After years of water shortages plaguing the southeast of Queensland the state government decided to build a desalination plant, at Tugun, on the Gold Coast in 2009. After only 2 months after the taps were finally turned on, the State Government’s $1.2 billion desalination plant was shut down for five weeks of repair. (task sheet) The main problem the desalination plant faced was corrosion. The two giant stainless tanks used to store desalinated water had to be replaced because of corrosion and more than 100m of rusting pipe had to be replaced.
DESALINATION
Desalination is the process of removing dissolved salts and minerals from seawater or brackish water. (WaterReuse, Association, “What is Desalination?”) A desalination plant essentially
…show more content…
(Capital Painting. "Factors That Affect the Rate of Corrosion.") Oxygen can affect corrosion as it increases the rate of it. When an electrolyte is in contact with an area of metal containing high amounts of oxygen it is cathodic relative to the remaining surface. Which results in an oxygen concentration cell to form and causes rapid corrosion. The rate of corrosion is generally much slower in an oxygen-deficient environment, because without oxygen the reduction reaction could not occur, which would mean corrosion not being able to take place. (Capital Painting. "Factors That Affect the Rate of Corrosion.") Temperature too can affect corrosion, as corrosion reactions are electrochemical in nature and are normally accelerated with increasing temperatures. (Capital Painting. "Factors That Affect the Rate of Corrosion.") Therefore corrosion reacts faster in warmer temperatures. Another factor that can affect corrosion in chemical salts. Chemical salts increase the rate of corrosion by them increasing the efficiency (conductivity) of the electrolyte. (Capital Painting. "Factors That Affect the Rate of Corrosion.") Seawater contains the most common chemical salt of sodium chloride therefore increasing the amount of corrosion. Humidity is another factor that affects corrosion, as the wetter the environment, the more likely corrosion is likely to
However, due to the long lasting drought in California we should heavily consider this method of producing clean water. In other parts of the world such as China, India, Australia, Spain and more they have been able to produce nearly fourteen billion gallons of drinking water through this process. The largest desalination plant in the world is located in Saudi Arabia and produces two hundred and seventy three million gallons of drinking water per day. If the United States is able to perfect this, it could fix the situation. Amanda Little does an excellent job of sharing a wide array of perspectives of desalination in her article “Can Desalination Counter The Drought”. For instance she describes the discusses the standpoint of the executive director of the California Coast keeper Alliance, Sara Aminzadeh, as she argues, “It’s just not a good option from a cost and energy standpoint.” She goes on to say, “Desalination may seem like a panacea, but it’s the worst deal out there.” Although this method may not be cost or energy efficient, this may be the only plausible method of producing clean water. As seen in Saudi Arabia this is an efficient form of creating clean water and due to the lack of resources, this may be California’s last
With the Pacific Ocean lining the California coast line some may ask why can’t sea water be filtered and used as a source of free water. This is actually an alternative that has been researched and even put into use in places such as the Netherlands, Aruba, the Middle East and even right here in the U.S. This process is called desalinating seawater. Saltwater in its pure form cannot be used for drinking water and is deadly to plants, however if it goes through the process of desalinating it can be used. With California desperate for water Carlsbad, California decided to construct a desalinating plant. An article on NBCNEWS website states that the plant can produce “50 million gallons of freshwater a day from the sea and pour it into a water system that serves 3.1 million people”
Desalination is basically the procedure of separating excess sodium chloride, minerals and impurities from sea and ocean water to make it usable for irrigation and human consumption. It has been touted to rid the world of its current water problems for nearly 5 decades now, during this period huge strides have been made in the desalination technology. These advances have made it possible to venture into desalination as the long term option to the water problem in many parts of the world. It is seen as long term since the ocean is not going anywhere anytime soon as compared to lakes and rivers that have been going dry seasonally. The state of California is not new to the water shortage problem; as stated above tit has been a witness to previous droughts. It is therefore time to consider a long term solution to this problem.
With the water crisis being seen around the world, even right here in the United States, we need to explore other options to supply fresh water to the residents. One State, in particular, that raises concern is the state of California. An alternative method to supply water to residents could be the process of desalination. Desalination is when fresh water is made by using either seawater or brackish and eliminating the minerals and salts as a way to make the water safe for human and agriculture uses ( Kesieme et al., 2013). In recent years, we have seen an increase the in the number of desalination plants around the United States (fig 1). However, is the process of desalination the answer for the water crisis going on in California? As a
If residents and corporations throughout the United States continue to frivolously waste water and refuse to make painless changes and upgrades around their homes, it will continue to increase in cost to people across the United States. For example, as a result of the water shortage crisis currently afflicting the southwestern United States, the city of San Diego, California, is currently constructing a desalination plant, located in Carlsbad, California. The idea of a desalination plant is to collect undrinkable saltwater from the ocean and, using reverse osmosis and other filtering techniques, remove the salt to produce clean, potable water (Barnett). However, there are many downsides to relying on desalination practices to provide for a city the size of San Diego. First and foremost, it is considerably more expensive to produce clean drinking water from saltwater as opposed to using regular surface water or groundwater. The act of filtering the water alone can be twice as expensive as traditional filtration methods. In addition, desalination plants consume much more energy than traditional treatment plants, mostly due to the fact that the filtration methods are much more involved. Desalination consumes twice as much power as recycled plants, and four times as much as pumping groundwater (Newell, Roohk and Reardon). For example, the Carlsbad plant alone will require the same amount of electricity as is used to power 125,000 homes in California. However, the biggest
Today, desalination is a common process that's used in seaside cities and towns worldwide. There are more than 15,000 desalination plants around the world providing freshwater from salt and brackish water alike (Planet Green 2011). This number continues to grow as researchers work to improve the process, both in terms of cost effectiveness and energy efficiency (DSE 2011). But countries such as Australia, Israel and even the United States are continually adding desalination plants of various sorts into their water-management portfolios. The facilities are common in North Africa and the Mideast, where freshwater is scarce (Chandler 2008).
