1. A non-uniform is 4.5m long and weighs 640N. It is balance when a 270N weight is hung 0.800m from the light end of the bar and the bar is pivoted at its center. Where is the center of gravity of the bar?2.Two workers carry a non-uniform beam weighing 730N. The beam is 2.6m long and its center of gravity is 1.1 m from one end. If the workers hold the beam at its end, how much does each worker lift?

Answered: Image /qna-images/answer/53829a31-4a0b-40da-985c-147c7caefbd1.jpg

1. A non-uniform is 4.5m long and weighs 640N. It is balance when a 270N weight is hung 0.800m from the light end of the bar and the bar is pivoted at its center. Where is the center of gravity of the bar?

1. A non-uniform is 4.5m long and weighs 640N. It is balance when a 270N weight is hung 0.800m from the light end of the bar and the bar is pivoted at its center. Where is the center of gravity of the bar?

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.31P: The homogeneous plate of weight W is suspended from two cables. Determine the force P that is...

See similar textbooks

Related questions

Q: A non-uniform bar weighs 400N and is 4m long. When it is supported by a fulcrum at its midpoint, a…

A: Consider the free body diagram as shown below for the uniform bar.

Q: QUESTION 4 Determine the equivalent mass (meq) to be located at C for the transitional masses…

Q: A hydraulic crane of total mass (including the mass of the boom) 5300kg supports a load of 800kg.…

Q: Find the reactions at the supports for the beam that weighs 10 kN shown below. The length of the…

Q: A loaded scow has a draft of 1.8 meters in fresh water when erect. The scow is 6 meters wide and 12…

A: L=12meter W=6meter H=2.4 meter center of gravity =1.8 meter from the bottom

Q: Galaw-galaw. A post weighing 314. [N] and with height h has its lower end 0.214. The upper end is…

A: Given Data The weigth of the post is:W=mg=314N The coefficient of static friction is:μs=0.214 The…

Q: Problem 5 An ion-engine-propelled spacecraft has mass 1000 kg without propellant. Its propellant…

Q: The bar is 10m long. A mass of 40kg places at 9m from left end of bar. Where should a 60kg mass be…

A: length of the bar, L=10 mmass one, m1=40 kgmass second, m2=60 kg

Q: Problem 1 Given: Mass of canister: 4000 kg Mass of beam BD: 50 kg Max allowable force: 1. AB = 30 kN…

A: To find: The allowable acceleration of the system. Given: The mass of canister is M=4000 kg The mass…

Q: nonuniform bar 2 m long is horizontal and is in a state of equilibrium when supported at the center.…

Q: 3. The tasty fish pictured above has a mass of 1100 kg and is hanging from a cable attached via a 4…

A: Given data as per question Mass of fish = 1100 kg Length of cable = 4 m Weight of beam = 600 kg…

Q: An elastic string of natural length 4l and modulus of elasticity 4mg is stretched between two points…

Q: A wooden plank with a mass of 50.968 kg is supported by two cables at its ends. At what location…

Q: Question 11 of 14 A bucket crane consists of a uniform boom of mass M = 201 kg and length L = 59.33…

Q: Each member of the truss is a uniform 16-ft bar weighing 540 lb. Calculate the average axial force…

Q: A uniform sphere of weight W rests between a smooth vertical plane and a smooth plane inclined at…

A: Weight of an object is defined as mass times the acceleration due to gravity. The weight of the…

Q: Two weights are connectedby a very light, flexible cord that passesover an 80.0 N frictionless…

A: Given data: Radius of pulley (R) = 0.3 m Weight of block (W1) = 75 N Weight of block (W2) =125 N…

Q: Find the reactions at the supports for the beam that weighs 10 kN shown below. The length of the…

Q: A uniform beam that 10-m long is being supported by two men, one man at each end. The weight of the…

Q: Compute the forces in each member of the Warren Truss.' 2000 N 3000 N D 60 60 60 60 E A 10 m 10 m…

Q: a uniform ladder 8 meters long and weighing 350 N rest against a smooth vertical wall at an angle of…

A: Given: Length of the ladder is 8 m. Weight of the ladder is 350 N. Angle from the vertical wall is…

Q: A mobile crane has a 25 ft long boom (OA). The center of gravity (G1) of the boom is located at its…

A: Draw the F.B.D of the truck.

Q: A 6-m long ladder has a mass of 16 kg, and its center of gravity is 2.4 m from the bottom along the…

Q: A uniform beam ( weight 71 N, length 6m) is being supported by cable and a hinge on a wall. The…

Q: The rigid beam of negligible weight is supported by a pin at o and two vertical rods. Find the…

Q: 14. Find the distance x along AB, at which a horizontal force of 60N should be applied to hold the…

A: Given Data The horizontal force acting is: P=60 N The length of the bar AB is: AB =12 m The weight…

Q: A rectangular dam with base equivalent to 2.5-meters and height equivalent to 6-meters holds water…

A: Given: The dam width b = 2.5 m The dam height, h = 6 m The dam thickness, L = 1 m The unit weight of…

Q: A hydraulic crane of total mass (including the mass of the boom) 5300kg supports a load of 800kg.…

A: Draw the free-body diagram of crane and boom.

