Physics for Scientists and Engineers: Foundations and Connections
1st Edition
ISBN: 9781133939146
Author: Katz, Debora M.
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Question
Chapter 28, Problem 76PQ
To determine
The expression for the current density as a function of
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
A conducting rod with a circular cross-section (this rod is a cylinder) has a radius of 10
mm and is 2 metres long. The rod is made of aluminum, so its conductivity is 3.6 x 10' S/m. A
potential difference (voltage) is applied at both ends of this rod and the current is I = 90 A.
That's a lot of current!
a. What is the resistance of the rod, when measured from one end to the other?
b. Calculate the current density in the rod along its length.
Determine the electric field amplitude at all locations within the rod.
c.
d. What is the electric potential difference between the two ends of the rod.
A conducting rod with a circular cross-section (this rod is a cylinder) has a radius of 1o
mm and is 2 metres long. The rod is made of aluminum, so its conductivity is 3.6 x 10' s/m. A
potential difference (voltage) is applied at both ends of this rod and the current is I= 90 A.
That's a lot of current!
a. What is the resistance of the rod, when measured from one end to the other?
b. Calculate the current density in the rod along its length.
. Determine the electric field amplitude at all locations within the rod.
d. What is the electric potential difference between the two ends of the rod.
A wire has a current density of 7.09 x 10° A/m?. If the cross-sectional area of the wire is 2.11 mm², what current I does
the wire carry?
A.
With this current, how much time t is required for 4.05 x 100 electrons to pass any point on the wire?
Chapter 28 Solutions
Physics for Scientists and Engineers: Foundations and Connections
Ch. 28.1 - Prob. 28.1CECh. 28.2 - Prob. 28.2CECh. 28.3 - Prob. 28.3CECh. 28.5 - When a lightbulb burns out, its filament breaks so...Ch. 28.6 - A battery with terminal potential is connected to...Ch. 28.7 - A battery of terminal potential is connected to a...Ch. 28 - Prob. 1PQCh. 28 - Prob. 2PQCh. 28 - Prob. 3PQCh. 28 - Prob. 4PQ
Ch. 28 - Prob. 5PQCh. 28 - Prob. 6PQCh. 28 - Prob. 7PQCh. 28 - Prob. 8PQCh. 28 - Prob. 9PQCh. 28 - Prob. 10PQCh. 28 - Prob. 11PQCh. 28 - Prob. 12PQCh. 28 - Prob. 13PQCh. 28 - Prob. 14PQCh. 28 - The current in a wire varies with time (measured...Ch. 28 - Prob. 16PQCh. 28 - The amount of charge that flows through a copper...Ch. 28 - Prob. 18PQCh. 28 - Prob. 19PQCh. 28 - Prob. 20PQCh. 28 - Prob. 21PQCh. 28 - Prob. 22PQCh. 28 - A copper wire that is 2.00 mm in radius with...Ch. 28 - Prob. 24PQCh. 28 - Prob. 25PQCh. 28 - Prob. 26PQCh. 28 - What is the electric field in an aluminum wire if...Ch. 28 - Prob. 28PQCh. 28 - Prob. 29PQCh. 28 - Prob. 30PQCh. 28 - Prob. 31PQCh. 28 - Prob. 32PQCh. 28 - Two concentric, metal spherical shells of radii a...Ch. 28 - Prob. 34PQCh. 28 - Prob. 35PQCh. 28 - Prob. 36PQCh. 28 - Prob. 37PQCh. 28 - A lightbulb is connected to a variable power...Ch. 28 - Prob. 39PQCh. 28 - Prob. 40PQCh. 28 - Prob. 41PQCh. 28 - Prob. 42PQCh. 28 - Prob. 43PQCh. 28 - A Two wires with different resistivities, 1 and 2,...Ch. 28 - A copper and a gold wire are supposed to have the...Ch. 28 - Gold bricks are formed with the dimensions 7358134...Ch. 28 - Prob. 47PQCh. 28 - Prob. 48PQCh. 28 - Prob. 49PQCh. 28 - Prob. 50PQCh. 28 - Prob. 51PQCh. 28 - Prob. 52PQCh. 28 - Prob. 53PQCh. 28 - Prob. 54PQCh. 28 - A two-slice bread toaster consumes 850.0 W of...Ch. 28 - Prob. 56PQCh. 28 - Prob. 57PQCh. 28 - Prob. 58PQCh. 28 - Prob. 59PQCh. 28 - Prob. 60PQCh. 28 - Prob. 61PQCh. 28 - Prob. 62PQCh. 28 - Prob. 63PQCh. 28 - Prob. 64PQCh. 28 - Prob. 65PQCh. 28 - Prob. 66PQCh. 28 - Prob. 67PQCh. 28 - Prob. 68PQCh. 28 - Prob. 69PQCh. 28 - Prob. 70PQCh. 28 - Prob. 71PQCh. 28 - Prob. 72PQCh. 28 - Prob. 73PQCh. 28 - Prob. 74PQCh. 28 - Review When a metal rod is heated, its resistance...Ch. 28 - Prob. 76PQCh. 28 - Prob. 77PQCh. 28 - Prob. 78PQCh. 28 - Prob. 79PQCh. 28 - Prob. 80PQCh. 28 - Prob. 81PQCh. 28 - A conducting material with resistivity is shaped...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- Figure P21.6 represents a section of a conductor of nonuniform diameter carrying a current of I = 5.00 A. The radius of cross-section A1 is r1 = 0.400 cm. (a) What is the magnitude of the current density across A1? The radius r2 at A2 is larger than the radius r1 at A1. (b) Is the current at A2 larger, smaller, or the same? (c) Is the current density at A2 larger, smaller, or the same? Assume A2 = 4A1. Specify the (d) radius, (e) current, and (f) current density at A2. Figure P21.6arrow_forwardIn Figure P28.67, suppose the switch has been closed for a length of time sufficiently long for the capacitor to become fully charged. (E = 8.50 V, r1 = 10 kN, and r2 = 16 kN.) 10.0 µF 3.00 k2 Figure P28.67 (a) Find the steady-state current in each resistor. I = 327 HA I2 = 327 HA 13-kn = 0 HA (b) Find the charge Q on the capacitor. 