0.2 m 3 0.8 m Mud Pm A retaining wall against a mud slide is to be constructed by placing 0.8-m-high and 0.2-m- wide rectangular concrete blocks ( mass density = 2700 kg/m3) side by side, as shown in the figure. The friction coefficient between the ground and the concrete blocks is f = 0.3, and the density of the mud is about 1800 kg/m3. There is concern that the concrete blocks may slide or tip over the lower left edge as the mud level rises. Determine the mud height at which (a) the blocks will overcome friction and start sliding and (b) the blocks will tip over. m

0.2 m 3 0.8 m Mud Pm A retaining wall against a mud slide is to be constructed by placing 0.8-m-high and 0.2-m- wide rectangular concrete blocks ( mass density = 2700 kg/m3) side by side, as shown in the figure. The friction coefficient between the ground and the concrete blocks is f = 0.3, and the density of the mud is about 1800 kg/m3. There is concern that the concrete blocks may slide or tip over the lower left edge as the mud level rises. Determine the mud height at which (a) the blocks will overcome friction and start sliding and (b) the blocks will tip over. m

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter12: Lateral Earth Pressure

Section: Chapter Questions

Problem 12.5P

See similar textbooks

Similar questions

Determine the total active thrust, in kN/m, for a retaining wall (height 5.60 m) with horizontal backfill given the following properties: Unit weight = 17.42 kN/m3, angle of internal friction = 32 degrees, Cohesion = 11.76 kPa, Surcharge = 9.32 kPa.
Determine the total active thrust, in kN/m, for a retaining wall (height 4.77 m.) with horizontal backfill given the following properties: Unit weight = 17.49 kN/m3, Angle of internal friction = 32°, Cohesion = 11.32 kPa, and Surcharge = 8.6 kPa. Round off to two decimal places.
A retaining wall 9 m high supports a cohesionless sandy soil with its face vertical as shown in figure below. Find active earth pressure on the wall , Take Yw = 9.81kN / (m ^ 3)
Determine the active Rankine earth pressure (magnitude and location) against the 1-foot thick retaining wall in the figure at right.
A rigid retaining wall 5m high supports a backfill of cohesionless soil with angle of 40°. The water table is below the base of the wall. The backfill is dry and has a unit weight of 19kN/m³. Determine Rankine's passive earth pressure per meter length of the wall.
Determine the active thrust pressure for the backfill soil having an internal friction angle of 35° and unit weight of 110 lb/ft3. The height of the retaining wall is 18 ft.
Q.8 The depths of soil behind and in front of a rigid retaining wall are 25 ft and 10 ft. respectively, both the soil surfaces being horizontal (Fig. 3). The shear strength parameters for the soil are c = 600 lb/ft2, and Ø = 22°, and the unit weight is 110 lb/ft3. Using Rankine theory, determine the total active thrust behind the wall and the total passive resistance in front of the wall. Assume the water table is at a great depth
3) A retaining wall is illustrated IN THE Figure. Determine the Rankine active force, (Pa) per unit length of the wall and the location of the resultant. H = 9 m, H1 = 4 m, Υ1 = 16.5 kN/m3, Υ2 = 20.2 kN/m3, ø'1 = 30, ø'2 = 34, q= 21 kN/m2
A concrete dam is triangular in cross section and 30m high from the horizontal base. If water reaches a depth of 27m on the vertical face, what is the minimum length of the base of the dam such that the resultant will intersect the base within the middle third? What minimum coefficient of friction is required to prevent sliding ? Determine the pressure distribution along the base. If the uplift pressure varies from half full hydrostatic at the heel to zero at the toe.
A vertical retaining wall 6 m high is supporting a horizontal backfill having a weight of 16.5 kN/m3 and a saturated unit weight of 19kN/m3. Angle of internal friction of backfill is 30°. Ground water table is located 3m below the ground surface. Determine the at rest lateral earth force per meter length.Determine the location of the resultant force.Determine the at rest lateral earth force per meter length if it carries a surcharge of 50 KPa. INCLUDE FBD.
A frictionless retaining wall is shown in the figure below. Location of passive force from the base of the wall (m)
A retaining wall 6 m high supports cohesionless soil having a dry density of 1600 kg/m³, angle of resistance 32 and void ratio of 0.68. The surface of the soil is horizontal and level with the top of the wall. Neglecting wall friction and using Rankine’s formula for active pressure of a cohesionless soil. 1. Determine the nearest value of the total earth thrust on the wall in KN per lineal meter if the soil is dry. a. 73.1 b. 86.7 c. 62.4 d. 98.1 2. Find the nearest value of the thrust on the wall in KN per lineal meter if owing to inadequate drainage, it is waterlogged to a level of 3.5 m below the surface. a. 112 b. 171 c. 147 d. 153 3. Find at what height above the base of the wall the thrust acts during the waterlogged condition. a. 2.21 m b. 2.00 m c. 1.74 m d. 1.42 m