1) For register AH • Set bits b0, b3 • Invert bits bl, b6, b7 • Reset bit b2, don't affect other bits
Q: (b) In the real mode, show the starting and ending addresses of each segment located by the…
A: In real mode the address are calculated as follows Starting address = (segment register)H * 10H…
Q: In MIPS, all operation codes (op-codes) use ______ only. A- 5 bits B- 8 bits C- 6 bits D -32 bits
A: In MIPS, all operation codes (op-codes) use ______ only. A- 5 bits B- 8 bits C- 6 bits D -32 bits…
Q: Add 16 and 16 using two's complement representation with 6 bits. Is there an overflow? a. 100000, no…
A: Objective: We need to determine the result of the addition of (+16) and (+16) using two's complement…
Q: consider two 8 bit numbers. a=01000001 and b = 10000100. add the two binary no. and interrupt the…
A:
Q: Q7. Perform the following operations using bit masking. (a) Set the bits 2, 4 and 6 of the register…
A:
Q: (A) What is the result of the operation 0242 - 0598 performed in 10's complement. Write down the…
A: Note: As ASCII table is not clearly visible. we had provide solution for other 3sub-parts . we…
Q: Computer Science Define variable arr with values 15,43,21. Store each value in R2, R3, and R4 with…
A: Least significant bit In a binary number, the bit furthest to the left is called the most…
Q: Note that you need to fill 3 digits for PC and AR, 4 digits for other registers, and 1 digit for E…
A: 105 answers Time (at the end of) PC IR AR DR AC E T0 109 - - - FFF9…
Q: A 3-bit parallel adder can add Select one: a. two 3-bit binary numbers b. three 2-bit binary numbers…
A: n-bit parallel adder is used to add two n-bit binary numbers.
Q: 4. Write an ALP to check whether the given byte 55 h is a bit wise palindrome if it is bit wise…
A: Here we have to write an ALP for given byte 55h which is bit wise palindrome........ And here…
Q: Q1: Select any value for AX register b15 b14 bi3 b12 b1 b0 b9 68 b7 ь6 b5 b4 b3 b2 b ьо X x |X x X…
A:
Q: Design 4 bit left/right rotation circuit that specifies the number of bits in the rotation by a…
A: Lets see the solution in the next steps
Q: 11.Convert word to double word. Reproduce bit 15 of AX and DX for example : AX = C32FH the result…
A: The signed word in AX to a signed double word in DX:AX by extending the most-significant bit (sign…
Q: Write an 8051 microcontroller C program to transfer the message “STOP” serially and continuously at…
A: Rules of Assembly LanguageThe assembly code must be written in upper case lettersThe labels must be…
Q: What is the concept of carry and overflow bit?
A: carry :-- Carry bit is set when we add two number and result is out of storage capacity of the…
Q: e with the message vector [ 1100] by using the states of the register(the ri
A: Q.
Q: ALP for 8-bit divison of numbers in register r3 and r4 and store result in P2
A: Given: ALP for 8-bit divison of numbers in register r3 and r4 and store result in P2. ALP is a…
Q: 4. S-boxes in DES map O a. 4 to 2 bits O b. 6 to 4 bits O c. 2 to 4 bits O d. 4 to 6 bits
A: S-boxes in DES map
Q: 1. In real mode, show the starting and ending addresses of each segment located by the following…
A: Given: In real mode, show the starting and ending addresses of each segment located by the following…
Q: Design a 4-bit ALU to perform the following functions: B',A OR B,A XOR B,A AND B
A: Hey there, I am writing the required solution based on the above given question. Please do find the…
Q: 6. a) Encode the following bit stream 110000111000000001 using i) HDB3 ii) B8ZS iii) Manchester iv)…
A:
Q: Design a 4-bit magnitude comparators, which compares two 4-bits binary numbers (A3A2A1A0 and…
A:
Q: 3) Fill the register AL with the bit 3 of AH, i.e., If b3 of AH=0 then AL must be 00H If b3 of AH=1…
A: Answer: If b3 of AH=2 then AL must be 1H.
Q: Q1: Select any value for AX register b15 b14 b13 b12 bl1 b10 b9 b8 b7 b6 b5 b4 b3 b2 bl b0 |X X X X…
A:
Q: Time left 1:3 A three bit LFSR is shown in figure below. Initially, the value of output Y = Y2Y1YO…
A: Given: A three bit LFSR is shown in figure below. Initially, the value of output Y = Y2Y1YO is set…
Q: Design a 4 bit arithmetic unit with two selection variables s0 and s1 and two n-bit data inputs…
A: It is defined as a logic circuit that performs basic arithmetic operations like addition,…
Q: LIST P = 16F877A Using INCLUDE "P16F877A.INC" and PWM (Pulse Width Modulation), write the…
A: PWM exploitation PIC Microcontroller The basics of pulse dimension modulation and you furthermore…
Q: 2. Find the Physical Address of a Segment: Offset value. a. 1010:2233 b. 3000:F2F2
A: Given: a 1010:2233 where 1010 is the segment and 2233 is the offset a 3000:F2F2 where 3000is the…
Q: d) Consider a 15bit address in high-order interleaving, determine the bank and offset value from the…
A:
Q: Q1: Select any value for AX register b15 b14 bl3 b12 bl1 b10 b9 b8 b7 b6 b5 b4 b3 b2 bl b0 X X X X X…
A: Actually, AX,BX,CX,and DX are the general purpose registers.