A desalination plant is a possible alternative to California’s need of consumable water. There is a course cons against desalination mainly affecting the marine environment for leaving highly concentrated saline water behind through the process but we should not fear it as it is a long term solution we cannot toss aside. Kerry Cavanaugh from Los Angeles Times mentions, “2,000 an acre foot, compared to about $1,000 an acre foot for imported water” (par. 3). This means that production of water through this process is cost efficient and seems rather illogical to spend more money into producing water; instead of importing it from another major source. The process cost is not a major step forward, but the idea of reaching out to import water is rather absurd. California is an arid state; we are the ones responsible for turning it into a paradise. In order to maintain it that way a method to lower the cost of desalination can be propose as solution. The thought
-Article 1- Ghaffour, N., M. Missimer, T., & L. Amy, G. (2013). Desalination (Technical review and evaluation of the economics of water desalination: Current and future challenges for better water supply sustainability) (Vol. 309, pp. 197-207). Thuwal.
Desalination is one of the more popular options being considered to attempt to terminate the drought. Desalination is a process through which salt water is pumped from the ocean in to a treatment facility, and then the salt is extracted to make it possible to be used domestically. This is a long drawn out process, which involves seven different steps. The steps of desalination include the
Ocean water desalination is the process of making ocean water drinkable. Seventy-one percent of the world is covered in ocean water, and a significant number of people in the world live within thirty miles of an ocean. Despite the abundance of resources, a large portion of the energy and materials found in the ocean remains largely untouched. Desalination of ocean water is the only solution for countries with a limited availability of existing sources of drinking. Areas such as parts of the Middle East and Africa, where water is scarce, may use outside shipments of fresh water and techniques to purify the abundant ocean water in order to survive. Some areas in South America where water may be abundant, could be unsafe to drink due to the biological
1. There are two main sources of fresh drinking water, ground water and surface water. Ground water originates from precipitations that usually fall in the form of snow or rain. While, the surface water is also originates from precipitate that reaches the land surface and is then recharged into rivers, wetlands and lakes. Although these systems are usually reliable, in desperate time of need, a more reliable source of water is needed. The desalination plant is extremely valuable and flexible because it does not depend on rainfall. Instead, the desalination plant is the only source that relies on seawater. Using seawater in the desalination plant helps meet the community’s water needs and secures the water needs in the future. While other sources of water, such as rainwater or water from dames are not reliable enough to strictly rely
While desalination, is indeed an effective long-term solution, it isn 't necessarily the most cost competitive method, because it can cost four to eight times more expensive than alternative solutions.
Desalination is the removal of salt and impurities from groundwater or seawater to produce fresh drinking water. Desalination is a secure water source that doesn’t depend on rainfall and has become a significant water source that has been strengthened through its decrease in production costs and related technological improvements. The process of Desalination is another means of securing Western Australia’s future water supply. Western Australia has two main plants, Perth Seawater Desalination Plant and Southern Seawater Desalination Plant, both of these plants deliver water to the Integrated Water Supply Scheme which supplies water to over 2 million people in Perth, parts of the South West, parts of the Agricultural region and the Kalgoorlie-Boulder
It begins sea water to enter the sea water intakes through the refineries so as to prevent impurities from entering the sea water pumps, which in turn pumped seawater evaporators. After that, sea water mix with sodium hypochlorite when sea water intakes before entering the evaporator in order to process biological material sticking out. This solution (sol) is treated in tanks and then is injected through the pumps in specific amount on demand. There are electric power plates next to the sea water intakes for distribute electricity power that feed pumps and other electrically equipment’s, as there is also a measurement required for this equipment and control devices. The seawater moves
The purpose of this project was to discover how the pH level affects corrosion rate. The hypothesis was if the pH level affects the corrosion rate, then the lower the pH level is quicker the corrosion rate would be. This will happen because liquids below the pH level of 7 possess stronger acidic attributes. The effect of pH level on corrosion rate was determined by depositing a copper penny in each of three plastic cups, and then three different liquids by their pH levels, were assigned to be displaced into each cup formulating a chemical reaction to be observed. The results collected during this investigation contradicted with the intended result, this experiment was conducted to determine corrosion rate; Dana Puti Vingear (pH level: 4.5)