The three Classical Orders of Greek architecture consist of the Doric, Ionic, and Corinthian orders. Describe them and how are they different?

Q: A rod is being designed for a speed of 110 km /hr on a horizontal curve with a super elevation of…

A: Super elevation e=8%=0.08,Speed V=110 km/hr,Side friction f=0.10,To Find-The value of the minimum…

Q: Subject: Contruction Quality Management If you are the general contractor, how you will identify…

A: For every quality engineer or manager, non-conformity is a constant source of worry. There have been…

Q: The box wrench is subjected to the 50 lb force. (Figure 1) Figure 2 in. 12 in. 0.5 in. Section a-a 1…

A: To a box wrench, a load of 50lb is applied. To determine sections a-a The maximum principal stress…

Q: 1. FIND HOW MANY KG WATER, CEMENT, SAND, AND AGGREGATES ARE NEEDED TO HAVE 12 CUBIC METERS OF…

A: Concrete mix 1 : 2 : 4    NOTE  : As per guidelines, first question is solved. Request you to post…

Q: Q2. Determine the magnitude and direction of friction torce acting on the 20kN block shown if P=10kN…

A:

Q: A RC column of size 460 mm x 600 mm having effective length of 3.6 m is to be designed using LSM to…

A:

Q: The penetration value of a bitumen sample tested at 25°C is 80. When this sample is heated to 60°C…

A: A bitumen sample tested at 25oC- Penetration value = 80. So, Bitumen grade = 80. To Find- The value…

Q: In this Question the cable attached to a tower as you can see a) Since f1 = 8m and f2 = 8m, find the…

A:

Q: For a particular loading condition, a saturated clay layer undergoes 30% consolidation in a period…

A: Given- 30% consolidation in 180 days, Additional time required for further 20% consolidation.

Q: A superspeedway in New Delhi has among the highest super-elevation rates of any track on the Indians…

A:

Q: If a nozzle is so shaped that the velocity of flow among center line changes from 1.5 m/sec to 15…

A:

Q: It is known that q = 2kN/m, 1 = 6m in the shown structure. Determine the force in the tension link…

A:

Q: A superspeedway in New Delhi has among the highest super-elevation rates of any track on the Indians…

A: A superspeedway in New Delhi- Radius R = 335 m and 33° banking. To Find- The coefficient of side…

Q: 7) Suppose a crew of two people requires 3 minutes per stop, at which they can service four…

A: Number of people in crew = 2 Required time for stop = 3 min/stop At required time they can service 4…

Q: Find the amount of land required in a sanitary landfill to dispose of urban waste of city of 120 000…

A:

Q: A granular soil has a saturated unit weight of 20 kN/m³ and an effective angle of shearing…

A: Given data, To determine the safe slope angle  A granular soil has a saturated unit weight,γsat =20…

Q: Draw the shear, bending moment, and axial force diagrams and the qualitative deflected shape for the…

A:

Q: 0.0054 Is to carry 5 m3 /s. The channel material has an n value of 0.051. For a most efficient…

A:

Q: What will be the load carrying capacity (kN) of a group of 6 piles, if the individual load carrying…

A:

Q: The shaft is made of L2 tool steel, has a diameter of 40 mm, and is fixed at its ends A and B. It is…

A:

Q: The co-efficient of friction in the longitudinal direction of a highway is estimated as 0.396. The…

A: Coefficient of friction (f) = 0.396  Speed (V) = 65 Km/hr  Determine the breaking distance (L) for a…

Q: An alert driver used brakes to avoid an accident when suddenly a person steps from behind parked car…

A:

Q: Problem# 1. A cantilever beam made of IPE200 is subjected to a concentrated live load of 10 KN…

A: Given, To find,a) Design flexural stregth & Check if the beam has enough capacity to support…

Q: 10) A 10.75 cm diameter steel pile is driven 25 m into stiff, insensitive clay. The pile has an…

A: Given; Diameter of pile (d) = 10.75 cm = 0.1075 m Length of the pile (l) = 25 m Friction capacity…

Q: Q- In a leveling work, sum of the Back Sight (B.S.) and Fore Sight (F.S.) have been found to be…

A: A leveling work- Sum of back sights- ∑BS=3.085 m, Sum of fore sights- ∑FS=5.645 m. The reduced level…

Q: Design rate of super elevation for horizontal highway curve of radius 450 m for a mixed traffic…

A: Radius of the curve R=450 m, Speed V=125 km/hour, To Find- The value of the design rate of super…

Q: ans

A: Determine the reaction at A and B of the beam using Castigliano's theorem.

