Answered: 1, Please write down the rated voltage…

1, Please write down the rated voltage of the generator and the transformation ratio of each transformer. 220kV 110kV он T-1 T-2 T-4 35kV 10kV 110kV T-3 10kV

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.32P: Determine the positive- and negative-sequence phase shifts for the three- phase transformers shown...

See similar textbooks

Related questions

Q: The net cross section of a transformer is 20 square inches. The maximum flux density is 11…

A: Given: N=1000Bm=11 kiloguassBm=11×103×10-4 Wb/m2Bm=1.1 Wb/m2A=20 square inchA=20×2.54×10-22…

Q: Q1- the primary voltage of transformer is 6600 V and the turn ratio equal 10.6. If the primary and…

Q: A single-phase, 2200/200 V transformer takes 1A at the H.V side on no load at a power factor of…

A: Given data – VHV = 2200 V, VLV = 200 V, IHV = 1 A , cosø = 0.85 Total power loss is equal to iron…

Q: (c) A 500 kVA, 11000 V/400 V, 50 Hz, single phase transformer has 100 turns on the secondary…

Q: A 1 kVA ideal transformer has 240 turns on the primary and 80 turns or secondary winding. The…

Q: 23. The secondary windings of a 60 Hz transformer has 50 tums. If the induced voltage of this…

Q: Among the drawings of the magnetic circuits of 3-phase and 1-phase transformers, indicate the…

Q: A three-phase transformer has 420 turns on the primary and 36 turns on the secondary winding. The…

Q: Transformer 1 80KVA 2,300:230 v Ze"=0.0113+j0.0207 ohm Transformer 2 50 KVA 2,300:230 v.…

A: GivenTransformer 180 kVA2300V:230VZe''=0.0113+j0.0207 ΩTransformer 250 kVA2300:230…

Q: 2) A 500-kVA, 3-phase, 50-Hz transformer has a voltage ratio (line voltages) of 33/11 kV and is…

A: Given, A 500 kVA , 3-ph , delta-star transformer has, Voltage ratio (line voltage) of 33/11 kV. For…

Q: emf induced in the secondary winding of a 50-Hz single-phase transformer having 100 turns on its…

A: We need to find out cross section area for given voltage .

Q: In a single phase transformer, if the average value of emf is 231 V, then RMS value is_ 256.41…

A: We need to find RMS value for given average value.

Q: A 3-phase 100OKVA, 11000/416 transformer is delta-connected on the primary and star connected on the…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Determine the ratio of the kW output of transformer A to the kW output of transformer B. Both…

Q: A 3-phase 10OOKVA, 11000/416 transformer is delta-connected on the primary and star connected on the…

A: TRANSFORMER: The transformer transfers power from one circuit to another circuit without a change…

Q: In a single phase 230/110 V transformer the gross sectional area of the core is 44.4 cm². If the…

A: Given area of the core is 44.4 cm² maximum flux density of the core is 1.2 Wb/m² Transformer…

Q: condary voltage and the output and power factor of each transformer. Test data Open circuit:…

A: Given:- 2 , 1 phase transformer, Load: 750A, cosϕ=0.8 lag O.C.= 1100/13300 V S.C. = H.V. winding…

Q: The number of turns on the primary and secondary windings of a 1-o transformer are 399 and 40…

Q: The net cross section of a transformer is 20 square inches. The maximum flux density is 1.1…

Q: 1. A 40 kVA, 3300/240, 50 Hz single phase transformer has 660 turns on the primary, Determine: i.…

A: Given values, Single phase transformer having kVA rating is 40 kVA Primary voltage, V1= 3300 V…

Q: Q 1/ A 50 kVA, 2000 V/100 V, 60 Hz single-phase transformer has 50 secondary turns. Determine: (a)…

A: Given, A 50 kVA, 2000V/100V, 60 Hz single phase transformer has 50 secondary turns, Transformer…

Q: DISCUSSION: 1- Draw the N.L chara and external chara. Of series generator, draw the different…

