.Q1/(a) At the network below, Find Av

Q: Q. Determine the resistance between the terminals A and B of the network. 10 2 20Ω A 52 152 10Ω 25 2...

A:

Q: Under the condition that Ra = R, in terms of V1, derive or solve for an expression for V0 usinng cir...

A:

Q: Find the Thévenin equivalent of this circuit.

A: The given circuit is shown below:

Q: 1. a) Explain parity method for error detection for 8-bit data transmission using necessary circuit.

A: When a message or signal is forwarded, it may be resolved by noise or data is corrupted. To avoid th...

Q: A 400 V, 4-pole, 1450 rpm, 50 Hz wound- rotor induction motor has the following circuit model parame...

A: Given, V=400VN=1450rpmf=50HzR1=0.3Ω R2=0.25ΩX1=X2=0.6ΩXm=35ΩLet the motor is Y-connectedR01=R1+R2=0....

Q: D1 D2 R1 R2 Si Ge R3

A:

Q: 3. A 100 µF capacitor, a 4.0 H inductor and a 35 Qresistor are connected in series with an alternati...

A:

Q: R 300 300 135V I In order for the power consumed in the circuit in the figure to be 405 W, the value...

A:

Q: - An| b(1 – con(0)/ /1+ cos(0) etermine the values of the constants (A and B) so that the value of V...

A: The value of voltage V at given coordinate is 800V, putting it in question we have: 800=AlnB(1-cos75...

Q: complement of F=

A: When we take Function and its compliment  then their- multiplication is 0  addition is one.

Q: a pɔ q e DE • 22 • 92 • sz .. 25 22 61 61 91 12 LL abcde

A: A circuit made up of only parts connected to a series is known as a series circuit; similarly, one f...

Q: With reference to the network shown in Fig. 10.19, find the input impedance Zin that would be measur...

A:

Q: Write a conclusion about voltage drop and power loss calculations for Ring d.c distribution system.

A: Ring DC distribution system: It is the system for distributing the power. In this system, the first ...

Q: A transformer having efficiency of 90% is working on 200 V and 3 kW power supply. If the current in ...

A:

Q: 1. The Equivalent resistance to this set of resistors? 2. The total current of the circuit? 3. The v...

A:

Q: 4.41 Find the Thevenin and Norton equivalents at terminals a-b of the circuit shown in Fig. 4.108. 1...

A:

Q: The three transformers that feed & three-phase converter is connected in Δ on the primary side and Y...

A: We know that the, for star connected network the line current is equal to the phase current. So, the...

Q: 100 ohm V2 220 ohm V1 560 ohm I, V4 330 ohm V3 470 ohm 150 ohm 820 ohm 20v V2 V3 V4 I100 2 Iıso n

A: Given circuit :

Q: A 3-phase, 50Hz, 600V, 6-Pole IM gives an output of 37.5kW at 960rpm. the motor is operating at 0.86...

A:

Q: explain what happened as the lamp load increasing through shunt generator

A: The ammeter displays the load current readings, while the voltmeter displays the end voltage value. ...

Q: Discussion Question 1: A rectangular block of iron is 2cm x 2cm x 30cm. How would you connect this b...

A: A rectangular block of iron which has the dimensions of 2 cm× 2 cm × 30 cm. So now if we connect it ...

Q: Can someone explain this problem steb by step. Thanks!!

A:

Q: A signal waveform has a frequency of 8 MHz, and the width of the positive pulse is 0.08 us. What is ...

A:

Q: R 300 30Ω 135V I In order for the power consumed in the circuit in the figure to be 405 W, the value...

A: Given circuit: Power consumed in the circuit is 405 W.  

Q: 20/0º V j1 N Vị V2 5Ω ,3Ω 10 -j1N: 2/0° A I,

A: In the given circuit there are two nodes V1 and V2 connected with a voltage source. The first equati...

Q: 1. A tuned circuit has a resonant frequency of 18 MHz and a bandwidth of 120 kHz. What are the upper...

A: 1.  The upper and the lower cut-off frequencies in terms of the resonant frequency and the bandwidth...

Q: 2. The series is shown in the picture below, i(t) = 2 + 10 Cos(t+10° ) + 6 Cos(3t + 35°) Amperre., ...

