Multiple concept problem: A bike wheel having a moment of inertia of 0.09 kg-m2 has an initial angular speed of 3 rev/s and gradually comes to rest due to a frictional force. The frictional force is caused by a torque of 1.0 N-m. Assuming the angular deceleration remains constant during the entire period, determine how much time it would require for the wheel to come to a stop.

Multiple concept problem: A bike wheel having a moment of inertia of 0.09 kg-m2 has an initial angular speed of 3 rev/s and gradually comes to rest due to a frictional force. The frictional force is caused by a torque of 1.0 N-m. Assuming the angular deceleration remains constant during the entire period, determine how much time it would require for the wheel to come to a stop.

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter8: Rotational Equilibrium And Rotational Dynamics

Section: Chapter Questions

Problem 11WUE

See similar textbooks

Similar questions

A constant net torque is applied to an object. Which one of the following will not be constant? (a) angular acceleration, (b) angular velocity, (c) moment of inertia, or (d) center of gravity.
Big Ben (Fig. P10.17), the Parliament tower clock in London, has hour and minute hands with lengths of 2.70 m and 4.50 m and masses of 60.0 kg and 100 kg, respectively. Calculate the total angular momentum of these hands about the center point. (You may model the hands as long, thin rods rotating about one end. Assume the hour and minute hands are rotating at a constant rate of one revolution per 12 hours and 60 minutes, respectively.)
(a) Calculate the angular momentum of an ice skater spinning at 6.00 re/s given his moment of inertia is 0.400kg-m2 (b) He reduces his rate of spin (his angular velocity) by extending his arms and increasing his moment of inertia. Find the value of his moment of inertia if his angular velocity decreases to 1.25 rev/s. (c) Suppose instead he keeps his arms in and allows friction of the ice to slow him to 3.00 rev/s. What average torque was exerted if this takes 15.0 s?
Calculate the moment of inertia of a skater given the following information. (a) The 60.0-kg skater is approximated as a cylinder that has a 0.110-m radius. (b) The skater with arms extended is approximately a cylinder that is 52.5 kg, has a 0.110-m radius, and has two 0.900-m-long arms which are 3.75 kg each and extend straight out from the cylinder like rods rotated about their ends.
Why is the moment of inertia of a hoop that has a mass M and a radius R greater than the moment of inertia of a disk that has the same mass and radius? Why is the moment of inertia of a spherical shell that has a mass M and a radius R greater than that of a solid sphere that has the same mass and radius?
An approximate model for a ceiling fan consists of a cylindrical disk with four thin rods extending from the disks center, as in Figure P8.41. The disk has mass 2.50 kg and radius 0.200 m. Each rod has mass 0.850 kg and is 0.750 m long, (a) Find the ceiling fans moment of inertia about a vertical axis through the disks center, (b) Friction exerts a constant torque of magnitude 0.115 N m on the fan as it rotates. Find the magnitude of the constant torque provided by the fans motor if the fan starts from rest and takes 15.0 s and 18.5 full revolutions to reach its maximum speed. Figure P8.41
The angular speed of a wheel is given by (t) = 72.5 rad/s + (9.34 rad /s2) t. a. Is the wheels angular acceleration constant? Explain. b. Find an expression for the angular acceleration.
A 60.0-kg woman stands at the rim of a horizontal turntable having a moment of inertia of 500 kg m2 and a radius of 2.00 m. The turntable is initially at rest and is free to rotate about a frictionless, vertical axle through its center. The woman then starts walking around the rim clock-wise (as viewed from above the system) at a constant speed of 1.50 m/s relative to Earth. (a) In what direction and with what angular speed does the turntable rotate? (b) How much work does the woman do to set herself and the turntable into motion?
Calculate the moment of inertia by direct integration of a thin rod of mass M and length L about an axis through the rod L/3 , as shown below. Check your answer with the parallel-axis theorem.
Consider an object on a rotating disk a distance r from its center, held in place on the disk by static friction. Which of the following statements is not true concerning this object? (a) If the angular speed is constant, the object must have constant tangential speed. (b) If the angular speed is constant, the object is not accelerated. (c) The object has a tangential acceleration only if the disk has an angular acceleration. (d) If the disk has an angular acceleration, the object has both a centripetal acceleration and a tangential acceleration. (e) The object always has a centripetal acceleration except when the angular speed is zero.
Two astronauts (Fig. P10.67), each having a mass of 75.0 kg, are connected by a 10.0-m rope of negligible mass. They are isolated in space, orbiting their center of mass at speeds of 5.00 m/s. Treating the astronauts as particles, calculate (a) the magnitude of the angular momentum of the two-astronaut system and (b) the rotational energy of the system. By pulling on the rope, one astronaut shortens the distance between them to 5.00 m. (c) What is the new angular momentum of the system? (d) What are the astronauts new speeds? (e) What is the new rotational energy of the system? (f) How much chemical potential energy in the body of the astronaut was converted to mechanical energy in the system when he shortened the rope? Figure P10.67 Problems 67 and 68.
A baseball pitcher throws the ball in a motion where there is rotation of the forearm about the elbow joint as well as other movements. If the linear velocity of the ball relative to the elbow joint is 20.0 m/s at a distance of 0.480 m from the joint and the moment of inertia of the forearm is 0.500kg-m2 , what is the rotational kinetic energy of the forearm?