Two vertical circular cylindrical tanks are connected near the bottom by a short tube having a cross-sectional area of 725 cm2. The inside diameters of the tanks are 3m and 1.5 m, respectively. The tanks contain oil. With the valve in the tube closed, the oil surfaces are 4m in the larger tank and 0.6 m in the smaller above the tube. With c=0.78, find the time required for the surfaces to equalize following a quick

Two vertical circular cylindrical tanks are connected near the bottom by a short tube having a cross-sectional area of 725 cm2. The inside diameters of the tanks are 3m and 1.5 m, respectively. The tanks contain oil. With the valve in the tube closed, the oil surfaces are 4m in the larger tank and 0.6 m in the smaller above the tube. With c=0.78, find the time required for the surfaces to equalize following a quick

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

1. A block, 1ft square and 9 inches deep floats on a stratified liquid composed of a 6in layer of water above a layer of mercury. Determine the weight of the block if the position of its bottom is 1 inch below the mercury. 2. At point A in a pipeline carrying water, the diameter is 1m, the pressure is 98kPa and the velocity is 1m/s. At point B, 2m lower than A, the diameter is 0.5m and the pressure is 20kPa. Determine the direction of flow. Show detailed computation. 3. What is the hydraulic radius of the channel shown: 1.5m 1.5h 4. wty A vertical right-angled triangular surface has a vertex in the free surface of a liquid. Find the force on one side. 1.5m 1:2m
INCLINED MONOMETER EXAMPLE tube shown in Fig. than that at B. T 1m Determine the angle of the inclined if the pressure at A is 5KPa greater SG-0.7 SG-1.0 10 m
A conduit is carrying oil ( S = 0.75 ) and its absolute viscosity is 0.25 kg / m-s. If the flow rate is 0.45 cu.m/s Determine the following • The entrance length • The length of the inviscid cone • The length of the profile development given the following situations 1. Circular pipe 800mm 2. rectangular pipe (Width = 800mm, Depth 1200mm)
... Elevation 15.25m Elevation 14 m water Elevation 10.7m 30° An orifice in a 30 degree plane from horizontal as shown has its vena contracta at elevation 10.7m. If the water surface in the tank is at elevation 15.25m and the peak of the jet is at elevation 14m. Find the coefficient of velocity. 0.983 B) No answer among the choices 0.952 D 0.964 0.975
A cylindrical tank with its axis horizontal has a length of 6 m and the ends of the tank are vertical planes, as shown in Figure Q2 (a). The vertical pipe of 0.2 m in diameter is connected to the top of the tank. The tank and the pipe are filled with ethyl alcohol to a level of 1.5 m above the top of the tank. The diamter is 2.07m.
H.W.9/7 For the closed tank with Bourdon-tube gauges tapped into it, what is the specific gravity oi thE On ana une pressure reading on gage C? Soil = 0.87 0.5 m Air PA= 50.0 kPa 1.0 m Oil S = 0.8) PB = 58.5 kPa 0.5 m 1.0 m Water 0.5 m Pc=? T= 10°C
13. A U-tube differential manometer connects two pressure pipes A and B. Pipe A contains carb tetrachloride having a specific gravity 1.594 under a pressure of 11.772 N/cm2 and pipe B contains oil of sp. gr. 0.8 under a pressure of 11.772 N/em. The pipe A lies 2.5 m above pipe B. Find the difference of pressure measured by mercury as fluid filling U-tube. 14. A differential manometer is connected at the two points A and B as shown in Fig. 2.25. At B air pressu is 7.848 N/cm² (abs.), find the absolute pressure at A. [Ans. 31.36 cm of mercury] [Ans, 6.91 N/em) AIR B WATER OIL Sp. gr.0.8 OIL Sp. gr. 0.8 50'cm 30 cm om 100 cm 50 cm 10 cm MERCURY Sp. gr. 13.6 WATER Fig. 2.25 Fig. 2.26
11. A single column vertical manometer (L.e., micrometer) is connected to a pipe containing oil of sp. gr. 0.9. The area of the reservoir is 80 times the area of the manometer tube. The reservoir contains mercury of sp. gr. 13.6. The level of mercury in the reservoir is at a height of 30 cm below the centre of the pipe and difference of mercury levels in the reservoir and right limb is 50 em. Find the pressure in the pipe. (Ans. 6.474 Nem) 12. A pipe contains an oil of sp. gr. 0.8. A differential manometer connected at the two points A and B of the pipe shows a difference in mercury level as 20 cm. Find the difference of pressure at the two points (Ans. 25113.6 Nm) 13. A U-tube differential manometer connects two pressure pipes A and B. Pipe A contains carbon tetrachloride having a specific gravity 1.594 under a pressure of 11.772 N/em and pipe B contains oil of sp. gr. 0.8 under a pressure of 11.772 N/em. The pipe A lies 2,5 m above pipe B. Find the difference of pressure measured by…
COMPUTE THE CAPILLARY RISE IN mm. OF PURE WATER AT 10^0 C EXPECTED IN A 0.8 mm θ TUBE
13. A U-tube differential manometer connects two pressure pipes A and B. Pipe A contains carbo tetrachloride having a specific gravity 1.594 under a pressure of 11.772 N/em and pipe B contains ofl of sp. gr. 0.8 under a pressure of 11.772 N/em. The pipe A lies 2.5 m above pipe B. Find the difference of pressure measured by mercury as fluid filling U-tube. 14. A differential manometer is connected at the two points A and B as shown in Fig. 2.25. At B air pressu is 7.848 N/cm (abs.), find the absolute pressure at A. [Ans. 31.36 cm of mercuryl (Ans, 6.91 Nicm) AIR WATER OIL Sp. gr.0.8 OIL Sp. gr. 0.8 50'cm 30 cm 100 am 60 cm 10 cm MERCURY Sp. gr.13.6 WATER Fig. 2.25 Fig. 2.26
a cylindrical vessel has 0.5m diameter and 1m height rotates at 10rad/s. initial height of Mercury inside the cylinder is 0.25m. Determine the final height of the water. a. 0.48b. 0.41c. 0.32d. 0.57
A pipe carrying oil of sp gr 0 877 changes in A pipe carrying oil of sp gr 0.877 changes in size from 150mm at section E to 450mm at section R Section E is 3 66m lower than R section R. Section E is 3.66m lower than R and the pressures are 91.0kPa and 60.3kPa, respectively. If the discharge is 0.146m3 respectively. If the discharge is 0.146m /s, determine the lost head and the direction of flow.