In a half wave rectifier, the input sine wave is 200sin200 nt Volts. If load resistance is of 1k then the average DC power output of half wave rectifier is O 4.016 W O 5.016W O 3.25W O 6.25W O not all above

In a half wave rectifier, the input sine wave is 200sin200 nt Volts. If load resistance is of 1k then the average DC power output of half wave rectifier is O 4.016 W O 5.016W O 3.25W O 6.25W O not all above

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 3RQ: Diodes and rectifiers allow current to _________. flow in one direction only flow in both...

See similar textbooks

Related questions

Q: For half wave rectifier circuit shown below Is = 5sin(wt), Idc =?. Is O a. 2.5 A O b. 1A О с. ЗА Od.…

A: Given, Is = 5sin(wt) -----(1) Is = Imsin(wt) --------(2) Equating (1) and (2), Im = 5 amperes

Q: A 50 ohms load resistance is connected across a half wave rectifier. The input supply voltage is…

A: This is circuit problem.

Q: For a full wave rectifier, when input frequency if 60HZ, output frequency is

Q: A half wave rectifier, given that, Vs=68sin(2?ft), Ro=10 Ohm, f=50 Hz, What is the value of…

Q: For a half wave controlled rectifier VS = 50 sin wt , α = 30° and load of 20Ω Find 1. Vav 2. Vrms 3.…

A: Note: As per our honor code, we are authorized to answer up to 3 sub-parts, we’ll answer the first…

Q: A full wave controlled rectifier uses O diodes only both diodes and thyristors none of the mentioned…

A: A controlled rectifier is one in which the AC is converted into DC and then the power fed to the…

Q: one of the diodes in a bridge full-wave rectifier opens, the output is_ Input frequency will be…

A: Dear in this question, one diode gets open in a full wave rectifier and we are asked to find which…

Q: b) A single phase diode rectifier with RC load is connected to a grid with 240V and 50Hz. Find C…

A: Given data: Vin=240 V RMS P=100 WVr,pp=20 V f=50 Hz

Q: In a full wave bridge rectifier, the input sine wave is 40sin100nt. What will be the average output…

A: given in a full wave bridge rectifier , the input sine wave is 40 sin 100πt .here we have to find…

Q: 3. A certain unfiltered FW rectifier is powered by 140Vrms with turn ratio of N1:N2 = 5:1 Determine;…

A: The circuit diagram is shown below, Where,V1=140 VrmsN1:N2=5:1RL=10kΩ

Q: Be a single-phase half-wave rectifier with an RL load. The sinusoidal input voltage has a frequency…

A: The answer is

Q: Find the output waveform for the following full wave rectifier? 10:1 D, VD1=0.3v V½ ms=115v R= 10kn…

A: Given Vrms = 115 V RL = 10 k VD1 = 0.3 V P : S = 10 : 1

Q: What will be the out put of the H.W.R+PMMC meters, if an average responding a.c meter of half-wave…

A: Measuring Instruments: Generally we use two types of measuring instrument in electrical system.…

Q: 03: bridge rectifier eircuit shown in Figure (1), with a forward diode resistance Rd=12, and Rd=o…

Q: Draw a half-wave rectifier circuit and explain what happened to the diode during (5) positive and…

A: Half-wave rectifiers circuit are used to transform AC voltage to DC voltage. A halfwave rectifier…

Q: If one of the diodes in a 60 Hz bridge full-wave rectifier opens, the output is Select one: a.…

Q: A 230 V input voltage is connected to a full-wave rectifier. Calculate the DC voltage, DC/AC power…

Q: A half-wave rectifier with the diode arrow pointing away from the load has a DC output voltage of…

A: The solution is given below. The half wave rectifier can be solved by using waveform.

Q: A full wave rectifier is operated from 60 Hz, 110 V rms line. It has 200 µF filter capacitor and a 5…

Q: a/Draw the output voltage waveform for the bridge rectifier in this figure : 5:1 D4 120 V ms ,D3 D…

Q: The input voltage of a single-phase full- wave diode rectifier is v= 100 sinwt Volts and the…

A: The solution can be achieved as follows.

Q: b. Full-wave Center-tapped Rectifier. Consider the following circuit on the right. D1 2:1 b.1 Show…

Q: For a full-wave controlled rectifier, find out the RMS output voltage

A: Given data Vm = 220

Q: In a half wave rectifier, the input sine wave is =250sin400 nt Volts. Find output ripple frequency…

Q: Q17: A fully-controlled three-phase bridge rectifier circuit is modified by placing a commutating…

Q: A half-wave rectifier is connected to a 8910 load in parallel with a capacitor, if the supply…

A: Given : In the given question they have mentioned a half wave rectifier with a RC filter. Here…

Q: In a half wave rectifier, the sine wave input is 300sin300t. The average value of output voltage is?…

A: The solution can be achieved as follows.

Q: In a full wave bridge rectifier, the transformer secondary voltage is 10sinwt. The forward…

A: NOTE: Since you have posted a question with multiple subparts, we will solve the first three…

Q: In a half wave rectifier, the input sine wave is 200sin200 nt Volts. If load resistance is of…

A: The equation of sine wave is in the form Em sin ωt. Comparing it, we get Em=200 Power = Em22πRL…

Q: Exam: Find the output waveform for the following full wave rectifier and the current pass through…

A: To solve above problem, one should know what rectifier circuit is and how it is working. To charge…

Q: The single phase full bridge rectifier in shown below has a DC load current Il of 10A. The source…

Q: A Single Phase Half Wave Controlled Rectifier has a DC voltage of 20V and a source voltage of…

A: The solution can be achieved as follows.

