OAssigamalⒸ diagramDraw Single linePequipment.ein cominggoing30is ii) Out11;;₁) Bus Bars ! 220kv-double bars, 66 kV-doublee bars, 11 kvof alines : Two 220KVlines: Sive 66 kv, 1 llkvshowsubstation having.bus bar.iN) Transformers: (W) 3 winding transformers -2100 MVA,Wave Trap: Couplingincomingthe position ofacreatorsthe following220/66/111b) Auxiliary transformer - 1 SMA, || KVA/400VCondenser and earth switch atlines.CTS, Pis, disconnecting switchesCircuit breakers.

Given data Two incoming 220 kV Five outgoing 66 kV and one outgoing11 kV 220 kV-Double bus, 66…

P e Assigamal Draw Ingle line diagram equipment. 0 in coming going lines: Two 220kV lines : five 66 kV, of G Wave Trap: Coupling incom show subutation having ii) Out "in) Bus Bars : 220 kv-double bars, 66 kv-doublee bars, 11 k ing the position of irreators the 1 llkv bus bar. ir) Transformers: (@) 3 winding transformers -2100 MVA, 220/6/1 (6) Auxiliary transformer - 1 SMA, 11 KVA/400r Condenser and earth switch at lines. following Cis, Pis, disconnecting switche circuit breakers.

P e Assigamal Draw Ingle line diagram equipment. 0 in coming going lines: Two 220kV lines : five 66 kV, of G Wave Trap: Coupling incom show subutation having ii) Out "in) Bus Bars : 220 kv-double bars, 66 kv-doublee bars, 11 k ing the position of irreators the 1 llkv bus bar. ir) Transformers: (@) 3 winding transformers -2100 MVA, 220/6/1 (6) Auxiliary transformer - 1 SMA, 11 KVA/400r Condenser and earth switch at lines. following Cis, Pis, disconnecting switche circuit breakers.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.36P: Three single-phase two-winding transformers, each rated 25MVA,34.5/13.8kV, are connected to form a...

See similar textbooks

Similar questions

Which termination would result to a phase change of 180 degrees at the load if Zo = 100 ohm? a. 50 ohm b. short circuit c. 75 ohm d. all of these What is the purpose of impedance matching? a. maximum return loss b. maximum SWR c. maximum load power d. maximum reflection A short piece of transmission line that may be open or shorted and used for impedance matching purposes. a. converter b. decoder c. stub d. transformer
Two similar star-grounded synchronous generators, one of which has its star point grounded, supply 11 kV three-phase busbars. An 11/66 kV delta/star connected transformer with the star point grounded is supplied from the busbars. The impedances referred to 11 kV, are as given below : Generator Transformer Impedance to positive-sequence currents j3.0 Ω j 3.0 Ω Impedance to negative-sequence currents j 2.0 S2 j3.0Ω Impedance to zero-sequence currents j 1.012 j3.0Ω Determine the fault current for an LG fault (a) on a busbar, and (b) at an hv terminal of the transformer. (c) Find also the voltage to ground of the two sound busbars in case (a).
Refer to the 5-bus data given below. Sbase = 400 MVA, the base voltage is 15.0 kV for buses 1 and 3, and 345 kV for buses 2, 4, 5. Note that 1-5 and 3-4 are 15/345 kV transformers.a) Draw a one-line diagram of the power system.b) Find the elements Y23, Y43, Y11 Y33 of the system bus admittance matrix.
Q1. Three single-phase two winding transformers, each rated 400 MVA, 13.8kV/199.2kV, leakage reactance of 0.10 pu are connected to form a three phase transformer bank. Winding resistance and exciting current are neglected. The high voltage windings are star connected. A three-phase load operated under balanced positive sequence conditions on the high voltage side absorbs 1000 MVA at 0.9pf lagging, a phase voltage of 199.2/0°kV. Determine the phase voltage at the low voltage bus if the low-voltage windings are also star connected.
Two single phase transformers of 1000 kVA and 500 kVA with equal voltage rating 11 kV/ 400V connected in parallel shares a common load. If the impedances of the transformer referred to secondary is 0.02 + j0.07 Ω and 0.05 + j0.175 Ω respectively, find the maximum UPF load can be connected to them without overloading
For the single phase system given in the Figure, the following ratings are given. Transformer A-B: 500V/1.5kV, 9.6 kVA, leakage reactance = 5%. Transformer B-C: 1.2kV/120V, 7.2kVA, leakage reactance= 4%. Line B: series impedance = 0.5+3j Ω. Load C: 120V, 6kVA at 0.8 power factor lagging. a) Determine the actual values of the load impedance and the leakage reactance’s of the transformers referred to primary and secondary sides. b) Choosing 1.2kV as the voltage base for circuit B and 10kVA as the system wide kVA base, express all system impedances in per unit. c) What is the appropriate sending-end voltage (Vs) corresponds to the given loading conditions?
cotabato light and power company supplies two single phase transformers at san pablo area banked in open delta if each transformet is rated 75KVA capacity what is the maximum 3 phase load in kilowatts that the bank can carry without suffring oerload considdering that the load has laggingpower factor of 0.80
2. A 100 MVA, 18 kV generator, with per unit reactance of X”d= 0.19, X’d = 0.26, and Xd = 1.3 is connected through acircuit breaker to a transformer rated 100 MVA, 240Y/18 kV,X = 0.10 per unit. It is operating at no load and ratedvoltage when a three-phase short circuit occurs at the highvoltage side of the transformer. Find the initialsymmetrical rms current in the line on the low voltageside.
A 6,600V, 1,200 kVA, 3-phase alternator is delivering full load at 0.80 power factor lagging. Its reactance is 25% and resistance is negligible. By changing its excitation, the emf is increased by 30%. At this load, determine the new current and power factor. Draw the single line diagram.
What would be the total single phase 120kVA capacity that could be used with the transformers size of 1.5 kVA?
In a three phase overhead system , each line is suspended by a string of three insulators. The voltages across top unit and the middle unit are 8KV and 11KV respectively. Calculate a) ratio of shunt capacitance to self capacitance b) line voltage c) string efficiency.
An AC three phase distribution system (given in Figure 2), which has end user with balanced three phase (10A) load, is given in the figure. The phase-neutral voltages of the transformers are given as V1=224V, V2=225V, V3=228V and V4=231V respectively. a) Calculate phase-neutral voltage of the bus-bar (B). b) Calculate currents of the transformers (I1, I2, I3 and I4) c) Calculate phase-neutral voltage of the point K while the output of TR3 and TR4 (xy) have been short circuited for a transient time (transformers are still operational) by the line fault.