Find the margin of K to keep the system shown in figure N°1 stable 1-_ Find the margin of K to keep the system shown in figure N°1 stableR(s) +E(S)KSs-1s²+2s+1C(s)Find how many poles there are in the right half plane, left half plane, and on the jo axis.Is this system stable in open loop?Use routh-wirts

Answered: 1-_ Find the margin of K to keep the…

Engineering

Electrical Engineering

1-_ Find the margin of K to keep the system shown in figure N°1 stable R(s) E(S) K S s-1 s²+2s+1 C(s)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.27P

See similar textbooks

Related questions

Q: a. A 55-hp, 550-V shunt wound motor draws a line current of 5 A at no load. The shunt field…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Solve the following. Show complete solution, complete equation, resistor combination and circuit…

Q: consider the binary number 110110012. Find the equivalent decimal number.

Q: V R2 ww R1 C1

Q: converter topologies in pv system

A: It is asked to discuss about the converter topologies in PV system.

Q: es the wattmeter has resistance and resistance halwlate the Percentage error if the Wattmeter is So…

A: When the current coil is connected near to the load then error in power measurement =I2 RC When the…

Q: 4. An LC circuit consists of a 1-uF capacitor and a 4mH inductor. What is its oscillation frequency…

A: Given data, The capacitor (C) is 1μF The inductor(L) is 4mH

Q: Quiz Determine the value of ix and V. 20/30° V 60Hz 10 (2 ww 14 ΤΗ 0.1 F 0.5 H

A: Given data, Circuit diagram is given as,

Q: For a 16-QAM modulator with input bit rate fb = 10 Mbps and carrier frequency fc = 60 MHz, calculate…

Q: F.T. 3) If X(t) + y(t) = x (2t - 1) it Ans: Y(w) X(w) and X.(W) = -J(W+1) W+1 [4+jCW+1)]² (2+jwj2…

Q: Find the solution to linear constant coefficient difference equation y(n)= (1/2) y(n-1) + x(n) with…

Q: 4. Write nodal equations for V1, V2, V3, V4. Do not simplify. 50 Vi ele V3 2H 0. 40 3MCT) 1₂ 0 For…

A: For the above given question we need to write nodal equations for all the nodes.

Q: Given the periodic signal x(t) with A= 4 and T = 2. The Fourier series coefficient ao of x(t) is…

A: The periodic signal repeat itself after fixed interval of time . The periodic signal are transform…

Q: A 30 star connected 6-pole 60 Hz induction motor draws 16.8A at a power factor of 80% lagging with…

A: In this question, We need to determine the speed of the motor, rotor current and copper losses? We…

Q: A negative-sequence Δ-connected three-phase generator feeds a Δ-balanced load. If the load impedance…

A: Given: Ia=(18.43+j12.91) A=(22.5∠35.01°)AZ=(18+j12)Ω In delta connection, line current is 3 times of…

Q: 2. In the circuit below vin (t) = 10V, and has been present for a very long time. $1 1 In 2 S 1F HH…

A: For the above given circuit we need to calculate all the voltage parameters of the capacitors.

Q: For an unmodulated carrier of 150 V and a modulated peak value of 230 V. What is the modulation…

A: Given: Un-modulated carrier amplitude, Ac=150 V Modulated peak, Am+Ac=230 V

Q: convention V0 is real) and assume that I(t) = I0eiωt where I0 is a general complex number (which can…

Q: this is not incomplete, and please do not answer its functioning of parts answer should be on point…

A: It is asked to explain the isolated operation of wind farms.