Q: Q. A straight binary sequence is applied to a 4-bit DAC, and the output in figure below is observed.…
A: According to the information given:- We have to define a straight binary sequence is applied to a…
Q: 0xC0D was found in a 12-bit register. What is the decimal number represented if it is interpreted…
A: unsigned binary number Unsigned binary integers are numbers that do not have a plus or minus sign.…
Q: Question 22 Choose the 8088 signals that are used to generate ROMRD. ALE RD 1O/M IORD WR
A: Actually,RD is read WR is write.
Q: the register AL with bit3 of AL If bit3 of AH is 0 then AL must be 00H If bit3=1 of AH then AL must…
A: Registers are a type of computer memory used to quickly accept, store, and transfer data and…
Q: A number Nis stored in a 4-bit 2's complement representation as a3 a2 a a it is copied into a 6-bit…
A: The answer is given below:-
Q: Suppose we want an error-correcting code that will allow all single-bit errors to be corrected for…
A: a. The number of parity bits: The length of the memory word is 12. The number of parity bits for…
Q: 8. Write MIPS code that prints "The bit is 0" when bit 15 in$t0 is 0 and prints "The bit is 1" when…
A: MIPS program :) .data # data section output: .asciiz "The bit is " # declaring string to print…
Q: 3 A channel transmits only frequencies between 4 MHz and 6 MHz with a signal- to noise ratio of 25…
A:
Q: A bit stream "1101011011" is being given as an input to a CRC chip having a 14-bit encoder. The…
A:
Q: If the bit pattern in Register0 is 3A and the bit pattern in Register1 is 9F, what would be the bit…
A: If the bit pattern in Register0 is 3A and the bit pattern in Registerl is 9F, whatwould be the bit…
Q: Assume that IEEE 754 floating point format is used and $f1 and $f2 store the floating numbers as…
A: converting given IEE 745 into floating point number . And adding them .
Q: ind the 32-bit representation for the following command, and then discuss which bits of this 32 bits…
A: Solution: The instruction is add r5,r6,#11. The first three bits are Condition bits, Operation Code…
Q: Q1: Select any value for AX register b15 b14 bl3 b12 bl1 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0 X X X X…
A: Actually, AX,BX,CX,DX are the general purpose registers.
Q: Question 1 A digital system uses 8-bit for integer representation and 16-bit for floating point…
A: Given that, digital system uses 8-bit integer representation and 16-bit floating point number…
Q: Draw a block schematic arrangement of a Six bit binary adder.
A: The block schematic arrangement is a 6 bit binary adder is given below:
Q: A bit stream “1101011011" is being given as an input to a CRC chip having a 14-bit encoder. The…
A: The answer is..
Q: 3. Write an ALP to divide signed 8 bit by 8 bit number.
A: The solution to the given question is: Program: LXI H, 4150 MOV…
Q: XOR BX,1800H a. Clears bits 11 and 12 b. Set bits 11 and 12 c. Invert bits 11 and 12
A: XORing instruction is use of set values to 0 to registers. XOR BX, 1800H means,. IT will reset the…
Q: Using MSI (i.e. functional blocks), show how can you design a circuit that has two n-bit unsigned…
A: The Code for the given question is in step-2.
Step by step
Solved in 3 steps
- Data represented in ________ is transmitted accurately between computer equipment from different manufacturers if each computer’s CPU represents real numbers by using an IEEE standard notation.If 2 bits of a byte are in error when the byte is read from ECC memory, can ECC detect the error? Can it fix the error?A(n) __________ is an integer stored in double the normal number of bit positions.
- In ___________ there is always a transition at the middle of the bit, but the bit values are determined at the beginning of the bit. If the next bit is 0, there is a transition; if the next bit is 1, there is none.Assume that IEEE 754 floating point format is used and $f1 and $f2 store the floating numbers as below: $f1: 1000 1010 0110 1110 1001 1000 0000 0000 $f2: 1000 1010 0100 1111 0100 0010 0000 0000 What are the values of each register? What is the result computing for ($f1+$f2)271. In Return to Zero (RZ), the signal changes not between bits but a. before the bit b. after the bit c. doesn d. during the bit
- Represent -53.625 using 32-bit IEEE-754 floating point standard. Indicate Sign bit (1 bit), Biased Exponent bits (8 bits), and Fractional bits (23 bits). For the fractional bits, indicate just the first 9 bits out of 23. For example for 228 (slide 55 of chapter 5) your answer for the fractional bits would be 110010000. sign bit --> biased exponent --> first 9 fractional bits -->Character P is encoded as 1010000 in a computer. Usually, a parity bit will be sent together with a character. What is the odd parity bit for character P?Convert -0.6 to a 16 bit floating point number.(Sign:1-bit Exp:5-bit Mant:10-bit excess-15)Convert -0.6 to a 16 bit floating number. Express your answer as hexadecimal.(Sign:1-bit Exp:5-bit Mant:10-bit excess-15)
- Representing 7 bit floating -point Given that the: Sign: 1 bit (MSB)•Exponent: 3 bits•Mantissa: 3 bits (LSB) State/provide the representation in 1s and 0s of the value indicated for each of the following subquestions. Make certain you include all of the bits required for a complete 7-bit representation. Please show all the steps a- 5.2510 B: -2.7510Are you able to differentiate between the least significant bit and the most significant bit in a given set of data?LIST P = 16F877AUsing INCLUDE "P16F877A.INC" and PWM (Pulse Width Modulation), write the microprocessor code that enables the fan to operate at 80% if the button on the 5th bit is pressed, and 30% if the button on the third bit is pressed.