Answered: 1. (64° 49' 13" to decinal degree 2.…

Engineering

Civil Engineering

1. (64° 49' 13" to decinal degree 2. 87.375° to DMS to decinal degrees to DMS 3. 19° 12' 18" 4 220.43°

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Three lines have the following north azimuths: AB 114o36’, CD 254o45’, and EF 302o14’. What are the…

Q: Question 6. Design a trapezoidal channel to carry a discharge of 980 cfs. The channel laid on a…

A: Given data Discharge Bed slope Side slope Mannings roughness coefficient Angle of slope Gravel

Q: determine the difference of elevation of points A and B

A: C value is not given. so I assumed C as 0.381. So there must be variation in the answer option…

Q: Four hills A, B, C, and D are in a straight line. The elevations are 247.58m 236.33m, 314.31m, and…

Q: The center height of the road @ STA 7+110 is 2.0 m while @ STA 7+160, it is 1.20 m cut. From STA…

A: Given: The center height of the road at STA 7+110 is 2 m. The cut of the road at STA 7+160 is 1.2 m.…

Q: Compute the elevation of reservoir C. CHOICES: a.835.06, b. 538.06, c. 853.60, d. 583.60

A: This is a junction flow problem which can be solved by using bernouli's theorem between surface of…

Q: the slope distance 587.447 m and altitude angle 16°26'35", the horizontal distance is

A: Given,slope distance=587.447m Slope angle=16°26'35" To find ,:- horizontal distance

Q: Water flows at a rate of 30m3/s in the concrete channel shown. Find the required slope of the…

A: Given:- Water flows at a rate of 30m3/s in the concrete channel shown. Find the required slope of…

Q: If the elevation of A is 240.05m, determine the elevation of C.

A: The formula to calculate the height of the instrument L-1 is given by, HIL-1=Elevaion of A-BS of L-1…

Q: The true azimuth of a line measured from south is 154°30'. If the magnetic declination within the…

Q: ?What is the elevation of point BM1 in the below table if you know that the elevation of BM2 is…

Q: Four hills A, B, C and D are in straight line. The elevations are A = 247 m., B = 236 m., C = 314…

A: Given: Elevation of A = A = 247 m. Elevation of B = 236 m Elevation of C = 314 m Elevation of D =…

Q: The angle of side slope for this channel is 6.73 m y=1.5 m a 5 m 51° .a O 60° .b O 32° .C O 45° .d O

Q: 1. Four hills A, B, C and D are in straight line. The elevations are A = 247 m., B = 236 m., C = 314…

A: Consider the hills A, C, and D only. Let the height of towers at A and D as x. The elevation of the…

Q: A storm drainage canal drains water (S = 1.0) out into the sea (S=D1.03).

A: Draw the free body diagram as below. Consider the left hand side portion Determine the…

Q: 20 kN/m 30 kN/m 10 m 5 m 10 m FIG. P5.61

Q: From the given profile leveling notes: What is the difference in elevation between station 5 and 2?

A: The leveling is used to calculate the elevation of the point which two far from the station or point…

Q: Convert the following bearings to equivalent azimuths AB, N 25°25’ W BC, Due East

A: 1. AB : N 25°25' W = 360°-25°25'= 334°35'

Q: An open channel is to be designed to carry 1 m3/s at a slope of 0.0065. The channel material has n =…

Q: What is the azimuth south of a traverse that has a latitude of (+) 1750.15m and departure of…

Q: -) WATER IS FLOWING IN A TRAPE010 CHANNEL WITH A SIDE SLOPES EQUAL TO 2H :sV AND A 13 ft BOTTOM…

A: Trapezoidal Channel is an open channel with a trapezoidal cross section where both sides have the…

Q: Q3/ Find bed width (B) and depth of flow (y) of a rectangular open channel, if Q = 150 (m/s), S. =…

A: Given Q = 150 (m3/s), S = 0.0001, n = 0.017 (m 13/s) B = 20y

Q: Water flows in a trapezoidal channel with side slope 1V:3H, bottom width of 16ft and water depth of…

A: Area of the channelA=zy2+by=3(4.5)2+16×4.5A=132.75ft2Perimeter:P=B+2y1+z2P=16+2(4.5)1+32P=44.4605ft

Q: B 60 kN/m

A: Given:- To find:- Shear force and bending moment diagram Absolute maximum shear force and bending…

Q: An open channel is to be designed to carry 1.5 m3/s at a slope of 0.007. The channel material has an…

A: solution Given discharge Q = 1.5m3/secslope S =0.007n=0.012 for the most efficient rectangular…

Q: Building's basement elevation is 379.1 m. The stub-out connection elevation is 370.8 m „lf the…

A: Given that: Elevation of basement elevation=379.1 mElevation of Stub-out =…

Q: A trapezoidal open-channel (n 1.5m when the slope is 0.002.

