Technician A says that rattling on road irregularitiescan be caused by worn shock absorber bushings orgrommets, worn spring insulators, a broken coilspring or broken spring insulators, worn control armbushings, worn stabilizer bar bushings, worn strutrod grommets, worn leaf spring shackles and bushings,and worn torsion bars, anchors, and bushings.Technician B says that dry or worn control arm bushingsmay cause a squeaking noise on irregular roadsurfaces. Who is correct?a. Technician A onlyb. Technician B onlyc. Both A and Bd. Neither A nor B

Technician A says that rattling on road irregularitiescan be caused by worn shock absorber bushings orgrommets, worn spring insulators, a broken coilspring or broken spring insulators, worn control armbushings, worn stabilizer bar bushings, worn strutrod grommets, worn leaf spring shackles and bushings,and worn torsion bars, anchors, and bushings.Technician B says that dry or worn control arm bushingsmay cause a squeaking noise on irregular roadsurfaces. Who is correct?a. Technician A onlyb. Technician B onlyc. Both A and Bd. Neither A nor B

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter46: Suspension Systems

Section: Chapter Questions

Problem 10ASRQ: Technician A says that rattling on road irregularities can be caused by worn shock absorber bushings...

See similar textbooks

Similar questions

While conducting a bounce test: Technician A says that the bumper should be pushed two or three times downward with considerable weight applied on each corner of the vehicle. The bumper should be released after each push and the vehicle should oscillate about 1½ cycles and then settle. Technician B says that one free upward bounce should stop the vertical chassis movement if the shock absorber or strut provides proper spring control. If the vehicle’s bumper does more than 1½ free upward bounces, the shock absorber or strut is defective. Who is correct?
When attempting to diagnose a vibration that is present only when the car is cruising at highway speeds, Technician A says that the problem may be caused by out-of-balance tires. Technician B says that the problem may be caused by a worn wheel bearing.
Technician A days that a weak suspension spring can cause a loss of traction during acceleration. Technician B says that a weak suspension spring can cause poor braking power. Who is correct?
Tech A says that caster can be adjusted on nearly all front suspensions. Tech B says that toe can only be adjusted on front suspension. Who is correct
Technician A says that rattling on road irregularities can be caused by worn shock absorber bushings or grommets. Technician B says that dry or worn control arm bushings may cause a squeaking noise on irregular road surfaces. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B
Technician A says that leaf spring type suspensions are subject to wheel tramp. Technician B says that anti sway bars are designed to limit wheel tramp. Who is correct?
Give at least 5 STATEMENT OF THE PROBLEM regarding to this topic. (A statement of the problem is used in research work as a claim that outlines the problem addressed by a study. The statement of the problem briefly addresses the question: What is the problem that the research will address?) "Comparing ABS system to hydraulic break of a vehicle"
A discussion concerning CV joint testing is being held. Technician A says that a recommended method to check CV joints is to raise the vehícle so that the lower control arms are hanging freely; at this point the engine can be accelerated while noise checks can be performed. Technician B says that the vehicle should be road tested so that the CV joints can be checked under load. Who is correct? O a. A only O b. B only c. Both A and B d. Neither A nor B
Describe uncontrolled spring action without a shock absorber.
List four possible causes of cluth slippage
Technician A says that clutch slippage is most notice-able in higher gears. Technician B says that clutch slip page is not noticeable in lower gears. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B
What is benefit of bifilar suspension technique?