Q: Statical Stability. The scow shown in Fig. A above is 15 m long, 6 m wide, and 4 m deep. It has a…

Q: A truck bed cargo shell has a rectangular glass window that is held up by two strut pistons. Assume…

Q: Question 2. The system shown below is composed by a flexible cable, a bar and weight with mass…

Q: (12m) ladder weighs 200N and is ed against a smooth vertical wall its lower and (6m) from the wall

Q: A non-uniform bar rests across two supports that are 20 ft apart. When loads of 200 lb, 4 ft from…

Q: A 50-kg barrel hangs from one end of a 30-kg beam 3.0-m long. The distance from the loaded end of…

A: The free-body diagram of the beam is drawn below. Here, O denotes the balance point.

Q: 1. A circular opening 4 ft. in diameter is closed by a hemispherical shell weighing 2,800 lb. A.…

Q: A beam rests on a fulcrum, 1.2 m from one end. A weight of 350 kg is suspended from this end causing…

A: Solution: To find: The length (L) of the beam.

Q: A41 A uniform ladder which is 10m long and weighs 300N leans with its upper end againsta smooth…

A: length of a ladder = 10 m weight of ladder = 300 N bottom of the ladder from the base of the wall =…

Q: Draw the free-body diagram of the smooth uniform bar shown in Fig. 2. The bar has a mass of 20 kg.

A: Given data as per question Mass of bar=20×9.81=196.2 N considering FBD of the bar

Q: a garage door 20 ft long and 10 ft high weighs 90 lbs. the hinges are 2 ft from the upper and lower…

A: Given data: Weight of the door, W = 90 lb. As given that the upper hinge carries the entire weight…

Q: A hallow metal sphere with mass m = 355.0kg is held to the bottom of a water tank using an ideal

Q: 15. The force, P, to hold the 3-m wide gate (yes, the gate goes outside of the water) in the…

Q: (b) Figure Ql(b) shows two cylinders A and C were hanged together at both ends B and D. If the mass…

Q: A body consisting of a cone and hemisphere of radius (r) on the same base rests on a table, the…

A: Draw sketch for given condition for better understanding

Q: In the need for a standby electric power unit due to frequent power outages, a 500 kW diesel…

A: solution in uploaded attachment

Q: Q15/A uniform steel plate 360 mm square with a mass of 15 kg is suspended in the horizontal plane by…

A: Consider the diagram as shown below for the steel plate.

Q: Exercise Figure 2.11 shows a flatboat hull that, when fully loaded, weighs 150 kN. Parts (b)-(d)…

Question

2.Two workers carry a non-uniform beam weighing 730N. The beam is 2.6m long and its center of gravity is 1.1 m from one end. If the workers hold the beam at its end, how much does each worker lift?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A concrete seawater dam is shown in cross section. Is the dam safe against tipping about edge A? The mass densities are 24000kg/m3 for concrete and 1030kg/m3 for seawater.
The homogeneous plate of weight W is suspended from two cables. Determine the force P that is necessary to keep the plate in the position shown.
Two concrete blocks weighing 320 lb each form part of the retaining wall of a swimming pool. Will the blocks be in equilibrium when the pool is filled and the water exerts the line loading shown?
Draw the FBD for the bar described in Prob. 5.1 if the bar is homogeneous of mass 50 kg. Count the unknowns.
The thin-walled cylindrical can with a spherical dimple weighs 0.2 lb. Determine the force P required to push the can into water to a depth of 8 in. Use =0.036lb/in.3 for water.
The uniform ladder of weight W is raised slowly by applying a vertical force P to the rope at A. Show that P is independent of the angle .
The bar ABC is supported by three identical, ideal springs. Note that the springs are always vertical because the collars to which they are attached are free to slide on the horizontal rail. Find the angle at equilibrium if W = kL. Neglect the weight of the bar.
Find the magnitude of the pin reaction at B caused by the weight W=80lb. Neglect the weights of the members.
A uniform beam that 10-m long is being supported by two men, one man at each end. The weight of the beam. Is 100-N. If the first man supporting at the right side exert twice as much as the second man on the left, where must a 50-N motor be placed (measured from the first man) on top of the beam? Show complete solution.
A cylindrical buoy 1.8 m in diameter, 1.2 m high and weighing 10kN floatsin salt water of density 1025kg m−3. Its centre of gravity is 0.45 m from the bottom. Ifa load of 2 kN is placed on the top, find the maximum height of the centre of gravityof this load above the bottom if the buoy is to remain in stable equilibrium.
A non-uniform bar rests across two supports that are 20 ft apart. When loads of 200 lb, 4 ft from end A and 150 lb, 6 ft from end B, are on the bar, end A supports 233 lb and end B supports 197 lb. Find the weight of the bar and the position of the center of gravity.
Q.) A loaded scow has a draft of 1.8 meters in fresh water when erect. The scow is 6 meters wide and 12 meters long and 2.4 meters high. The center of gravity of cow is 1.8 meters above the bottom along the vertical axis of symmetry. What is the maximum single weight that can be moved transversely from the center of the scow and unloaded over the side without sinking the scow?SHOW ALL SOLUTIONS AND THE FIGURES THAT SUPPORTS THE SOLUTIONS