1. A steel rod (initial diameter: 3.2 mm, initial length: 42 mm) is extended by a uniaxial tensile load of 4800 N in 120 seconds. At this load, the length of the rod is measured as 49,2 mm. Calculate the followings: (a) Stress and strain occurred on the rod at this load. (b) Initial strain rate.
Q: .2 A narrow beam of singly charged ¹0B and ¹¹B ions a slit of width 1 mm into a uniform magnetic…
A:
Q: 1) Time-of-flight: Suppose that you have a time-of-flight mass spectrometer with a detector that can…
A: Given: The given details are, Suppose that you have a time-of-flight mass spectrometer with a…
Q: The potential energy function for either one of the two atoms in a diatomic molecule is often…
A: The spacing at which the potential energy has a local minimum must be ascertained.
Q: At the same constant acceleration, how many revolutions would it take the blade to come to rest from…
A: Given data : ∆θ = 4 revolution wf ( final angular velocity) = 0 Then At same constant of…
Q: The velocity of water at the outer edge of a 56 cm diameter whirlpool, where the water level is…
A: Given: The velocity of water at the outer age, V1=3 ms When the diameter of whirlpool, d1=56 cm For…
Q: A 21 kg box is being pushed across the floor by a constant force N. The coefficient of kinetic…
A: We have given Force F =( 106 i ) N Mass m = 21 kg μ= 0.12 t1= 8 s do = 17i+6j-6k t2 = 9.6 s…
Q: A galvanometer of resistanc'Y HIND AX gives full scale deflection with a current of 2 mA. How will…
A: We have to compute-Resistance required (R)=?The data given as-G=100 ohmIg=2 mA=2×10-3 AV=5 volts
Q: In a biprism experiment, red light of wavelength 6500 Å was used. It was then replaced by green…
A: We need to compue-Value of n=?The data given as-Wavelengthof red light λ1=6500 A0Wavelength of green…
Q: When a box is at rest on a level floor, forces are exerted between the atoms in the bottom surface…
A: Given: A box is resting on a level surface.
Q: 2. Calculate the circular rotation speed for a 20 solar mass point source (a black hole) and a 1,000…
A: Solution: The circular rotation speed for Plummer potential is given by the following relation:…
Q: Section B: Give the explanation of the Nouns. 1. electron effective mass 2. fermi energy 3.…
A: 1. The mass of an electron in the periodic potentials of a crystal is different from the free…
Q: Check Your Understanding Suppose you have a macroscopic salt crystal (that is, a crystal that is…
A: We must investigate if the geometric center of the macroscopic salt crystal is necessarily where the…
Q: Question 1 (a) A series RLC tuning circuit is excited at its resonant frequency of 50 MHz by 10V…
A:
Q: : A metal sphere has capacitance 3 x 109 F when surrounded by a medium of dielectric constant 3.…
A: We need to compute-Capacitance (C2)=?The data given as-Capacitance (C1)=3×10-9 FDielectric constant…
Q: An object is moving with ordinary speed 0.5c in S reference frame along a direction making an angle…
A:
Q: The force on a particle of mass 2.0 kg varies with position according to F(x) = -3.0x² (x in meters,…
A: The origin must serve as our point of reference when we calculate the particle's mechanical energy.
Q: You are pulling a 100-kg crate along the floor. The coefficient of static friction between the crate…
A: Solution:-Given thatmass of crate (m)=100 kgcoefficient of static friction (μs)=0.55coefficient of…
Q: Find E at (5, 0, 0) due to charge distribution labeled A in Figure 4.23. Using Coulombs Law PL=2…
A:
Q: 1. A cylindrical aluminum rod is positioned between two enclosed volumes, each con- taining a moles…
A: Given that: Length of the rod, L=24.0 cm=0.24 mArea of cross section, A=14.0 cm2=14.0×10-4…
Q: 1- A particle with mass m and with zero energy has a time independent wave function P(x) = Axe 1/²…
A:
Q: A spacecraft is in an orbit with a perigee height of 280 km, an apogee height of 400 km, and an…
A:
Q: 1. A frame ABC shown in Figure 2 consists of a tension member AB and a compression member BC. Member…
A: Given that Mdulus of elasticity,E=200 GPa=200×109Pa Horizontal force,H=150 kN=150×103N Length,L=3.5…
Q: Item 1 The electric field of an electromagnetic wave in a vacuum is Ey (21.0V/m)cos((2.78 × 108 )x -…
A: (1) Given that expression of electric field Ey=(21.0V/m)cos((2.78×108)x-ωt) The general expression…
Q: A uniformly charged sphere produces an intensity 100 V/m on its surface in a medium of dielectric…
A: We need to compute-Surface charge density (σ)=?The data given as-Electric intensity (E)=100…
Q: Ex. 13: A cube of side 5 cm each whose upper face is displaced by 0.65 cm due to a force of 0.25 N.…
A: We need to compute-(i) Shearing stress=?(ii) Shearing strain=?(iii) Modulus of rigidity=?The data…
Q: A sled of mass 70 kg starts from rest and slides down a 10° incline 80 m long. It then travels for…
A: The amount of net work generated by friction on the sled is 1900 J, which must be determined.
