Show Step by step With Correct Answer.I will rate 1. A structure is attached to the ocean floor as shown in the Figure. A 2-m-diameter hatch islocated in an inclined wall and hinged on one edge. Determine the minimum air pressure,P1, within the container that will open the hatch. Consider the weight of the hatch is 50N.Consider seawater specific gravity is 1.025.10 mHatchSeawater30°HingeAir pressure, P1Free surface

Answered: Image /qna-images/answer/e0166e52-5e68-46f9-93d2-c786e2bf0027.jpg

1. A structure is attached to the ocean floor as shown in the Figure. A 2-m-diameter hatch is located in an inclined wall and hinged on one edge. Determine the minimum air pressure, p₁, within the container that will open the hatch. Consider the weight of the hatch is 50N. Consider seawater specific gravity is 1.025. 10 m Hatch Seawater 30° Hinge Air pressure, P₁ Free surface

1. A structure is attached to the ocean floor as shown in the Figure. A 2-m-diameter hatch is located in an inclined wall and hinged on one edge. Determine the minimum air pressure, p₁, within the container that will open the hatch. Consider the weight of the hatch is 50N. Consider seawater specific gravity is 1.025. 10 m Hatch Seawater 30° Hinge Air pressure, P₁ Free surface

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter6: Hydraulic Conductivity

Section: Chapter Questions

Problem 6.14P

See similar textbooks

Similar questions

COMPUTE THE CAPILLARY RISE IN mm. OF PURE WATER AT 10^0 C EXPECTED IN A 0.8 mm θ TUBE
15. If the pressure in pipe A is 6 kPa, the SG = 0.85 pressure in pipe B =. ........... psig. Water 90 mm 30% a. 1.27 70 mm b. 8.73 40 mm C. 60.17 SG = 13.6 Mercury d. None of all these
A container holds an oil layer of 0.3 m (SG = 0.9) above a 1.2 m layer of seawater (SG =1.03). What is the gage pressure at the bottom of the container (Pg in kPa)? (usespecific weight of water = 9.79 kN/m3 )
2) An open cylindrical tank contains 2 liquids with specific gravities and depth as follows: Liquid 1: Sı=1.00 di=1.30m; Liquid 2: S2=1.50 d2=1.35m; Liquid 2: S2=1.50 d2=1.35m. Find the pressures along the interface of the liquids and at the bottom of the tank.
Compute the capillary rise in mm of pure water at 100C expected in a 0.8 mm diameter tube. Surface tension of water at 100C=0.0742 N/m and y=9.804 kN/m3 Answer is in mm
5. Water is siphoned from a large tank and discharges into the atmosphere through a 0.05 m diameter tube. The end of the tube is 0.9 m below the tank bottom, and the height of the tube is H = 2.0 m. 2.75 m %3D (a) Determine the volume flowrate from the tank. (b) Determine the water pressure at the top of the tube. (Assume viscous effects are negligible) I 0.9
A tank contains gasoline sp. gr. = 0.90, oil sp. gr. = 0.8, and seawater sp.gr. = 1.03. If the depths of the liquids are 0.5 m. for oil, 0.6 m. gasoline, 1 mseawater. respectively. Find the pressure IN kPa at a depth of 1.4 m. Use 3decimal places.
The gage pressure (psig) at point a is nearest (a) 13.7 (b) 14.7 (c) 101.3 (d) 0 (e) 1 Oil a 3 in SG = 0.69 SThe gage pressure (psig) at point c is nearest (a) 57.2 (b) 1.4 (c) 6.7 (d) 0.4 8 in Water The absolute pressure (psia) the natural gas pipeline is nearest h, = 22 in (a) 8.4 (b) 65 (c) 9 (e) 23 16 in SThe gage pressure osig) in the natural gas pipeline is Natural gas Dif the pipeline pressure was increased by 50%, what cost- effective manometer modification(s) might be needed? (b) More mercury, less oil (c) Add 2 more manometer loops (d) Replace the manometer with a high-pressure gage (e) Rotate the gas line to a vertical alignment Mercury SG = 13.6
A tank used to collect rainwater having diameter of 4m .the depth of the tank varies linearly from 3.5m at its center to 3m along the perimeter.the local atmospheric pressure is 1bar ,the acceleration of gravity is 9.8mS square and the density of the rainwater is 987.1kg/m3. When the tank is filled with water,determine a) the pressure in kPa at the bottom center of the tank b)the total force in kN,acting on the bottom of the tank
1. Oil is placed inside a closed container, but it is not filled to the top. The vacant area above the liquid has an absolute pressure equivalent to 115 kPa, solve for the gage pressure located 2 meters below the liquid surface.
A closed tank contains 0.5 m thick layer of mercury (specific gravity = 13.6) at the bottom. A 2.0 m thick layer of water lies above the mercury layer. A 3.0 m thick layer of oil (specific gravity = 0.6) lies above the water layer. The space above the oil layer contains air under pressure. The gauge pressure at the bottom of the tank is 196.2 kN/ m². The density of water is 1000 kg/m³ and the acceleration due to gravity is 9.81 m/s². The value of pressure in the air space is
Compute the capillary rise in mm of pure water at 10 Celsius expected in an 0.8 mm diameter tube.