2.) Weights of 2, 4, 6 and 8 N are fastened to the corners of a 2 m 2 m frame. If it weighs 10 N, where would the fulcrum (the support point) be placed to balance the frame and the weights? Show the Free body diagram of your work. Write it on the paper and do not type it

The homogeneous plate of weight W is supported by a ball-and-socket joint at D and three wires. Draw the FBD of the plate and count the unknowns.

Weights of 2, 4, 6 and 8 N are fastened to the corners of a 2 m x 2 m frame. If it weighs 10 N, where would the fulcrum (the support point) be placed to balance the frame and the weights?

Abbot and Costello are transporting a 0.125m3 cubic block along a ramp inclined at 20°. They tied the block under the midpoint of a 3m, 2kg, pole-arm. Abbot is at the lower end of the pole while Costello leads the pair up, holding the other end of the pole. Calculate the upward forces exerted by Abbot and Costello during the transport if the block weighs 1000N.

In a hydraulic press, the small cylinder has a diamter of 1 in, while the large piston has a diameter of 8 in. If a force of 120 lbs is applied to the small piston, what is the force on the large piston, neglecting friction.

In a hydraulic press the diameter of the plunger is 50 mm . Find the diameter of the hydraulic press side when the force at hydraulic press side is 22050 N to lift the weight at the plunger of 450N. a. 350 mm b. 250 mm c. 500 mm d. 100 mm

The picture attached shows a boom that supports the weight 2000 N. The boom is supported by the hinge at A and a wire. It weighs 3000 N. Find the magnitude of the support force at the hinge.

Find the tension of AB, BC, and BD in pounds.

Question 8 A weight of 1467 N resting over a smooth surface inclined at 30° with the horizontal, is supported by a weight (P) resting on a smooth surface inclined at 45° with the horizontal as shown in figure. Determine the weight P.