Q: A system that its output at a given time depends only on the input at the same time is said to be O…

A: Given statement: A system that its output at a given time depends only on the input at the same time…

Q: 3- Choose the correct answer: a. If the system requires lower system complexity, which system do you…

Q: 2. The force exerted on an object is given by F = 2xax +3zay -4a₂. Determine the F along the…

Q: iii) A three-phase, 50Hz, 6-pole induction motor runs at 950 rpm. Calculate a) the synchronous speed…

Q: The potential difference (VA - VB) between the points A and B in the given figure is. VA A I=2A 22…

A: Given circuit,

Q: According to the NEC, allowance for the future expansion of installations is A. an exception. B. in…

A: Answer:A:- an exception

Q: Design a clamper to perform the function indicated. That is, determine the proper value of V₁ (A)…

Q: Determine the value of ix and V. 20/30° V 60Hz 10 92 1H 0.1 F 0.5 H V

A: Let two impedance x and y be connected in parallel and the Total current flowing through the winding…

Q: For the following circuit Is = 10/0° (A) Z₁ = -19.0000 + j4.0000 (S2) Z₂ = -1.0000-j4.0000 (9) Is +…

A: Given, Is=10∠0° AZ1=-19.0000+j4.0000 ΩZ2=-1.0000-j4.0000 Ω

Q: The minimum size service disconnect for a single-family dwelling is A. 200 A. B. 100 A. C. 60 A. D.…

A: 4 .a. Based on our load we used the minimum size service disconnected for a single - family dwelling…

Q: The resistance and Calculate wel me for Ls 1) The ii The Пе 11 2 if الا lto connected SO curent coil…

A: Given data:: current coil resistance (let Ra)= 0.03 ohms pressure coil resistance (let Rp) = 6000…

Q: GIVEN: A motor has an output of 0.5 hp with an input of 410 W. FIND: The efficiency of the motor.…

A: Given, A motor has Output power, P0=0.5 hp Input power, Pin=410 W

Q: 14.a. A clothes dryer in a one-family dwelling is rated at 6,000 VA. What's the demand load on the…

Q: For op-amp circuit shown in fig. 10.80, Determine the bandwidth with feedback when the gain…

A: For the circuit shown in the figure, Gain * BW = 2.6 x 108 Hz with feedback So if we are able to…

Q: At what rate is thermal energy being generated (The power) in the 2R-resistor when - 16 V and…

A: We need to find out power for given resistor for the given circuit

Q: Solve for question iv) and v)

Q: blackboard.ncat.edu Remaining Time: 1 hour, 17 minutes, 25 seconds. A Moving to the next question *…

A: The given circuit diagram is shown below:

Q: 3. For the circuit in Fig. find the branch currents I, Iz, and I, using mesh analysis. 12V α 5Ω 12…

A: Given circuit,

Q: (+ -15V 15V U1 VEE 741

A: Given data, Input is given, vi=12V, 6 V, 0 V, -6 V,-12 V Circuit diagram is given as,

Q: From the truth table below, determine the standard SOP expression. Inputs Output ABC X 000 0 001 1…

A: Given data, Truth table,

Q: Figure 2: For questions 3-5 R1=100 R2=40 www R4=200 R3=60

A: Given data : The given circuit is shown below, (4) Battery voltage E=400V (5) Total resistance…

Q: (A) Write the nodal equations using the general approach for the network. Find the nodal voltages…

A: Given data : The given circuit is shown below,

Q: 12-23. Calculate the bandwidth efficiency for the following modulators: (a) QPSK, fb= 20Mbps. (b)…

A: For the given phase shift keying methods we need to calculate bandwidth efficiency for the given…

Q: 3. For the circuit shown in Fig. Q3: (1) compute the total impedance in polar form. (ii) compute the…

Q: 4Α νι 1Ω www 20 Ω www 02 10 Ω 8 Ω V4 10 Ω V3 Μ 20 Ω 30 Ω

Q: In order to show both forms concurrently, both input channels (CH1 and CH2) of the oscilloscope…

A: Oscilloscope is a device which is used to see the different signals like voltage, current etc. In…

Q: a. If the system requires lower system complexity, which system do you recommend: i. DPCM ii. DM…