Q: Ex. 34: A galvanometer of resistance 100 gives full scale deflection with a current of 2 mA. How…
A: We have to compute-Resistance required (R)=?The data given as-G=100 ohmIg=2 mA=2×10-3 AV=5 volts
Q: Block 2 shown below slides along a frictionless table as block 1 falls. Both blocks are attached by…
A: Here we have to determine the speed of the block,. Given that the block has a mass of 2 kg, a weight…
Q: Suppose the initial velocities were not at right angles to each other. How would this change both…
A: In the event if the beginning velocities were not at right angles to one another, we must analyze…
Q: Calculate the cost of running the compressor for the pulse-jet baghouse, assuming that the ratio of…
A: Given that Q=24000 actm Ratio of pulse air to filtered air is 0.008, Compressor supplies air at…
Q: Two point charges, Q1=-25µC and Q2=+45μC are separated by a distance of 12 cm. The electric field at…
A: Electric field at a point r distance away is given by :- E=kQr2So given that at point P…
Q: A fluid (sp. gr. = 0.9, u= 1.2 Pa-s) flows in a laminar state between two stationary parallel plates…
A: Given: A fluid (sp. gr. = 0.9, μ= 1.2 Pa/s) flows in a laminar state. μ=1.2 Pas=1.2 N.sm2. Two…
Q: Explain how a synchrotron accelerates particles. W mechanism in these devices? How much more pow…
A:
Q: A box slides on a frictionless surface with a total energy of 50 J. It hits a spring and compresses…
A: We have to determine the energy lost when the box slides on the rough surface. We know, Total…
Q: (i) Marall. Boltzmann No Configuration 1 2. 3 4 S 6 7 8 9 1 2 3 + 5 6 2 () Fermi-Dirac & () Boson…
A:
Q: Consider the statement, "The temperature of a lost and whhat me gas is doubled." suust och showego…
A: Temperature is a physical quantity which is quantitative measure of hotness or coldness of any body.…
Q: charges are at res C at z = -1.58 m.
A: Given: Charges are given as, q1=-7.21 mC=-7.21×10-3Cq2=-1.79 mC=-1.79×10-3Cq3=5.76 mC=5.76×10-3C…
Q: A car starts from rest and with constant acceleration achieves a velocity of 30 m/s when it travels…
A: Given: Initial and final velocity of car is: u=0m/s v=30m/s Travelled distance is: s=350m
Q: Ex. 4: The velocity of light in air is 3 × 108 m/s. Find the frequency and wavelength of a beam of…
A: We need to compute-(i) Frequency of light in diamond (vd)=?(ii) Wavelength of light in diamond…
Q: Calculate the work W against gravity required to build a right circular cone of height 3 m and base…
A: Disclaimer: “Since you have asked multiple question, we will solve the first question for you. If…
Q: Two charges are situated near point P. q₁ = 0.025 µC and q2 = 0.12 µC. Find the electric field…
A: Given: In this question, the given details are, Here, the two charges are situated near point P ,…
Q: You are working as a Junior Engineer for a small motor racing team. You have been given a proposed…
A: Given: Velocity of car = v(t) = A1-ettmaxspeedFor Bugatti Veyron 16.4 Grand Sport Vitesse -…
Q: If Ωmatter = 0.3, Ωvac = 0.7 and Temperature of Cosmic Microwave Background = 2.73 K, at what…
A: Given: Vacuum energy density, Ωvac=0.7Matter energy density, Ωmatter=0.3Temperature of Cosmic…
Q: The dispersion relation of a system is given by w(k)=2w, sin, where wo is a constant and n is an…
A: We will answer the questions using formula for group velocity and phase velocity. The steps are as…
Q: A 4.0-kg particle moving along the x-axis is acted upon by the force whose functional form appears…
A: At x=2.0 m, we need to determine the particle's velocity. We are aware that the particle has a mass…
Q: If the density of liquid helium 4 is 1.25 x 10² kg/m³, estimate the temperature at which helium…
A: Given Data density of liquid helium ρ = 1.25×102 kg/m3 we have to calculate at what…
Q: The inductance of a long solenoid of length 1000 mm wound uniformly with 3000 turns on a cylindrical…
A: Given: Length of the solenoid, l = 1000 mm Number of turns, N = 3000 Diameter, d = 60 mm Radius, r =…
Q: A block of mass 500 g is attached to a spring of spring constant 80 N/m (see the following figure).…
A: The amount of potential energy that was held in the block spring support system right before the…
Q: The 2-m-wide rectangular gate is pinned at its center A and is prevented from rotating by the block…
A: Given: In this question, the given details are, The 2-m-wide rectangular gate is pinned at its…
Q: Tarzan grabs a vine hanging vertically from a tall tree when he is running at 9.0 m/s. (a) How high…
A: We have to determine the height to which tarzan can swing upward.
Step by step
Solved in 3 steps
