Josh threw the marble vertically upward with a speed of 66 ft/s from a bridge. On the way down, the marble just misses the bridge and falls into the water 5 seconds after having been thrown upward. Find the height of the bridge in feet above the water

Josh threw the marble vertically upward with a speed of 66 ft/s from a bridge. On the way down, the marble just misses the bridge and falls into the water 5 seconds after having been thrown upward. Find the height of the bridge in feet above the water

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.26P: The velocity vector of the boat has two components: v1 is the velocity of the water, and v2 is the...

See similar textbooks

Related questions

Q: 2.76 Steel railroad rails 10 m long are laid with end-to-end clearance of 3 mm at a temperature of…

Q: Determine the x- and y-coordinates of the centroid of the shaded area shown

Q: Consider a 150-MW steam power plant that operates on a simple Rankine cycle. Steam enters the…

Q: 2.75 A steel rod is stretched between two walls. At 20°C, the tensile force in the rod is 5000 N. If…

Q: Find the efficiency of engine Input power-1000 J Ouput power-200 J

A: Find the efficiency of the engine.

Q: 3. For a single element beam as shown in figure below, its equivalent nodal load matrix should be W

Q: Q8: The 25-kg bar BD is attached to the two light links AB and CD and moves in the vertical plane.…

Q: A spray drier is used to dry skim milk to a final moisture content of 5.00%. The air entering the…

Q: 1. In an engine rotating at 1500 rpm, a cam is used to open and close a valve during half of its…

A: Given: Speed of the engine=1500 rpm Hence speed of the camshaft=15002=750 rpm Hence angular speed of…

Q: A pump is moving soybean oil through a 1-in. (nominal) pipe. The 110-volt motor is using 285 watts.…

A: Given dataDiameter of pipe = 1 inch = 0.0254 mVoltage of motor = 110 VPower of motor = 285 WOverall…

Q: Q3. A steel frame supports a rotating machine which exerts a horizontal force at the girder level,…

Q: B- EVEN: Josh threw the marble vertically upward with a speed of 66 ft/s from a bridge. On the way…

A: Given U= 66ft/s t= 5s

Q: The beam shown has an overall length L of 5.9 metres. A uniform distributed load of 7.8 kN/m is…

Q: Consider an aligned fiber reinforced-polymer matrix composite for which the constituent fibers have…

A: Tensile strength is the highest load a material can withstand without cracking when stretched,…

Q: atmosphere at 14.7 lbf/in.2 and 520°R. A normal shock stands at the exit plane with Mx = 2.3. The…

Q: shaft in torsion only is to transmit 2500 hp at 570 rpm. Its material’s allowable shear stress is 10…

A: as per guidelines we need to answer only first 3 subparts

Q: An airfoil at a given altitude has a critical Mach number of 0.7. Find the sweep angle that is…

Q: The initially stationary uniform disk of mass m₁ = 2.2 kg and radius b = 265 mm is allowed to drop…

A: Find the required time .

Q: A sky lantern which a child tied to a piece of stone on the ground at the side of a tall multi-…

A: Given:v1=2.7 m/st=2.5 sec

Q: 2/63 A particle which moves in two-dimensional motion has coordinates given in inches by x = ² - 4t…

A: Find the velocity and acceleration .

Q: Failure of Materials Due to Creep and Fatigue.

A: Environmental conditions, such as corrosion, have an impact on fatigue strength. The fatigue…

Q: 1. A 60-mm diameter steel tube with a wall thickness of 3 mm just fits in a rigid hole. Determine…

Q: A sky lantern which a child tied to a piece of stone on the ground at the side of a tall multi-…

Q: The beam shown has an second moment of area of 9,500,000 mm and a controlling section modulus of…

A: Given data : Maximum moment=M Second moment of area=I Section modulus=Z Required : Maximum…

Q: The hydraulic cylinder imparts a constant upward velocity VA = 0.27 m/s to corner A of the…

Q: 400 lb/ft A C B - 4 ft- -4 ft- FIG. P4.7 | 10 KN t50 kN m A - 2 m 3m KIG PA 9

Q: The jib crane shown in the figure is subjected to three coplanar forces. Replace this loading by an…

Q: 3. For a single element beam as should be W g shown in figure below, its equivalent nodal load…

Q: 3. A 90% efficient Francis turbine running at 100 rpm discharges 6m * 3/s of water. The inner runner…

Q: For the cantilever steel beam [E = 220 GPa; I = 86 x 10 mm ], use the double-integration method to…

Q: Find the quanity of heat required to produce 79% dry steam at 8000 kpa from feedwater at 50 degrees…

A: Given:x=0.79P=800 KPaT=50°C

Q: The 27-kg wheel has a radius of gyration about its center O of ko = 260 mm, and radius r= 0.5 m.…

A: Givenm=27kgko=260mmr=0.5mF=354Nθ=6ot=3.2sg=9.81m/s2

Q: A stone is thrown vertically upward from a point on a bridge located 40 m above the water. Knowing…

Q: Consider an aligned fiber reinforced-polymer matrix composite for which the constituent fibers have…

A: Tensile strength is the highest load a material can withstand without cracking when stretched,…

Q: 28. The measurement of a thermocouple can be found directly from its standard data table if ola

A: ANSWER -a) TRUE

Q: A - ODD A sky lantern which a child tied to a piece of stone on the ground at the side of a tall…