Q: wo straight tangents of a two-line highway intersect at point B. The tangents have azmuths of 270…

A: azmuths- 2700 and 1100  Radius - 7300 ft To find - a)the tangent lengths b)the length of curve c) PI…

Q: The principal stresses at a point across two planes are 76MN/m² (tensile) perpendicular and 34MN/m²…

A:

Q: An equal-tangent vertical curve is to be constructed between grades of -2.0% (initial) and +1.0%…

A: we have to design the curve

Q: Observations from unknown point Flagpole: 18°05'37'' King's Battery: 38°03'36'' Plumpud:…

A: Flagpole: Angle = 18°05'37'' Coordinates: X = +49835.50, Y = +59098.10 King's Battery: Angle =…

Q: a school building?

A: Rooms shall have, for the admission of light and air, one or moreapertures, such as windows and…

Q: A surveyor paces a 60 m length four times with the following results: 74, 75, 76, 75.5 paces. How…

A: We need to first determine the average pace length, based on the given data  average pace length =…

Q: 60 A square shallow foundation is to be constructed over a layer of sand. Given Df = 1 m; No is…

A: Given; Df = 1m ; qnet = 350 Kn/m2  sand is normally consolidated

Q: The chandelier is suspended from the wall and ceiling using rods AB and BC, which have diameters of…

A: To find the maximum value of m

Q: Derive and show the relationship or transformation of Ws = Ys Vs →→ to Ws=ite v Gm your

A:

Q: Explain and provide references of why stress strain curves and testing results are of importance to…

A: Stress-strain curves and testing results are essential for engineers in various fields, including…

Q: *8-20. Determine the slope and the displacement at the end C of the beam. E = 200 GPa, I = 70(106)…

A:

Q: 4 10 20 50 80 120 200 Pan 6.0 g 35.847 69.685 32.144 12.798 22.885 15.974 9.563 9.112

A: According to Indian Standard Soil Classification System (ISSCS), soil with particle size > 300 mm…

Q: A drinking water treatment plant with conventional treatment uses on disinfection segment consisting…

A: Baffling factor = 0.5 Theoretical detention time (TDT) = 270 min Average free chlorine residual= 1.6…

Q: An isosceles right-angled triangular section of height 10m and width 10m. It is subjected to a shear…

A: An isosceles right-angles triangular section Height of the section h=10 m, Width of the section b=10…

Q: The design speed for a two-lane road is 80 kmph. When a design vehicle with a wheel base of 6.6 m is…

A: Two lane road- Speed V=80 kmph, Wheel base length L=6.6 m, Off-tracking length O=0.096 m,   It is…

Q: neqaned mormation A 90° elbow in a horizontal pipe is used to direct water flow upward at a rate of…

A: Diameter of elbow=10cm = 0.1m Momentum flux correction factor=1.03

Q: A vertical cylindrical steel storage tank has 30 m diameter and the same is filled up to a depth of…

A:

Q: Using the given 6-h unit hydrograph derive the flood hydrograph due to the storm given below. UH:

A: The direct runoff hydrograph is next calculated by the method of superposition as indicated in Table…

Q: Question (1): For the beam shown in figure (1): 1- Calculate all support reactions. 2- Calculate the…

A: Determine  a. Support reaction of the beam.  b. Internal force and moment at C and D.

Q: 1) Derive the ff: (show the relationship or transformation) a) Ym= w ▷ ▸ to dry unit weight, yd: Yd=…

A: To deriveyd=ym1+mc

Q: A soil sample was compacted.The result of the standard proctor test shows that at 100% compaction,…

A:

Q: a. Explain the effects of frame stiffness on the shear force and bending moment of shear wall using…

A: As there are two different questions posted and not mentioned which one to solve so As per Bartleby…

Q: • Example: 25/1 Consider a concrete pile that is 0.305 m x 0.305 m in cross section placed in sand.…

A: