Given the earth dam and flow net shown, calculate the seepage loss under the dam if the water height behind the dam is 15ft. The soil has a hydraulic conductivity of 100 ft/year. EL 0 Water Level EL-10--- 730 ft³/year 650 ft³/year 500 ft³/year 890 ft³/year Water Level You 130 lb/ft³ Impervious Stratum

Given the earth dam and flow net shown, calculate the seepage loss under the dam if the water height behind the dam is 15ft. The soil has a hydraulic conductivity of 100 ft/year. EL 0 Water Level EL-10--- 730 ft³/year 650 ft³/year 500 ft³/year 890 ft³/year Water Level You 130 lb/ft³ Impervious Stratum

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.4P

See similar textbooks

Similar questions

Calculate the equivalent hydraulic conductivity for the following soil sample: 1.5 ft Water O: K-2x10* ft/sec O: K=3x10* ft/sec O: K-4x10 ft/sec : K-5x10 ft/sec Water (2) 4 layers@ 0.5 ft thick each 10 ft O 0.00035 ft/sec O 0.00031 ft/sec O 0.00003
SITUATION 4 The soil under a dam has three layers with different coeffident of permeability. Determine the following: (a) Calculate the equivalent hydraulic conductivity in am/sec. (b) Compute the Transmissibility of the soil when the water table is at the ground surface, in sq.cm/ sec (Note: Transmissibility= k x distance) (c) Determine the seepage velocity of water moving through soil if it has a void ratio of 0.60 and a hydraulic gradient of 0.0018 in cm/hr. Illustration for Situation 4 KI = 0.000 I0 cm/sec at 3m K2= 0.032 cm/sec at 4m K3= 0.000041 cm/sec at Gm
A section of a homogeneous earth dam is shown in the Fig.1. Calculate the seepage discharge per metre length, through the body of the dam. The coefficient of permeability of the dam material may be taken as 8 x 10-$ m/s. Apply 6. 4m Free board 2m 2:1 14m 12 m 2-5:1
An unconfined aquifer is 100 feet thick was evaluated using a field pumping test. The depth to groundwater is 10 feet. At a distance of 1000 feet, the drawdown was 40 feet, and at a distance of 5000 feet it was 20 feet. Find the permeability of the aquifer assuming that a steady-state of 960 gal/minute during the test in ft/sec.
The soil has cross sectional area of flow of 1 ft² and a hydraulic conductivity of 1.45 x 104 ft/sec. Calculate the rate of flow. Supply 7.6 ft³/day 6.3 ft³/day 3.1 ft³/day 4.8 ft³/day 1 ft Soil 2 ft H Outflow, Q
Figure below shows layers of soil in a tube that is 100mm x 100mm incross section. Water is supplied at a constant head difference of 400 mm across thesample. The hydraulic conductivities of the soils in the direction of flow through them areas follows. Soil k (cm/sec) Porosity, n (%) A 1x10-2 25 B 3x10-3 32 C 4.9x10-4 22 a. Calculate the equivalent k in cm/sec.b. Calculate the rate of water supply in cm^3/hrc. Calculate the seepage velocity through soil C in m/sec.
Q2: A) At the beginning of a given day a reservoir has a surface area 30 Km². The inflow to the reservoir during the day was measured to be 80m/s and the reservoir outflow was measured as 15m/s. In addition, the day was dry and the seepage is 10% of the inflow. Assume the area of the reservoir does not change significantly by the end of the day. Determine the reservoir evaporation in mm/day where the reservoirs level is decreased 2 cm?
(c) A pumping well was drilled penetrating straight into an unconfined aquifer with the thickness of 42 m. The distance of pumping well with first extraction well and second extraction well are 20 and 180 m, respectively. Meanwhile, the drawdown for the first extraction well is 4.5 m, and the second extraction well is 1.5 m. The constant pumping rate has been set at 0.09 m³/s. (i) Sketch the cross section of unconfined aquifer system and label the values. (ii) Determine hydraulic conductivity of the groundwater through the soil media when it was being pumped out and classify the type of soil according to TABLE Q1(c). (iii) Point out THREE (3) negative effects that might happen for over - pumping aquifers.
A 12 inch diameter well was installed in an unconfined aquifer consisting of a 60 foot thick layer of sand. The water table was 15 feet below the ground surface before pumping of the well began. The well was then pumped at a rate of 30 gallons per minute and the water level in the well dropped to 45 feet below the ground surface after a steady-state condition was reached. The radius of well influence is 4000 feet. a) Calculate the permeability of the sand b) Compute and plot the drawdown surface
Q₂: A) At the beginning of a given day a reservoir has a surface area 30 Km. The inflow to the reservoir during the day was measured to be S0m/s and the reservoir outflow was measured as 15m/s. In addition, the day was dry and the seepage is 10% of the inflow. Assume the area of the reservoir does not change significantly by the end of the day. Determine the reservoir evaporation in mm/day where the reservoirs level is decreased 2 cm?
A sand layer of the cross-sectional area shown in the figure has been determined to exist for a 500 m. length of the levee. The hydraulic conductivity of the sand layer is 3 m/day. Determine the quantity of water which flows into the ditch in cu.m/min. * O (3 Points) w.s. El.=160 Levee Impervious layer' 10 m w.s. El.=150 2 m Sand Ditch Impervious layer 125 m O 240 cu.m/min O 0.166 cu.m/min O 288 cu.m/min
12 Determine the quantity of seepage under the dam cross section shown in m3/s/m if the soil has hydraulic conductivity, k=0.0001 meter cube per second. Note the numbers in the figure from left to right are:2.0m, 1.8m, 2.4m and 8.0 m, respectively. 2.00m 8.00 m 1.80 m Datum 12.40m 777 Enter your answer