A: The solution is given below 

Q: 625 G(s) 2+ 625

A:

Q: 196 G (s) = s (s + 8) Find the frequency domain specifications for the system

A:

Q: Q-4) Find the number of poles in the left half-plane, the right half-plane, and on the jw-axis for t...

A: Transfer function- It is define as the mathematical terms which shows the relation between the outpu...

Q: 7. Show a PLD fuse mapping for the following function using ONLY the below schemalle. O= !(MS!G # !M...

A:

Q: A transformer having efficiency of 90% is working on 200 V and 3 kW power supply. If the current in ...

A: Given, Efficiency of transformer, η=90 % = 0.9 Primary side voltage, VP=200 V Input power, Pin=3 kW=...

Q: 2. Calculate the rms value of the half-wave rectified sine wave shown in Figure P5.12. v(i) V 5 sin(...

A:

Q: Use R, = 9N and R2 = 10 N to find the Thévenin equivalent of the circuit shown below. R, 90 V R2 b

A: Given circuit:  

Q: 1) An analog signal x(t) = cos(320nt) + 2 cos(480nt) – cos(960zt ) is sampled with sampling frequenc...

A: Note- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the se...

Q: Compute the DFT for the sequence [3,2,1,0]

A:

Q: a) h[n] = {-1,1,2,-3,4} Above defines the impulse response h[n] of a certain LTI aystem Determine t...

A: Given, h[n] = {-1,1,2,-3,4} and x[n] = {-1,-2,5,3,4}. output signal y[n] of the system can be calcul...

Q: 1. The current in the 12 2 resistor in the following circuit is 1 A, as shown. a) Find vg b) Find th...

A: The solution is given below 

Q: 2 A Vo 1 A 10 V

A: Given superposition principle: The response produced at an element when all the sources are present...

Q: Q3 /For the circuit shown below calculate the voltage across R1 if multiple voltmeter are used with ...

A: The voltmeter will give best reading if its internal resistance is very high i.e. close to ∞. The ac...

Q: 12 0 20 0 + 40 V 25 0 5A 40 a 8A V. Q#2. Find voltage V across the 40 O resistance using Superpositi...

A:

Q: Reducing F = /ABC + A/BC + AB/c + ABC would result in the equation: Select one: O a. AB + BC + AC O ...

A: Given Boolean function: F=A'BC+AB'C+ABC'+ABC

Q: 3. A length 21, FIR lowpass filter is designed using the windowing method, and rectan- gular window ...

A:

Q: A biomass furnace is tested to determine its performance in terms of heating and evaporating water. ...

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for yo...

Q: Quiz (4) Consider the linear shift-invariant system described by the LCCDE y(n) = -y(n – 1) + 2x(n) ...

A: We need to find out the output for given system for given input

Q: 3. Determine V, and V2. 1 + Vi lov( + V2_

A: Given circuit:

Q: 4(t) = A1 - cos (1000t +5) + Az · cos • cos (2000t – Assume the system is in steady state. Find the ...

A:

Q: D1 R1 R2 DIODE R3 E

A:

Q: Use Kirchhoff’s Laws to find the branch currents indicated in the following networks

A: In this question,  Find the unknown current as shown in the circuit using the Kirchhoff’s Laws.  We ...

Q: Determine the terminal voltage of a 4-pole, 3-phase alternator that is running at 50 hz. The alterna...

A: Per phase induced emf =  4.44×f×flux×per phase turns× winding factor.   

Thevenin Theorem

Any linear circuit, no matter how complex, maybe simplified to an equivalent circuit utilizing only a single voltage source and series resistance coupled to a load, according to Thevenin's Theorem. The superposition principle says that all foundational equations must be linear, and the notion of "linear" is still the same (i.e., there should not be any exponentials or roots). This is particularly the case when operating with passive elements like resistors, inductors, and capacitors. However, some components (particularly some gaseous and semiconductor devices like tunnel diode, Schottky diode, transistors like BJT, MOSFET) are nonlinear, meaning their current resistance fluctuates with voltage and current. As a result, circuits made up of these parts are known as nonlinear circuits.