1- A man stands on the middle rung of a 250 N ladder resting on a smooth floor and against a wall as shown in Figure. The ladder is prevented from slipping by a string OD and the tension force in the string is 50 N, and the reactions at A and B are 1.3 kN and 433 N respectively. Find the mass of the man. DA e 250 N 30 2m 0

1- A man stands on the middle rung of a 250 N ladder resting on a smooth floor and against a wall as shown in Figure. The ladder is prevented from slipping by a string OD and the tension force in the string is 50 N, and the reactions at A and B are 1.3 kN and 433 N respectively. Find the mass of the man. DA e 250 N 30 2m 0

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

calculate the resultant moment about point O for all the figures below
Determine the magnitude (N) of the horizontal component of the reaction at point A if, F=492N, a=0.44m, b=2.02m, r=1.25m and d=27.47degrees. Round off only on the final answer expressed in 3 decimal places. Instead of units, indicate R if force is directed towards the right or L if towards the left.
Collars A and B are connected by a 525 mm wire and can slide freely, without friction, on the rods. If the force P = 370j [N] is applied to collar A and the system is in balance, calculate the intensity of the forces.
A 3-cm-diameter horizontal pipe attached to a surface makes a 90° turn to a vertical upward direction before the water is discharged at a velocity of 6 m/s. The horizontal section is 5 m long and the vertical section is 4 m long. Neglecting the mass of the pipe and considering the weight of the water contained in the pipe, the bending moment acting on the base of the pipe on the wall is (a) 11.9 N·m (b) 46.7 N·m (c) 127 N·m (d) 104 N·m (e) 74.8 N·m
Consider two blocks connected . BlockA has mass 2.00 kg, and block B has mass 5.00 kg. The table on whichB sits is frictionless, the cord connecting the blocks is light and flexible,and the pulley is light and frictionless. The horizontal force F S hasmagnitude F = 20.0 N, and block B moves to the left with an accelerationof 1.50 m/s2. What is the coefficient of kinetic friction that one block exerts on the other?
A 6m beam with a fixed end and supported by a roller in the right end is carrying a concentrated load at its midspan P = 20kN. What is the degree of indeterminacy? Determine the reaction in the roller support. Determine the angle of rotation at the roller support use EI = 2000kN.m2
The 58 kg uniform beam (slender rod) is lying on the floor when the man exerts a force of F = 336 N on the rope, which passes over a small smooth peg at C. a) Determine the initial angular acceleration of the beam, in rad/s2. b) Find the horizontal reaction on the beam at A (considered to be a pin) at this instant. Express your answer in Newtons.
Situation 1: A beam whose moment of inertia is 0.0036 m4 at portion CB and E = 220 GPa is subjected to a load of intensity q = 20 kN/m and L = 6 meters. 1. If support B is removed, Calculate the deflection at point B. 2. If support B is present, Calculate the value of reaction at support B. 3. Calculate the deflection at point C if support B is present.
A man having the mass of 75 kg sits in the chair which is pin-connected to the frame BC. If the man is always seated in an upright position, determine the horizontal and vertical reactions of the chair on the man at the instant ϴ = 45˚. At this instant he has a speed of 6 m/s, which is increasing at 0.5 m/s^2. Show FBD and solution.
2. A rectangular tank 6m long, 2m wide and 2m deep contains water to a depth of 1m. Itis accelerated horizontally at 2.5 m/s2 in the direction of its length. Determinea) Slope of the free surfaceb) Maximum and minimum pressure intensities at bottomc) Total force due to water acting on each end of tank. Check the difference betweenthese forces by calculating the inertia force of the accelerated mass.
The 14.6 lb lever OA with 9.6 in radius of gyration about O is initially at rest in the vertical position (?= 90°) where the attached spring of stiffness k = 4.3 lb/in is unstretched. Calculate the constant moment M applied to the lever through its shaft at O which will give the lever an angular velocity ? = 5.9 rad/sec as the lever reaches the horizontal position ? = 0.
Given the parabola 3x2 + 40y – 4800 = 0. (a) What is the area bounded by the parabola and the x-axis? (b) What is the moment of inertia, about the X-axis, of the area bounded by the parabola and the X-axis? (c) What is the radius of gyration, about the area bounded by the parabola and the X-axis?6. Determine the reactions at A and B on the Fink truss shown in the figure. Members CD and FG are respectively perpendicular to AE and BE at their midpoints.