A: Given:V1=3.7 m/st=3.5 sec

Q: A sky lantern which a child tied to a piece of stone on the ground at the side of a tall multi-…

A: Given:v1=2.7 m/st=2.5 sec

Q: The hydraulic cylinder imparts a constant upward velocity VA = 0.27 m/s to corner A of the…

Q: Calculate the forces, in Newtons, for the following 1. member FG 2. pin H 3. hydraulic cylinder AB…

A: Given: The load, P = 789 N The angle, θ = 37.4°

Q: Explain the function of the following system and its use. Is there any difference between front and…

A: Explanation: 1) This is an example of hydraulic brake system. 2) This is used in light motor three…

Q: The hydrodynamic fully developed flow in a pipe means that the O heat transfer rate doesn't change…

Q: PROBLEM. A mechanism carries a constant load P applied to the seat as given. As CDFE and EFGH is a…

A: Force in pin H and member FG

Q: Calculate the y-coordinate of the centroid of the shaded area

Q: A uniform, 31.16-N rod is 14.45 n long carries a 415.01-N at its right end and an unknown weight W…

A: Weight of the uniform rod, Wrod= 31.16 N Length of the rod, L= 14.45 cm Load, P= 415.01 N Unknown…

Q: I need to draw the three planes

A: According to the details provided in the question, we need to draw three projection views. I am…

Q: An object has a volume of 1 cubic meter. If its specific gravity is 1.2, what is its weight…

A: GivenVolume of the object V=1m3specific gravity =1.2

Q: Find the value of force which produce stress of 1.2 N/mm2 if cross sectional area is 0.5 mm2

Q: 2/73 A small airplane flying horizontally with a speed of 300 km/h at an altitude of 120 m above a…

Q: The 285-kg wheel has a radius of gyration about its center O of ko = 300 mm, and radius r = 0.4 m.…

A: Use parallel axis theorem to moment of Inertia about IC

Q: A refrigeration system using R-12 receives a load of 54 KW at an evaporator temperature of - 4 oC…

Question

Show complete solution with free body diagram.

Josh threw the marble vertically upward with a speed of 66 ft/s from a bridge. On the
way down, the marble just misses the bridge and falls into the water 5 seconds after
having been thrown upward. Find the height of the bridge in feet above the water
ODD.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Plot the earths gravitational acceleration g(m/s2) against the height h (km) above the surface of the earth.
B- EVEN: Josh threw the marble vertically upward with a speed of 66 ft/s from a bridge. On the way down, the marble just misses the bridge and falls into the water 5 seconds after having been thrown upward. Find the height of the bridge in feet above the water
3- Two cars moving towards cach other, separated by 150 km, If the first car has a speed of 60 m/s and the second has a speed of 40, find the necessary time for them to meet together.
A ball is released from the bottom of an elevator which is travelling upward with a velocity of 6 m/s. The ball strikes the bottom of the elevator shaft in elevator shaft in 3s. Determine the height of the elevator from the bottom of the shaft to the instant the ball is released and find the velocity of the ball when it strike the bottom of the shaft.
Q5. the acceleration due the gravity on the moon is 1/6" of what it is on earth. If you can throw a baseball on earth to reach a maximum height of 20m, how high could you throw a baseball on the moon? If you caught it when it came back down, how much time would elapse between your throw and catch? 3.-0 18m V-18.8m * Figure (1)
A ball is released from the bottom of an elevator which is travelling upward with a velocity of 6 ?/?. The ball strikes the bottom of the elevator shaft in elevator shaft in 3s. Determine the height of the elevator from the bottom of the shaft to the instant the ball is released, and find the velocity of the ball when it strike the bottom of the shaft.
Find how an airplane will move in landing. If in t seconds after touching the ground its speed in feet per second is given by the equation v=180-18t
If a body falls from a building and takes 12 seconds to reach the ground Find the height of the building ( Take g= 10 m
UBC Engin A trebuchet uses a falling counterweight to launch a projectile. It can be thought of as a machine that converts the gravitational potential energy of the counterweight into kinetic and gravitational potential energy of the projectile. The counterweight has a mass of 100kg and drops 3m. The projectile has a mass of 3kg, and starts on the ground. When it leaves the sling, it has a height of 4m speed of 30. m If the average power used in lifting the counterweight is 48W, find the time it takes to lift it from the ground to its full height. tlifting If the projectile goes from rest to its maximum speed in 1.5s. find the average power used in launching the projectile in this time period. Pprojectile Find the efficiency of the trebuchet when it launches. Efficiency % W
A skydiver jumps from an airplane, the resistance he encountered is proportional to its velocity and his limiting velocity is equal to 10 fps. After 20 minutes, he opens his parachute, at that moment the resistance increases thrice to it original velocity. If he landed after 35 minutes, what is the altitude of the plane the moment the skydiver jumps from it? Assume its second limiting velocity is 4fps.
A truck starting from rest is accelerated at the rate of 0.218 m/s2. Find the distance travelled by truck in 18 seconds.
Q3 A balloon goes vertically upward at a constant speed of sec/m7, and when it was at a height of 134.4 meters above the ground, an object fell from it. Find the time of arrival of this body to the ground, then find in meters the height of the balloon from the surface of the ground at the moment the object reaches the ground.