Instructions: On occasion, the notation A = [A, q] will be a shorthand notation for A = A cos + A sin .Exhibit 3-1The three forces shown act on a particle.30.0 N65.0 Nt30-2020.0 NUse this exhibit to answer the following question(s).Refer to Exhibit 3-1. What is the direction of the resultant of these three forces?

A vector quantity is having both magnitude and direction. Examples of vector quantities are force,…

Instructions: On occasion, the notation A = [A, q] will be a shorthand notation for A = A cos + A sin . Exhibit 3-1 The three forces shown act on a particle. 30.0 N 20.0 N 20 30 65.0 N X Use this exhibit to answer the following question(s). Refer to Exhibit 3-1. What is the direction of the resultant of these three forces?

Instructions: On occasion, the notation A = [A, q] will be a shorthand notation for A = A cos + A sin . Exhibit 3-1 The three forces shown act on a particle. 30.0 N 20.0 N 20 30 65.0 N X Use this exhibit to answer the following question(s). Refer to Exhibit 3-1. What is the direction of the resultant of these three forces?

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter5: Newton's Law Of Motion

Section: Chapter Questions

Problem 20P: A telephone pole has three cables pulling as shown from above, with and (a) Find the net force on...

See similar textbooks

Similar questions

A uniform plank with length 2 m, mass 30k is supported by three ropes as shown by the blue vectors in the above figure. If the person's weight is 700 N, d = 0.5 m from the left, find tension T1,T2 and T3
A 20.0 kg box is held at rest by two ropes that form theta=23 degrees angles with the vertical. An external force F is also applied vertically downward on the box. The force exerted by each of the two ropes is denoted by T of magnitude 660 N. A force diagram, showing the four forces that act on the box in equilibrium , is shown in the figure. Use g=10m/s2. What is the magnitude of the external force F (in unit of N) applied on the box?
Three forces act at point O. If it is known that the y-component of the resultant R is -5.4 kN and that the z-component is 6.6 kN, determine F3, θ, and R.
Solve Prob. 3.110, assuming that P = 138 N.(Reference to Problem 3.110):To test the strength of a 625 × 500-mm suitcase, forces are applied as shown. If P= 88 N, (a) determine the resultant of the applied forces, (b) locate the two points where the line of action of the resultant intersects the edge of the suitcase.
Discovery,Discussion and writing 1.Use the formula x=1/32 v² sin 20 to explain why the projection angle that maximizes the distance a projectile traves is 0=45° when h0= 0. Please refer to the problem and figure.
The three forces shown is to be replaced by a single resultant force. Determine the distance d (in mm) below point A to which the single resultant force must be applied. If you replace the three forces shown by an equivalent force–couple system at point A, what will be the magnitude of the couple (in N-mm)?
What force would balance (equilibrant) the resultant of the following vectors: 100 N, 45° north of east, 50 N east, and 80 N south. Use the component method in solving for the resultant of the given vectors. Check your work using the graphical method. Using the component method of adding vectors, find the resultant of the following vectors: 50 N to the right, 40 N downward, and 30 N, 30° North of East. What is the equilibrant (the one which balances the resultant vector) of the given vectors? Find the resultant of the following vectors: 30 m east, 40 m south, and 50 m west.
Answer only direction of the force (N, E, W, S, etc.) or provide diagram with x, y, z axis.
In a traction apparatus, three cords pull on the central pulley, each with magnitude 22.0 N, in the directions shown in the figure. What is the sum of the forces exerted on the central pulley by the three cords? Give the magnitude and direction of the sum.
Solve for the resultant of the system of non concurrent forces as shown, Each square in the grid is 50 cm x 50 cm in dimension.
Refer to Monkey Mo in Figure 1. What will be the magnitude of vector S if the rope that supports Mo is vertical? If the rope were horizontal, how would vector S be different? Why can’t both vectors T and S be horizontal? Figure 1 Monkey Mo and the three forces that provide equilibrium
Given a 2-D force system with geometry as shown. Find the magnitude of the equivalent resultant force (N) if P = 305 N , Q = 577 N, and T = 403 N .