1: A hypodermic syringe contains a medicine with the density of water. The barrel of the syringe has a cross-sectional area (2.50x105) m², and the needle has a cross-sectional area (1.00x10 8) m². In the absence of a force on the plunger, the pressure everywhere is 1.00 atm. A force F of magnitude 2.00 N acts on the plunger, making medicine squirt horizontally from the needle. Determine the speed of the medicine as it leaves the needles tip.

1: A hypodermic syringe contains a medicine with the density of water. The barrel of the syringe has a cross-sectional area (2.50x105) m², and the needle has a cross-sectional area (1.00x10 8) m². In the absence of a force on the plunger, the pressure everywhere is 1.00 atm. A force F of magnitude 2.00 N acts on the plunger, making medicine squirt horizontally from the needle. Determine the speed of the medicine as it leaves the needles tip.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.121P: One side of the container has a 03-m square door that is hinged at its top edge. If the container is...

See similar textbooks

Similar questions

Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen, air, and saturated steam at a temperature of 100C. Let D=1m,U=1m/sec, and hc=1W/m2K.
The thin-walled cylindrical can with a spherical dimple weighs 0.2 lb. Determine the force P required to push the can into water to a depth of 8 in. Use =0.036lb/in.3 for water.
One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
Each of the three gates has a constant width 1: (perpendicular to the paper). Calculate the force P required to maintain each gate in the position shown. Express your answers in terms of b, c, h, and (the weight density of the fluid).
Determine the dimensions of constants A and B far which the following equation is dimensionally homogeneous: F=Akx2sinBxk where F is a force, x is a distance, and k represents stiffness (dimensions: [FL1]).
The weight of the cylindrical tank is negligible in comparison to the weight of water it contains (water weighs 62.4lb/ft3). The coefficient of static friction between the tank and the horizontal surface is s. (a) Assuming a full tank, find the smallest force P required to tip the tank, and the smallest s that would allow tipping to take place. (b) If the force P = 200 lb initiates tipping, determine the depth of water in the tank.
Atmospheric pressure at sea level under standard conditions is ______inches of mercury (Hg) or_____ pounds per square inch absolute (psia).
Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels are 16 ft on the upstream side and zero on the downstream side. For water, use =62.4lb/ft3.
draw or make the FBD A test tube standing vertically in a test tube rack contains 2.5 cm of oil (ρ =0.81 g/cm3) and 6.5 cm of water. What is the gauge and absolute pressure on the bottom of the test tube? A 10kg block of Aluminum (ρ = 2700kg/m3) is attached to a rope. a. What is the tension force in the rope if the block is in a vacuum?b. What is the tension force if the block is in air (ρ = 1.29kg/m3)c. What is the tension force if the block is in water (ρ=1,000 kg/m3) A downward force of 100 N is applied to the small piston with a diameter of 50 cm in the hydraulic lift system shown below.a. What is the upward force exerted by the large piston with a diameter of 2m?b. What is the mechanical advantage of this hydraulic lift?c. If the input force of 100N pushes the small piston down by 2m, how high will the large piston rise? Water flows through a circular pipe with a constant radius of 10cm. The speed and pressure at point A is 4m/s and 250,000Pa respectively.a. What is the speed…
Patients suffering from decompression sickness may be treated in a hyperbaric oxygen chamber filled with oxygen at greater than atmospheric pressure. A cylindrical chamber with flat end plates of diameter 0.75 m is filled with oxygen to a gauge pressure of 27 kPa. What is the resulting force on the end plate of the cylinder?
A 10000 litre water tank is placed on a building roof and filled to capacity. The empty tank has a mass of 550kg. It is supported on 4 feet, each of which is a 300 x 300 mm steel plate. What is the pressure exerted by each plate, in Pa? (Round your answer to 2 significant figures)
a drop of water has a diameter of 2.5 mm. What is the surface tension in air if the pressure within the droplet is 0.8 kpa