1. A 200-kg cylinder is hung by means of two cables AB and AC, which are attached to the top of a vertical wall. A horizontal force P perpendicular to the wall holds the cylinder in the position shown. Determine the magnitude of P and the tension in each cable. Create free-body diagram. B 12 m 8 m 10 m 1.2 m A 200kg 72m

1. A 200-kg cylinder is hung by means of two cables AB and AC, which are attached to the top of a vertical wall. A horizontal force P perpendicular to the wall holds the cylinder in the position shown. Determine the magnitude of P and the tension in each cable. Create free-body diagram. B 12 m 8 m 10 m 1.2 m A 200kg 72m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Let G = 100kg, calculate the unknown loads A and B in order for the whole mechanism to stay stationary
We have a table that we seek to lift with a pulley. The table is uniform, with a weight of 73 Newtons, it is suspended by means of a cable 2.7 meters long, which is attached to the sides of the table and passes through a small pulley located at O. Determine the tension of the cable if: d1=0.43 m d2= 1.14 m
A supporting rope is loaded with a line load q(x) = q0 between points A and B. The rope shall be stretched such that the slope of the rope at point A is zero. If l (small letter L) = 10 m and h = 2.3 m. Determine the (A) horizontal tensile force and (B) the maximum force in the rope. q0 = (kN/m) 12.213
Blocks B has a mass of 20 kg and block C has a mass of 15 kg. The coefficient of static friction at the contacting surfaces is 0.2. Block A is suspended by arope that passes over a fixed cylinder and is attached to block B. The coefficient of static friction between the rope and the cylinder is 0.25. What is the largest mass block A can have without causing block B to slip the left?
A cable is attached to a 2.20 kg block A, is looped over a fixed peg at C, and is attached to plate B.(Figure 1) The coefficient of static friction between the plate and the block is μA= 0.180, the coefficient of static friction between the plate and the inclined plane is μB = 0.380, and the coefficient of static friction between the cable and the peg is μC= 0.450. If the plane's angle is 30.0 degrees, what is the maximum mass that plate B can have such that it does not slide down the plane?
Please Quickk. In a high rise building, the elevator rises 366 m with an operating speed of 5 meters per second and reaches full speed in 10.68 m. The loaded elevator weighs 2000 kg. The acceleration of the elevator in m/s2 is 1.17. Determine the bending stress of wire rope with drum diameter of 7.8 inches and wire diameter of 0.0987 in. Answer 380 ksi
The man pulls on the rope at a constant rate of 0.5 m/s. Determine the angular velocity andangular acceleration of beam AB when Ɵ = 60°. The beam rotates about A. Neglect the thickness ofthe beam and the size of the pulley.
Determine the tension in the rope and the acceleration of each block. Answer: 32.7 N, 8.175 m/s^2
a) Determine the additional load (in kilograms) that can be supported by the bathy sphere so that the cylinder is fully submerged as shown. Assume density of sea water as 1024 kg/m^3. Neglect metal thickness and cable support
Very urgent. The box in the figure is connected by a cable from point A to point B. If the stress T in the cable is 5kN, calculate the Moment Mo of this force to point C. A(0,0,5m), B(2m,5m,0), C(4m,0,0)
The 100-mm-diameter pulley shown fits loosely on a 10-mm-diameter shaft for which the coefficient of static friction is Determine the minimum tension T in the belt needed to (a) raise the 100-kg block and (b) lower the block. Assume that no slipping occurs between the belt and pulley and neglect the weight of the pulley Choices: A. TMAX = 1075 N, TMIN = 906 N B. TMAX = 1075 N, TMIN = 690 N
A man weighing [(70*B)+(8*E)] N stands at the middle rung of a steel ladder uniformly weighing [15+(4*A)] kN/m. Assuming that the floor and wall are perfectly smooth and that slipping is prevented by cable CD, determine the following: A. Tension in the cable B. Reaction at A and B the values are A=3 B=9 C=1 D=3 e=1