.In the given soil profile detemine the 6'of the points A,B.C and D. Show the v ariations in a diagram below, Considering NO seepage. 6'(Draw Diagram here) A H1 = 4.5 m w = 33.75% Gs = 2.66 e = 0.352 Moist Soil H1 Layer 1 B Ground water H2 = 5.25 m n= 0.6 Gs = 2.68 H2 Layer 2 H3 H3 = 3.5 m e = 0.81, Yd = 12.73 KN/m D Layer 3

.In the given soil profile detemine the 6'of the points A,B.C and D. Show the v ariations in a diagram below, Considering NO seepage. 6'(Draw Diagram here) A H1 = 4.5 m w = 33.75% Gs = 2.66 e = 0.352 Moist Soil H1 Layer 1 B Ground water H2 = 5.25 m n= 0.6 Gs = 2.68 H2 Layer 2 H3 H3 = 3.5 m e = 0.81, Yd = 12.73 KN/m D Layer 3

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter11: Ground Improvement

Section: Chapter Questions

Problem 11.9P

See similar textbooks

Similar questions

The subgrade is 72 feet wide at the top and is 9 feet thick. It has a Specific Gravity, Gs =2.66, a final porosity of 31.0% and a degree of saturation of 86.3%. It is coming from aborrow pit with an average total unit weight of 112.6 pcf and a water content of 8.0%.How many pounds of water must be added to the borrow material for the fill? How manycubic feet of borrow must be excavated? (Hints: Draw two phase diagrams, one for theembankment and one for the borrow pit. What is common between the conditions?(Intermediate Answer, This is not a given, but a value so you can check your work as youprogress. Ww in borrow pit = 43,100,000 pounds )
The following data are given for overconsolidated clay: Gs=2.71 LL=45 Average Pressure=120 kPa e=0.8 thickness=4m Change in Pressure =40 kPa Cs=1/5 Cc Determine the following 1. Compression Index (Ans. 0.315) 2. Pre-consolidation Pressure (Ans. 92.9 kPa) 3. Primary Consolidation Settlement (Ans. 49 mm)
‘mormally consolidated clay given: 1S kKN/m® ateo=122 = 430 KN/m? ate=098 * 10° m/sec, Find: long in days will it take for a 3 m thick lsyer of the same drained both sides in the field to reach 50% consolidation? is settlement at 50% consolidation?
A deposit of cohesionless soil with a permeability of 0.3 mm/s has a depth of 12 m with impervious ledge below. A sheet pile wall is driven into this deposit to a depth of 8 m. The wall extendsabove the surface of the soil, and a 3 m depth of water acts on one side. Sketch the flow net and determine the seepage quantity. Provide a diagram a.600 ml/s/meter length b.300 ml/s/meter length c.900 ml/s/meter length d.1200 ml/s/meter length
A dense silt layer has the following properties: Void ratio = 0.76, SG= 2.59. Free ground water is 9.31m below the ground. Capillary action rise will reach 7.93m. The soil above capillary action rise is dry while within the zone, it is saturated at 53.13%. Determine the effective pressure (kPa) at a depth of 7.05m from the groind surface. Use stored value. Asnwer in 5 decimal places.
For a sandy soil with Gs 2.68, calculate the critical hydraulic gradient that willcause boiling or quick condition for e 0.38, 0.48, 0.6, 0.7, and 0.8. Plot thevariation of icr with the void ratio.
3.A half-closed clay layer is 8 m thick and it can be assumed that cv ¼ ch. Verticalsand drains 300 mm in diameter, spaced at 3 m centres in a square pattern, areto be used to increase the rate of consolidation of the clay under the increasedvertical stress due to the construction of an embankment. Without sand drainsthe degree of consolidation at the time the embankment is due to come into usehas been calculated as 25%. What degree of consolidation would be reachedwith the sand drains at the same time?
The sand layer shown is 2.5m thick. Beneath the sand layer is a 1.8m thick clay layer, underneath the clay layer is a solid rock. Water table is at depth of 0.9 m below the ground surface. SAND: Ymoist= 23KN/m3 ; Ysat= 21KN/m3 CLAY: Ysat= 23 KN/m3 ; LL= 42% e=0.7 A.) Compute the overburden pressure at mid-clay layer. B.) Find the maximum surface pressure without exceeding a 139.5mm settlement in clay layer if it is assumed to be normally consolidated. C.) If surface pressure is 70kpa and pre-consolidation pressure is 80kpa, find the settlement in clay layer.
As indicated in the following figure, an incompressible silty sand fill 16.4 ft thick wasplaced on top of a 49.2 ft thick layer of soft and compressible silty clay. Underlying theclay is a layer of incompressible sandy gravel. The soil properties of the silty clay layer aregiven in the following figure. The ultimate settlement, Sult = 5.64 ft, from the primaryconsolidation of silty clay layer due to the weight of the silty sand fill is calculated. A) Find the time rate of settlement by showing the Time [year] vs. Settlement [ft] curve.Show sample calculation when percentage of consolidation, Uavg = 50% B) Compute and plot effective stress profile (σ’z vs. depth) at the Silty Clay layer in thefollowing timing:a. Before placing the fill layerb. right after placing the fill layerc. Ten years after placing the fill layerd. 40 years placing the fill layerShow sample (hand) calculation at a depth of 41 ft and the timing of 10 years after placingthe fill layer. can you show your work on…
The embankment for a highway 5097 ft long, 104 ft wide and 6 ft in compacted thickness is to be constructed from a sandy soil trucked from a borrow pit. The water content of the sandy soil in the borrow pit is 6.748% and its porosity is 0.422. The specification requires the embankment be compacted to a dry unit weight of 122.874 lb/ft3. The specific gravity is 2.588. Determine the following: a. Total weight of the soil solids, kips. b. Total volume of the soil required from the borrow pit, ft3. c. Weight of water to be added per foot length of the embankment to reach 10% moisture content, lb.Round off answers to three decimal places.
The embankment for a highway 5097 ft long, 104 ft wide and 6 ft in compacted thickness is to be constructed from a sandy soil trucked from a borrow pit. The water content of the sandy soil in the borrow pit is 6.748% and its porosity is 0.422. The specification requires the embankment be compacted to a dry unit weight of 122.874 lb/ft3. The specific gravity is 2.588. Determine the following: a. Total weight of the soil solids, kips. b. Total volume of the soil required from the borrow pit, ft3. c. Weight of water to be added per foot length of the embankment to reach 10% moisture content, lb.
Wrong answers will be downvoted Qsn. A soil mass has kx=8*10-7cm/s and ky=4*10-7cm/s. The effective permeability of the soil is ______ 5.6*10-7cm/s 6.6*10-7cm/s 4.6*10-7cm/s