52 (c) The switch is opened at t = 0. Write an equation for the current IR, in R2 as a function of time. O (327 HA)e-t/(0.190 s) O (275 µA)et/(0.190 s) O (275 µA)e-t/(0.190 s) O (327 µA)et/(0.190 s) (d) Find the time that it takes for the charge on the capacitor to fall to one-fifth its initial value. msarrow_forwardIn Figure P28.67, suppose the switch has been closed for a length of time sufficiently long for the capacitor to become fully charged. (E = 8.50 V, r1 = 10 kN, and r2 = 16 kN.) 10.0 µF 3.00 k2 Figure P28.67 (a) Find the steady-state current in each resistor. I1 = 1.32 Your response differs significantly from the correct answer. Rework your solution from the beginning and check each step carefully. µA I2 = 4.32 Your response differs significantly from the correct answer. Rework your solution from the beginning and check each step carefully. µA I3-ko = 0 HA (b) Find the charge Q on the capacitor. 8.83 Your response differs from the correct answer by more than 10%. Double check your calculations. µC (c) The switch is opened at t = 0. Write an equation for the current IR, in R, as a function of time. O (327 µA)e-t/(0.190 s) O (275 µA)et/(0.190 s) O (275 µA)e-t/(0.190 s) O (327 µA)et/(0.190 s) (d) Find the time that it takes for the charge on the capacitor to fall to one-fifth its initial…arrow_forward
- The two segments of the wire shown have equal diameters and equal lengths but different resistivities ρ1 and ρ2 . Current I passes through this wire. If the resistivities have the ratio ρ2/ρ1 = 2, what is the ratio ΔV1/ΔV2 of the potential differences across the two segments of the wire?arrow_forwardA copper wire has a diameter of 2.0 mm and a length of 3.0 m. It carries acurrent of 6.3 A. The density of free electrons in copper is 8.5×1028electrons per cubic meter and resistivity of copper is 1.7×10-8Ω.m.a) What is the current density in the wire?b) What is the resistance of the wire?c) What is the electric field in the wire?d) What is the drift velocity of free electrons? Or calculatethe drift velocity of free electrons (or find the drift velocity of freeelectrons)e) Find the power dissipated as heat in the wirearrow_forwardA long wire with a radius of 0.400 cm carries a current. The porential difference across a 3.60 m long section of this wire is 12.0 V, and the wire carries a current of 0.370 A. a. What is the resistance of the 3.60 m long section of wire? b. What is the resistivity of the wire?arrow_forward
- Taking R = 1.00 kΩ and ε = 250 V in Figure P27.19, determine the direction andmagnitude of the current in the horizontal wire between a and e.Figure P27.19arrow_forwardFigure P28.15 2) Using Kirchhoffs rules, (a) find the current in each resistor in Figure (28.24). (b) Find the potential difference between points c and f. Which point is at the higher potential? 4.00 k2 E2 R3 E3 60.0 V 80.0 V 70.0 V I2 13 I1 R2 3.00 k2 2.00 k2 a R1 Figure 28.24:arrow_forwardla. This resistor has a resistance of 48002, and 32mA of current flows to the left into it. The right end of the resistor is at a potential of VR= 12.5V. What is the potential difference AV across the resistor? 1b. What is the potential VL of the left end of the resistor? 1c. What is the power output by the resistor? VLP 1d. What is the current that flows out of the resistor? resistor R=4800 I I= 32mA VR=12.5Varrow_forward
- A beam of protons is moving toward a target in a particle accelerator. This beam constitutes a current whose value is 0.32 mA., which is moving through a potential difference of 13.1 kV. The target is an 22-gram block of copper, which is bombarded by these protons for 8 seconds. What is the change in temperature of the block of copper? Copper has a specific heat capacity of 385 J/(kg·°C).Type your answer here °Carrow_forwardIn the figure,E₁ = 6.00 V, E₂= 12.0 V, R₁ = 100 S2, R₂ = 200 S, and R3 = 300 2. What are the (a) size and direction (up or down) of the current through R₁, the (b) size and direction (left or right) of the current through R2, and the (c) size and direction (left or right) of the current through R3? www Ro E₁ M R₁ www R3 E2arrow_forwardA material of resistivity ρ is formed into the shape of a truncated cone of height it as shown in Figure P27.85. The bottom end has radius b, and the lop end has radius a Assume the current is distributed uniformly over any circular cross section of the cone so that the current density does not depend on radial position. (The current density docs vary with position along the axis of the cone.) Show that the resistance between the two ends isarrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Circuits, Voltage, Resistance, Current - Physics 101 / AP Physics Review with Dianna Cowern; Author: Physics Girl;https://www.youtube.com/watch?v=q8X2gcPVwO0;License: Standard YouTube License, CC-BY