A: 3)a) Delta modulator (DM) has lowest system complexity since it is a one bit quantiser. 3)b) The…

Q: V Q₁ Dynamster type voltmeter with its Vollage coil Connected across the Load side teads 192 w. load…

A: Given: Power, P=192 WVoltage, V=208VResistance of the potenitial coil, R=3825Ω

Q: Find the thevenin equivalent circuit

A: The given circuit diagram is shown below:

Q: What is the bandwidth of a parallel resonant circ ductance of 33 uH with a resistance of 14 V and a

Q: manufacturing process is b) A represented by the following block diagram where G₁(s) = 4/s, G₂(s) =…

A: Mason's Gain Formula- It is a technique used for finding the transfer function of a control system.…

Concept explainers

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.

Question

Find the margin of K to keep the system shown in figure N°1 stable

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q(s)=s4+3s3+27s2+75s+50. Find: Number of poles in the left-half plane? Number of poles in the jw-axis? Number of poles in the right-half plane? State of system is stable/unstable/marginally stable
Solve for Zi, Zo, and Av. note that (ro = 1/gos)
The poles of a system are:P1=1, P2=(2+7), P3=(3+7), P4=(4+7), and P5=(5+7)(i) Draw the system in complex z-plane(ii) Determine the possible ROCs(iii) Comments on the causality and stability for each ROC
If the pole is located at the origin of the s plane, the response is in the form of a: a. damp exponential b. exponential rise c. sinusoid d. constant What characterizes an unstable system? a. poles at the origin b. poles with negative real part c. poles with positive real part d. poles without real part Routh’s stability criterion will provide the number of: a. RHP b. poles c. LHP d. imaginary poles
For a solenoid (toroidal inductor), the inductance (L) could be increased because of:1, The number of turns of wires (N) is increased2, The cross-sectional area of the toroid (A) is decreased3, the length of the wire used to wrap the toroid (l) is decreased4, the relative permeability of the core material (r) is larger(single answer)1, 2, 43, 41, 21, 31, 3, 41, 2, 3
Planes Z=0 and Z=4 carry current K= -13 ax A/m and K=22 ax A/m, Determine H at (a). (1,1,1) ; (b) .(0,-3,10).
a. Two vectors A and B are given at a point P(r, Ɵ, Φ) in space as A = 10ar + 30aƟ – 10a Φ B = 3ar + 10aƟ – 20a Φ Determine: 2A – 5B B A X B Repeat the above solution if the two vectors A and B given at a point P(r, Ɵ, Φ) in space reduced by 30 percent. Discuss the differences in solution a and b above.
can you please solve this question, thanks. In free space, let Q1 = 10 nC be at P1(0,-4,0) and Q2 = 20 nC be at P1(0,0,4). Find E at the origin.
H6. You are planning a trip to a new high altitude space station. Your spacecraft is in an initial 200 km altitude circular earth orbit. Performing a Hohmann transfer compute: (a) the TOTAL delta-v required for a Hohmann transfer to a 1000 km altitude coplanar circular earth orbit. answer choices a. Dv = 445.38 m/sec b.Dv = 421.309 m/sec c.433.778 m/sec d. 220.00 m/sec
Question: Planes z=4 ,z=6 and y =1 carry current K=30ax A/m,K=20 ax and K=-20az A /m,respectively. Determine H at (0,0,2)
please solve question 8, X A solid spherical insulator hus radius R-z^ 3 +m. and carries a total positive chargo Q - R *10^ C distributed uniformly throughout in volume. Find the magnitude of the house field Eat 4 cm from the origin A 2.88 - 10 ^ 2 * NC B. 200 * 10 ^ 2 * NC 4.50 * 10 ^ 3 * NC D. 1.15 * 10 ^ 2 * NC
Suppose that a rectangular loop with sides measuring 0.01m lies in the plane x with its center in the origin as shown in the figure below. B=0.2t z