DO NOT COPY FROM OTHER WEBSITESCorrect and detailed answer will be Upvoted else downvoted. Thank you!, 05: An analog signal is first encoded in binary PCM before being transformed to amultilevel signal for transmission over the channel. Suppose that an analog messagewith a bandwidth of 2700 Hz is to be replicated with a #1 percent accuracy at thereceiver output. Also suppose the number of levels is seven. Compute:1- The bit rate of the required PCM signal.2- The baud rate of the signal.3- The minimum channel bandwidth required for transmission.

Given that an analog signal is encoded in binary PCM band then converted to a multilevel signal for…

Answered: 05: An analog signal is first encoded…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

ChapterS: Safety, Basic Electricity And Ohm's Law

Section: Chapter Questions

Problem 8RQ: What is an MSDS?

See similar textbooks

Similar questions

Consider a bandlimited message signal of 6kHz bandwidth. It is sampled at the rate of 55% higher than the Nyquist rate. The maximum quantization error of the sample amplitude is 0.5% of the peak amplitude? . Assume binary encoding. Calculate the minimum bandwidth ? of the channel to transmit the encoded binary signal.
Exxplain the rellation between BER and E/N_0, where E is the energy per bit,N_0 is the noise spectral density, BER is the bit error rate. What is the reason for usign channel coding?
When the number of bits in a PCM mode, n, is 3, what is the dynamic range in dB?
12-21. For a 16-QAM modulator with input bit rate fb = 10 Mbps and carrier frequency fc = 60 MHz, calculate the minimum bilateral Nyquist rate and baud rate. Tracea schematic of the output spectrum
The bit rate of a digital communication system is R kbit/s and the modulation used is 32-QAM. What will be the minimum bandwidth required for ISI free transmission?
A data of 240 kbps is to be transmitted over a channel of 5 kHz bandwidth. The transmission should be free from the ISI problem. What should be the minimum value of the SNR (in dB unit) if the channel is noisy?
Type your question here A carrier signal given by 10 cos 10000 ?? ???? is AM/DSB-LC modulated by single-tone signal 4 cos 100 ?? ????. 1- Calculate the modulation index. 2- Sketch the spectrum of the modulated signal. 3- Calculate transmission bandwidth.
A. If the probability of error of BPSK is 0.85 then Pe of BFSK is? B. What happens to the radio wave propagation when the rouefractive index of ionospheric layer becomes low or high? C. If the number of quantization levels are multiplied by four time them how many numbers of bits are added to the actual number? D. What is the disadvantage of wave tilt? E. What is a bipolar line coding technique with phase encoding, and explain why it is named as phase encoding method? F. What is oblique communication circuit? G. What are the differences between DPCM and Delta Modulation? H. What is the change in bandwidth when channel capacity is doubled and two number of bits are increased?
A CDMA system delivers message to N = 40 users with equal power. The message is transmitted at a rate of 10 kbps, using a DS spread spectrum signal operating at a chip rate of 2MHz. a. What is a bit period?b. What is a chip period?c. What is the processing gain of the system?
We need to send data 15bits at a time at a bit rate of 9Mbps. The carrier frequency is 18MHz.Calculate the number of levels (different frequencies), the baud rate, and the bandwidth.
Draw and show the BFSK modulation waveform for the given binary data sequence “1,0,0,1”, and also draw its BFSK constellation diagram.
A PCM binary stream is produced using an 8,000 samples/s rate and 7-bit encoding. 32 synchronization bits are inserted into the binary stream for every 224 data bits. The resulting binary stream is then transmitted in two-level pulses over a baseband channel, with r = 0.2. This is followed by digital band-pass modulation before the transmission. a. What is the bandwidth of the baseband transmission? b. Determine the bandwidth of the pass-band transmission under the following digital modulation schemes: c. BPSK. d. QPSK. e. BASK.

SEE MORE QUESTIONS

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS