed Find I₁ from t=0 tot…

A: As per bartleby guidelines, we need to answer the first three questions only. Kindly repost the rest…

Q: Norton equivalent FR₁ d 1022² 2A R₂=4-₁2 -ЛАМА- Ra 952 R4 42 RN || >

A: In this question We need to determine the Norton equivalent circuit. We are solving this problem…

Q: How do you add the gains of a two stage amplifier?

Q: Q7 Which of the following configurations is a Graetz bridge? 01 □ 2 □3 04

A: Graetz circuit is used to rectify alternating voltage. It consists of four diodes connected in…

Q: Question 4b The school board is trying to evaluate a new math program introduced to second-graders…

A: The above chart tells us that all the points which are between the upper and the lower control…

Q: In the circuit, find the value of R for which the consumed power is maximum and calculate this power

A: The maximum power will be delivered to Resistor R if the thevenin's equivalent resistance is equal…

Q: Using Millman's theorem, find the current through and voltage across the resistor R₁ in the figure…

A: Given circuit is The circuit is modified as below for calculation by Using Millman's…

Q: In the circuit shown below, find the base current IB if Ic = 301B. The base current is provided by a…

A: In this question We need to determine the base current IB as shown the circuit. Assume VCE sat =…

Q: The circuit is shown below, Vin is the sinusoidal waveform with magnitude 5V and frequency is 100…

Q: 1) Open and short circuit test tests are carried out in a 1100 VA single -phase transformer, 230/115…

Q: Question 4 Determine for the RLC circuit of Figure Q4.0, ((t) and v(t) for t> 0 given that v₂ (0) =…

Q: Assume that the range of output voltage in Figure 7.3(b) is from 3.6 V to 7.5 V. Which of the…

A: Given data Input voltage, Vi=10 V Output voltage range, Vo=3.6 V to 7.5 V Potentiometer resistance…

Q: This wind farm needs a 250 km connection laid to Sommerville. The choice is either a 3 phase system…

A: Given Two systems three phase AC system and Bipolar DC system Voltage =Vac = 400 kV We assume this…

Q: what is the impedance of the neutral line

A: Balanced 3 phase supply is applied to the balanced output It is asked to find impedance of neutral…

Q: 5Ω 40/90° V (+ 8Ω 7j2Ω την Μ 3/0° A 10 Ω j4Ω a h 20 Ω j15 Ω

A: In this question We need to determine the current Io using the thevenin equivalent theorem and…

Q: Construct a state diagram that has an input w and an output z. The output z is equal to 1 if either…

A: The given problem is from state machine. Let there will be overlapping of sequence is allowed. The…

Q: Phi is not zero. How it is zero because it does not start at the origin? Please explain?

A: The general expression of sine or cosine waveforms is given as A sin(ωt+ϕ)A cos((ωt+ϕ)

Q: Derive the Boolean Expression for the following arrange Select one ALES

A: Given arrangement- To find- Boolean expression

Question

P.4: Find the rms value for the following sinusoidal waveforms
a. v = 20 sin 754t
b. v =
7.07 sin 377t
c. i = 0.006 sin(400t + 20°)
d. i 16 x 10-3 sin(377t - 10°)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The average value of a double-frequency sinusoid, sin2(t+), is given by (a) 1 (b) (c) Zero
The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
If the rms phasor of a voltage is given by V=12060 volts, then the corresponding v(t) is given by (a) 1202cos(t+60) (b) 120cos(t+60) (c) 1202sin(t+60)
13 ) RMS value of sinusoidal voltage is given by Vrms= 5 V, Calculate the value of peak voltage Vm? a. 1.4142 V b. 5 V c. 3.535 V d. 7.07 V
Sketch the waveform, determine the phase difference, and calculate the rms values of the following waveforms: v(t) = 60 sen(wt + 20) e i(t) = 12 sen(wt - 20).
From the following waveform, calculate the RMS value and the average value Choices for RMS value: A)13.7V B)11.5V C)15.9V D)15.2V Choices for average value: A) 0V B)6.37V C)11.55V D)12.73V
The single phase AC sinusoidal voltage then the rms value of the voltage v is .........
A sinusoidal voltage wave has an RMS value of 70.71 V and a fequency of 60 Hz. Determine the value of the voltage if t=0.0014 s, after the wave crosses with the wt axis.
If the rms phasor voltage is given as V angle= 60-degree, then how v(t) can be written.
Calculate the rms value of a sinusoidal current of maximum value 20A.
Given the RMS value of the following voltage waveform is sqrt(8/3) , determine the maximum value, B, of the waveform.
The average value of a sinusoidal current is 300A. What is it’s rms value? Group of answer choices 444 A 202 A 333 A 101A