Answered: 1- For the soil packing shown in the…

1- For the soil packing shown in the figure below, find the void ration of this soil Sphere Sphere Sphere Sphere 2- Discuss why illite clay is more stable than montmorillonite clay. 00

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter3: Weight–volume Relationships

Section: Chapter Questions

Problem 3.18P

See similar textbooks

Related questions

Q: Table Q2(b)(i): Result of bulk density and water content from proctor compaction test Bulk density…

Q: Calculate the dry unit weight, the saturated unit weight and the buoyant unit weight of a soil…

A: Given: Void ratio Specific gravity Degree of saturation To find: Dry unit weight Saturated unit…

Q: Q14) A moist soil sample has its weight (8.5 N) and its dry weight is (7.7 N). The relative density…

Q: In its natural condition, a soil sample has a mass of x kg and a volume of 0.001 m³. After being…

Q: A saturated soil has the following characteristics: Initial mass = 40.91 grams Final mass = 28.79…

Q: sample. The hydraulic cConductivities of the soils in the direction of flow through them are as…

A: Darcy's law is an equation that describes the flow of a fluid through a porous medium. V = K i…

Q: In its natural condition, a soil sample has a mass of 1.980 Kg and a volume of 0.001 m³. After being…

A: Soil mass = 1.980kg Volume of soil mass = 0.001m3 Bulk density of soil = weight / volume = 1.980…

Q: shown in the figure. The coefficient of permeability of the Water is flowing through the…

Q: Calculate the grams of silt in the following sample: 40 second reading: 27 grams 8 hour reading: 23…

Q: For a decreasing load permeability test, the following are given values: - Sample length: 200 mm -…

A: For falling head permeability test= kT = 2.303 x [aL/A(tf – ti)] x log10 (h1/h2) where A and a=…

Q: 3. The mass of a wet sample of soil and its container is 0.33 kg. The dry mass of the soil and its…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: A cube of dried clay having sides 4 cm long has a mass of 110 gms. The same cube of soil, when…

A: Given data, Volume of the soil = 4³= 64m³ Mass of solids Ms = 110g Saturated mass of soil = 135gm…

Q: A wet sand sample has a volume of 4.64 x 10-4 m3 and weighs 8 N. After oven-drying, the weight…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Water flows through a sand filter as shown on the figure. The soil has a cross sectional area of…

Q: A soil sample has the following properties: porosity 0.398, specific gravity = 2.75. Find: a)Void…

A: Since you have posted multiple questions ,will provide solution for only the first question. Kindly…

Q: A mass of 230 cm3 of moist clay soil tested in the laboratory is 400 g. The soil was then oven dried…

A: Given Data Total weight of soil (WT ) = 400g Weight of dry soil (Wd) = 350g Total volume of soil…

Q: A 4.576 Kg of a soil with o = 20% & G,=2.68 were extracted from a hole at the surface of the soil…

Q: Use the basic relationships of phase diagram representation of soil bulk to determine the wet…

Q: The maximum attainable dry unit weight of the soil 21 kN/cu. m and the minimum attainable dry unit…

Q: Mass of soil U.S. sieve no. retained on each sieve (g) 4 6 30.0 10 48.7 20 127.3 40 96.8 60 76.6 100…

Q: 4. A sample of soft saturated clay has a volume of 100 cu. cm. and weighs 175 grams. If drying the…

Q: A Cylindrical soil sample of 7.5 cm height and 3.75 cm diameter has been prepared at the shrinkage…

Q: 2. The field unit weight of the soil sample 1s 1960 kg/m³ and the unit weight of the soil particle…

A: Given data - Field unit weight = 1960 kg/m³ Particle Unit weight = 2700 kg/m³ emax =0.69 emin=…

Q: Standard Proctor test was conducted on a silty clay soil collected from a proposed construction…

A: As per our guidelines we are supposed to answer only first three subparts. So kindly please repost…

Q: EX.1 The mass of moist soil sample collected from the field is 465gm, and its oven dry mass is…