Q: Determine the sight distance of a vertical parabolic sag curve 225m long and connecting a -2 grade…

A: Given, Length of curve (L) = 225 m Grade, G1 = -2% Grade, G2 = 3%

Q: An open channel with n=0.011 is tc slope of 0.0065. Find the most effic a. A rectangular b. A…

Q: A turning point has an elevation of 65.15 m. and the foresight taken on that point is 0.30m. If the…

Q: Determine the elevation of station BM1 using c = 0.14 and k

Q: Plot the following ground obstructions on an obstruction diagram.From an azimuth of 65° to 73° there…

A: Given:- A ground obstruction is given An azimuth of the ground obstruction = 65° to 73° The…

Q: Ship A is 11.3 nautical miles north of Ship B and bears 280°30'T from ship C. Ship B on the other…

Q: DIFFERENTIAL LEVELING For the given differential level notes. Determine the station with the highest…

A: Differential Levelling

Q: prove the formula of the combined correction for earths curvature and refraction Hcr = 0.0675 D^2…

Q: run from BM1 to BM2, which is 12 km long. Elevation of BM1 was found out to be 100 m and that of BM2…

A: Given:- line of levels long run=12km elevation of BM1=100m Elevation of BM2=125.382m Average…

Q: 2. Given the following differential level notes HI Elevation 100m Station BS FS BM-A 1.73 ТР-1 ТР-2…

A: Given:- Station BS HI FS Elevation BM-A 1.73 100 m TP-1 2.50 1.85 TP-2 2.76 1.05…

Q: Azimuth = 325° 51' 44" Bearing

Q: Q2: The level is setup at 20 m from point A and 200 m from point B. The staff reading at point A is…

A: The staff reading at point B will be taken as negative due to inverted staff.

Q: A rectangular channel with: n = 0.015, b=4 m, Q=5 m³/sec, So=0.0008. The water depth in the channel…

Q: An open channel is to be designed to carry 1 m3/s at a slope of 0.0065. The channel material has n =…

Q: water flows at 12m^/s in a concrete trapezoidal channel n=0.015 bottom width 4m side slopes 2H:1V…

A: solution discharge Q=12m3secwidth b=4mts and side slopes 2H:1Vcosnider at depth of yo=0.8mso the top…

Q: 115 kN, MD = 180 kN-M, LAB

Q: Determine the interior angles at each point of the following traverse: Line AB=N38009’ E, Line BC=S…

Q: The back staff reading on a B.M. of R.L. 1000.000 m is 1.663 m. If foresight reading on a point is…

Concept explainers

State Plane Coordinate Systems

The state plane coordinate system (SPCS or SPS) is a collection of 124 coordinate systems or geographic zones prepared for particular regions of the U.S. Every state consists of one or more than one state plane zone, the boundaries of which generally follow the county lines. Inside the U.S., there are 110 zones in total, 10 more zones in Alaska, 5 in Hawaii, and 1 for Puerto Rico and US Virgin islands. The system is extensively used for geospatial and geographic data assembling by the state and local governments.

Question

1. (64° 49' 13" to decinal degree
2. 87.375°
to DMS
to decinal degrees
to DMS
3. 19 ° 12' 18" to deciral degrecs
4 220.43°

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

0:£) B s, Mt B Traverse.. X o I onder 1o determine a tunnel between staton A and B where the vision was obstrucied between them, a traverse was slected o link between these stations, The field measurements of the raverseas in the table blow: - Line Length(m) | Azimuth DA 500 2000 be 00 oo ) 0o [oor AB ? ? Tength and the bearing of the tunnel (AB) and the angle BAD for stting it out
4) the angle of EOF if bearings of OE and OF are S15°04'E and S36°00'W 5) the angle of EPF if azimuth of PE from the North is 2019°02' and azimuth of PF feom the south is 154°16' 6) If azimuth from the north of line DE is 219°02' what is the azimuth of DE from the south?
HELP ASAP!!! P1: 280 N, P2: 590 N, x: 1.11 m, theta: 38 degrees
Determine the stationing of point B of a 6degree curve. The length of line 1A is 807.6ft and line AB is 645.3ft. The beginning station of the project is at Point 1 and is assigned as 10+00. Use Arc basis.
Three lines have the following north azimuths: AB 114o36’, CD 254o45’, and EF 302o14’. What are the bearings?
A line has a magnetic bearing of S41°30’E when the declination was 1°30’E. What is thetrue bearing of the line if a local attraction of 3°30’ to the east of the vicinity?
A1) Answer the following; a. From station 0+040 with a center height of 1.2m fill, the ground line makes a uniform slope of 6.5% to station 0 + 100, whose center height is 3.5m. Find the grade of the finished roadway. b. Station of P.T of a compound curve is at 15+480.14, l1= 30degrees, l2=36 degrees, D1= 4 degrees, and D2=5 degrees. what is the stationing of P.C.C? use arc basis.
Three independent lines oflevels are run from BM1 to BM2. Route A is 6km long, route B is 4 km long and route C is 8km long. By route A, BM2 is 82.27 m aboveBM1, by route B, BM2 is 82.40 m above BM1and by route C, BM2 is 82.10 m above BM1.1. Compute the probable elevation of BM2if the elevation of BM1 is 30.5 m. a. 113.13 m c. 113.45 m b. 112.79 m d. 113.06 m
Cathedral Hill is on a line between Constable Hill and Aurora Hill. Cathedral Hill is 6.235 km from the Constable Hill and Aurora Hill is 11.018 km from the Constable Hill. The elevation of the hills are: Constable Hill, 1260.86 m; Aurora Hill, 1266.44 m; and Cathedral Hill, 1261.04 m. Determine the height of tower to be constructed on Constable Hill so that the line of sight will clear the ground at Cathedral Hill by 5.0 m, if no tower is to be constructed on Aurora Hill
Answers a) 0.864 b) 18.76 kN/m3 c) 5.91 meters
0 a 2178 kN O b. 3726 kN 1| select one: WG o weiox92
Answers a) 0.436 b) 17.44 kPa c) 31.98 kPa d) 3.57 kN/m3