Q: The number of turns on the primary and secondary windings of a 1-p transformer are 415 and 38…

Q: 3. A 100 KVA, 4000V / 200V, 50 Hz single phase transformer has 100 secondary turns. Determine (a)…

A: Given: Single phase transformer with S=100 kVAV1V2=4000200f=50 HzN2=100 turns

Q: A transformer has 500 primary turns and 3000 secondary tur is 230V, then the secondary voltage is 1…

A: Given Transformer with The number of primary turns N1=500 The number of secondary turnsN2=3000The…

Q: A single phase transformer is rat 2,424 V / 206 V. 60 Hz The eau

Q: The following information is given to two transformers connected in parallel: Transformer 1: 75 Kva…

A: In this question, We need to load sharing by the transformer 1 if. Total sharing of load is 125KVA…

Q: Problem #1: A single-phase transformer has 300 primary turns and 750 secondary turns. The net cross…

Q: A 250 kVA, 11000 V / 400 V and 50 Hz single- phase transformer has 80 turns on the secondary, what…

A: we need to find out maximum value of flux.

Q: 2- Determine the number of turns per-phase in each winding of a 3-phase transformer with a ratio of…

Q: A 100-kva 2,400/240-volt 60 cycle transformer has the following constants: Rp = 0.42; Xp = 0.72; Rs…

Q: 1. A 40 kVA, 3300/240, 50 Hz single phase transformer has 660 turns on the primary, Determine: i.…

A: Given data Rating of transformer = 40 KVA Primary voltage V1=3300 V Secondary Voltage V2=240 V…

Q: A single phase 9.6 kVA, 500 V / 1.5 kV transformer has an impedance of 1.302 Ω with respect to…

A: GivenKVA of the transformer =9.6 KVA=0.0096 MVAPrimary side voltage=500 v=0.5 Kvsecondary side…

Q: A 100 KVA, 4000V / 200V, 50 Hz single phase transformer has 100 secondary turns. Determine (a) the…

A: The primary winding parameters of the transformer are: S1=100 KVAV1=4000 VN1=?f=50 Hz The secondary…

Q: a power transformer at a receiving substation has the following information on its same plate.…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: 1. A 100 kVA, 3300/400 V, 50 Hz single phase transformer has 110 turns on the secondary. Determine:…

A: 1. The number of turns on the primary

Q: 2- Determine the number of turns per-phase in each winding of a 3-phase transformer with a ratio of…

Q: Two transformers are to be operated in parallel such that they share load in proportion to their kVA…

A: Given that two transformers are connected in parallel. Given values are -…

Q: 6. Three transformers coonected on the Y primary and delta on the secondary side, step the voltage…

A: The ratio of transformation: This is opposite to the turn ratio. It is the ratio of the secondary…

Q: single-phase transformer

Q: Which of the following has a characteristic to operate in high voltages and can be transmitted over…

A: In this question we need to choose a correct option.

Q: A 100 kVA, 4000 V/200 V, 50 Hz single- phase transformer has 100 secondary turns. Determine (a) the…

Q: A 100-kva 2,400/240-volt 60 cycle transformer has the following constants: Rp = 0.42; Xp = 0.72; Rs…

A: Primary referred secondary resistance = secondary resistance×Primary voltage secondary voltage2.…

Q: a 50kVa, 11.5kV/2.3kV, two-widing transformer is to be connected as an autotransformer having an…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 2. The primary and secondary windings of a 500 kVA, 6600/400 V transformer have resistances of 0-420…

A: As per the guidelines of Bartley we supposed to answer first question only for solution of remaining…

Q: PROBLEM A transformer has 600 primary turns connected to a 1.5 kV supply. Determine the number of…

Q: A 250 kVA, 11 000 V/400 V, 50 Hz single-phase transformer has 80 turns on the secondary. Calculate:…

A: The apparent power of the transformer is known. Also, the transformation ratio, i.e. voltage across…

Q: In a single phase transformer, if the average value of emf is 231 V, then RMS value is O 115.50 O…