A: Given data Mass of moist soil Mass of dry soil. Specific gravity Void ratio

Q: For a moist soil, given that Volume = 5660 cm3; Mass = 10.4 kg; Moisture content = 10%: Gs = 2.7.…

Q: The soil layer under a dam is made up of 4 layers with the following properties. Thickness K (m)…

Q: The Void Ratio of a soil sample is 0.54 and the specific gravity of its particles is 2.69. Calculate…

Q: For a soil if Poisson's ratioµ = 0.333, the coefficient of earth pressure at rest will be (a) 0.5…

A: Given data : Poisson's ratio (μ)=0.333

Q: The given values are as follows: The specimen's e=0.46 length of soil specimen=450mm constant…

A: The given data is: Void ratio of specimen (e) = 0.46 Length of soil specimen (L) = 450 mm = 0.45 m…

Q: The moist density of a soil sample is 1679 kg/m, its specific gravity is 2.77, and its void ratio…

Q: The dry density of a soil sample is (1750 kg/m' ). where G, -2.66, what is the moisture content of…

Q: A cubic meter of soil in its natural state weighs 17.75 KN. After being dried, its weight is 15.08…

A: We knowWd=Ww1+w

Q: In a saturated soil mass, if Gs=2.75, water content 60% the void ratio will be? a. 0.62 b.…

A: Given data in question Specific gravity Water content Saturated soil mass To find out Void ratio…

Q: 1. The mass of a wet sample of soil and its container is 0.33 kg. The dry mass of the soil and its…

A: The given data is: Mass of the container=0.06 kg Mass of soil and the container=0.33 kg Dry mass of…

Q: A saturated soil has the following characteristics: Initial mass = 40.01 grams Final mass = 28.32…

Q: The moist density of a soil sample is 1750 kg/m, its moisture content is 23%, and its specific…

A: Given: The moist density of the soil sample is 1750 kg/m3. The moisture content is 23%. The specific…

Q: The following results were obtained from a standard compaction test on a soil: Mass (g) Water…

A: From Given Data Mass Water content Density Dry Density(γd) 2010 12.8 2.01 1.782 2092 14.5…

Q: A soil sample has the following properties: @ S= 50% its mass density (moist)= 1690 kg/ cu.m. @ S=…

A: We…

Q: (d) The weight of water required to saturate 1m3 of this soil. I only need the last question…

Q: A balloon-type apparatus is used to perform a field density test. The volume of the test hole…

Q: The data from standard and modified proctor test on a soil sample (density of solids: 2680 kg/m3 )…

A: The compaction of the soil is generally removing the air void in the soil and makes the soil dense.…

Q: EX.1 The mass of moist soil sample collected from the field is 465gm, and its over mass is 405.76…

Q: A cubic meter of soil in its natural state weighs 17.5 kN. After oven-drying, the soil weighs 14.2…

Q: In its natural condition, a soil sample has kg and a volume of 0.001 m³. After being completely…

Q: PROBLEM 2: A 50 cu.cm sample of moist clay was obtained by pressing a sharpened hollow cylinder into…

A: Given data- Total Volume of the soil-VT=50 cm3Initial weight of the soil-Wbulk=85 gmDry weight of…

Q: kage limil test Initial volume of soil in saturated state 25.7 cm3 Final volume of soil in dry state…

Q: The following observations are taken in the laboratory for determining the water content of a clay…

A: Note- Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: Sample Size - 3.81 cm diameter, 7.62 cm high. Wet weight -1.668 N Oven-dry weight - 1.400 N Specific…

Q: The porosity (n) of a mass of soil is 46.69 % What is the void ratio, e, expressed as a percentage?…

Concept explainers

Asphalt Binders and Mixtures

Asphalt binders are subsidiary products procured during the refining process of petroleum while manufacturing gasoline, diesel, and similar petroleum products. Asphalt binders are obtained from the residue that remains after the distillation of petroleum, this residue is further subjected to steam distillation and oxidation to remove the traces of gas oil present in the residue. Certain additives or modifiers are also added to asphalt binders to alter them to suit different applications.