Q: 2 k2 V; = 120 V (rms) A Ideal

A: The above circuit is a negative shunt clipper circuit. For the positive half-cycle, the output…

Q: In a full-wave rectifier, the dc voltage level is larger than the ripple voltage level. Select one:…

A: In full wave rectifier the DC output voltage is larger than the the ripple voltage level. The…

Q: Given a bridge full-wave rectifier with average voltage of 10V and a primary peak voltage of 120V.…

Q: In a full wave bridge rectifier, the transformer secondary voltage is 20sinwt. The forward…

A: For this case we assume the diodes as ideal diode and add the resistance of diode to load for simple…

Q: bläi 5 For a bridge rectifier Assuming the diodes to be ideal, determine (a) d.c. output voltage,…

A: For this problem we can easily solve this by using formulas.

Q: the sine wave input is 50sin5ot. In a half wave rectifier, If the load resistance is of 2KO, then…

A: Given a sine wave 50sin50t is applied at the input of half wave rectifier with 2 kilo ohm load.

Q: An ac supply of 220 V is applied to a Ha wave rectifier circuit through a transforme of turn ratio…

Q: Q2:a- If the input voltage source to full phase diode rectifier of high inductive load is as shown…

A: The input voltage source is given Firstly, to find the dc power Vdc=2π×VVdc=2π×200 =127.38…

Q: If one of the diodes in a bridge full-wave rectifier opens, the output is

A: if one of the diodes is open in the full-bridge rectifier then the full bridge rectifier will work…

Q: If the peak ac voltage of 12V is applied into a half-wave rectifier, find: a. the ripple voltage…

Q: 4) If the turn's ratio of the transformer in a half wave rectifier circuit is decreased, the forward…

A: Turns ratio of transformer is decreased current is increased. Why because in transformer N1/ N2 =…

Q: Ge 12V o Si Si 6.6kN Figure 1 Figure 1 shows a bridge rectifier circuit using germanium diodes. (i)…

A: Given : In the above given question we have three diodes and voltage source. In the question…

Q: See the figure of a half-wave rectifier with R-C load. v, =120/2 sin(120.T) and R=1k2. Determine :…

Q: For a half wave rectifier with efficiency (N) 40.65 % and input ac power 25mW.Compute the output dc…

Q: full wave rectifier circuits a-An AC input and at least four diodes are required b-One AC input,…

A: In this question , we will write about full ave rectifier...

Q: single-phase half- wave controlled rectifier circuit with inductive load (L-0.1 and R=102) and the…

Question

In a half wave rectifier, the input sine
wave is 200sin200 nt Volts. If load
resistance is of 1k then the average
DC power output of half wave
rectifier is
O 4.016 W
O 5.016W
O 3.25W
O 6.25W
O not all above

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Three Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Diodes and rectifiers allow current to _________. flow in one direction only flow in both directions divide paths of flow none of the above
Q5) The schematic circuit in PLECS for a single-phase rectifier is shown below, Q5) The schematic circuit in PLECS for a single-phase rectifier is shown below, Thyristor Crout Probe Pulse Generator VC, pulses Probe Scope Thy Orso v Joad O R: 1 The output voltage across R is depicted in 0.5 0.0- b) 0.2 0.0 d)
A half-wave rectifier is connected to an AC source of 20 Vm(peak). The de output voltage is 65Vdc 3.14Vdc 3Vdc 6.14Vdc
The time period of the output voltage of a single phase bridge rectifier is 25/3 ms. The supply frequency will be Hz.
1 phase full wave rectifier vs=220 1. measure Vo mean / Io mean / Vo r.m.s / Io r.m.s 2. draw Vi / Vo / Io R=100
A 1 - ∅ full-wave rectifier is made by using thyristors. If the peak value of the sinusoidal input voltage is Vm and the value of the delay angle is 45 degree, find the average value of output voltage Select one: a. 0.65 VM b. 0.85 VM c. 0.45 VM d. 0.25 Vm
A three phase full wave rectifier is shown below. The input phase voltage peak is Vm=311.128 V. The load is purely resistive of value 52. The DC and RMS output voltages are respectively equal to: Secondary 太D太D,太D, 太D。太De太D, b. Select one: O a. 180V, 240.2V O b. 514.6V, 515.04V O c. 180V, 197.2V O d. 220V, 249.2V
A sinusoidal voltage wave form of peak voltage í V and frequency f = 60Hz is applied to a bridge rectifier and to half wave rectifier separately. The Differences of average values and output frequencies are
Exam: Find the output waveform for the following full wave rectifier and the current pass through R1? D Vpi= 0.7v 1:4 R= 10kn ww D2 Vp=0.7v
A full-wave center-tapped rectifier has a secondary maximum voltage of 20 Vm and a 4.7 kQ load resistance. What is the dc load current for the circuit? O 1.26 mA O 2.61 mA O 1.4 mA O 61 mA
single-phase bridge rectifier has an RL load with R=15 Ohm and L = 60 mH. The ac source Vs = 100 sin (377t) Determine THD taking Is1 = 3.9
In a bridge full wave rectifier, the input sine wave is 25sin(30nt). The output frequency will be Select one: a. 15Hz b. 30Hz c. 25Hz d. 45Hz