A: First we will find out the peak value from given average value,then we will find out the RMS value…

Q: 1. A three-phase transformer , has 420 turns on the primary and 36 turns on the secondary winding.…

Question

1, Please write down the rated voltage of the generator and the
transformation ratio of each transformer.
220kV
110kV
он
T-1
T-2
T-4
35kV
10kV
110kV
T-3
10kV

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 7 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

In order to avoid difficulties with third-harmonic exciting current, which three-phase transformer connection is seldom used for step-up transformers between a generator and a transmission line in power systems. (a) Y- (b) -Y (c) Y-Y
For an ideal transformer, the efficiency is (a) 0 (b) 100 (c) 50
Determine the positive- and negative-sequence phase shifts for the three- phase transformers shown in Figure 3.36.
An infinite bus, which is a constant voltage source, is connected to the primary of the three-winding transformer of Problem 3.53. A 7.5-MVA,13.2-kV synchronous motor with a sub transient reactance of 0.2 per unit is connected to the transformer secondary. A5-MW,2.3-kV three-phase resistive load is connected to the tertiary Choosing a base of 66 kV and 15 MVA in the primary, draw the impedance diagram of the system showing per-unit impedances. Neglect transformer exciting current, phase shifts, and all resistances except the resistive load.
A single-phase l0-kVA,2300/230-volt,60-Hz two-winding distribution transformer is connected as an autotransformer to step up the voltage from 2300 to 2530 volts (a) Draw a schematic diagram of this arrangement, showing all voltages and currents when delivering full load at rated voltage. (b) Find the permissible kVA rating of the autotransformer if the winding currents and voltages are not to exceed the rated values as a two-winding transformer. How much of this kVA rating is transformed by magnetic induction? (C) The following data are obtained from tests carried out on the transformer when it is connected as a two-winding transformer: Open-circuit test with the low-voltage terminals excited: Applied voltage =230V, input current =0.45A, input power =70W. Short-circuit test with the high-voltage terminals excited: Applied voltage =120, input current =4.5A, input power =240W. Based on the data, compute the efficiency of the autotransformer corresponding to full load, rated voltage, and 0.8 power factor lagging. Comment on why the efficiency is higher as an autotransformer than as a two-winding transformer.
Rework Problem 3.14 if the transformer is delivering rated load at rated secondary voltage and at (a) unity power factor, (b) 0.8 power factor leading. Compare the results with those of Problem 3.14. -
The ratings of a three-phase three-winding transformer are Primary(1): Y connected 66kV,15MVA Secondary (2): Y connected, 13.2kV,10MVA Tertiary (3): A connected, 2.3kV,5MVA Neglecting winding resistances and exciting current, the per-unit leakage reactances are X12=0.08 on a 15-MVA,66-kV base X13=0.10 on a 15-MVA,66-kV base X23=0.09 on a 10-MVA,13.2-kV base (a) Determine the per-unit reactances X1,X2,X3 of the equivalent circuit on a 15-MVA,66-kV base at the primary terminals. (b) Purely resistive loads of 7.5 MW at 13.2 kV and 5 MW at 2.3kV are connected to the secondary and tertiary sides of the transformer, respectively. Draw the per- unit impedance diagram, showing the per-unit impedances on a 15-MVA,66-kV base at the primary terminals.
Using the transformer ratings as base quantities. work Problem 3.14 in per-unit.
For a short-circuit test on a 2-winding transformer, with one winding shorted, can you apply the rated voltage on the other winding? (a) Yes (b) No
22/. Draw the configuration of the following three phase transformers. i) Delta-Star transformer ii) Star-Star transformer
A load impedance of 52 ohms is connected to the secondary winding of the transformer with 208 volts. How much current will flow in the secondary
4. A 220-kVA transformer with .2% resistance and 4% reactance and another 120-kVA transformer with 3% reactance and .15% resistance with the same voltage ratio. the phase angle is 33 degree and the total load .245 MVA. How much the load of each transformer.