Question

i need the answer quickly

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Results from a liquid limit test conducted on a soil are given below. a. Determine the liquid limit of the soil. b. If it is known that the PI = 6.5, what would be the plastic limit of the soil? c. Determine the liquidity index of the soil if win situ = 23.8%
A specimen of clay has a water content of 82% and a saturation of 95%. The specific gravity of solids is 2.76. What is the void ratio of this soil? What is the moist density of this soil in kg/m3? Round the answers to five significant figures. Include phase diagram(s).
The saturated clay sample was weighed in a container and the total weight was 7.4 N. 24 hours 105 degreesAfter waiting in the oven, the container was weighed again, this time it was measured as 5.6 N. The weight of the container is given as 0.7 N. Given the specific gravity of 2.66 for the soil, a) water content b) void ratio c) porosity d) density and e)Calculate the unit weight.
A natural deposit of soil was found to have a water content of 27% and to be 88% saturated. Gs=2.7.Calculate (a) the void ratio, e; (b) the porosity, n; and (c) the dry density, ρd. (use kg/m^3 for density units). Include phase diagrams.
The weight of a cylindrical clay soil sample with a diameter of 39mm and a height of 78mm was 203.6gr.have been weighed. Its weight after being thrown in the oven was determined as 165.2gr. Specific gravity of this soil Gs= 2.69If (Gs=γs/γw), then the ground in this case;a) Natural unit weightb) Water contentc) Dry unit volume weightd) vacancy ratee) Calculate the percentage of saturation? (unit volume weight of water is 1.0 gr/cm3will be taken.)
A soil specimen has a total volume of 70 cm3 and a total mass of 135.5g. After complete drying in an oven, the specimen has a mass of 122.0g. The Gs is 2.60. Determine the void ratio. Report your answer to three significant figures, and draw the full phase diagram.
A saturated soil sample (S=100%) contains 28 g of soil solids and 22 g of water. The void ratio is 2.2. Calculate the following Water content (w), = porosity (n) = total (wet) density (ρT) = ____ g/cm3 dry density (ρd ) = ______ g/cm3 total unit weight (γT ) = ______ kN/m3 and specific gravity (Gs) of the soil solids = Adjust your answer to TWO decimal places. Provide step by step solution.
The moist unit weight of a soil is 17.79 kN/cu.m and the porosity is 0.416. If the specific gravity of the soil solids is 2.671, calculate the following: a. Dry unit weightin kN/cu.m. b. Void ratio
Calculate the dry unit weight, the saturated unit weight and the buoyant unit weight of a soil having a void ratio of 0.70 and a value of Gs = 2.72. Calculate also the unit weight and water content at a degree of saturation of 75%.
A sample of saturated clay was placed in a container and weighed. The weight was 6N. The clay in its container was placed in an oven for 24 hours at 105˚C. The weight reduced to a constant value of 5N. The weight of the container is 1N. If Gs = 2.7, determine: a) Water Content b) Void Ratio c) Bulk Unit Weight d) Dry Unit Weight e) Effective Unit Weight
1. A sample of saturated clay was placed in a container and weighed. The weight was 6 N. The clay withcontainer was oven dried for 24 hours at 105C and weighed again as 5N. if the weight of the containeris 1 N, and specific gravity of soil solids is 2.70, determine the a) water content b) void ratio c) bulk unitweight d) dry unit weight, e) saturated unit weight f) submerged unit weight. This is the question of Soil Mechanics.
If Dynamic viscosity = 0.0008 kg/m sec; gravitational acceleration g (9.81 m/sec2), average particledensity = 2650 kg/m3), and water density at 25 oC = 997kg/m3). Now Using Stokes's law and the Canadian system of soil classification, calculate the time needed forthe soil separates up to clay mineral particles of size 0.0001 mm to settle out of a depth of 0.2 min an aqueous suspension at 25 oC. What will be the effect of particle size ranges on settling time. Discuss a bit.