I need the answer as soon as possible 1. A transmission line has a conductor weight of 1200 kg/km and stress of I110kg. The sag was 9m. find the span between towers if the vertical sag equal to 5.4 m.

Please refer the attached images for the complete answer..

Answered: 1. A transmission line has a conductor…

1. A transmission line has a conductor weight of 1200 kg/km and stress of 1110 kg. The sag was 9m. find the span between towers if the vertical sag equal to 5.4 m.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.25P

See similar textbooks

Related questions

Q: Q1: A 400 kV 3-phase bundled conductor line with two sub-conductors per phase has a horizontal…

A: a) GMR of system is GMRsys=GMRa*GMRb*GMRc3 GMR of bundle conductor-a is…

Q: If a transmission line has to be designed with an ultimate strength 6000 kg and a safety factor of…

Q: e)Draw the single line diagram of AC and DC transmission. Compare both of them and draw conclusion…

Q: In a three phase 500 kV transmission line, diameter of the conductors are 48 mm. The breakdown…

Q: 2. a) Draw nominal t model of Transmission Line.

Q: 6. Verify that the volume of conductor required in a transmission system is inversely proportional…

A: Power in Three-Phase circuit- Power depends on voltage, current and power-factor. Law's of…

Q: A single phase transmission line has two parallel conductors 6 m apart, the ra dius of each…

A: We have an single phase transmission line which has two parallel conductor and given data as,…

Q: 1. A transmission line at river crossing is supported by two towers. Height of the lower tower is 72…

Q: 3. A single-phase transmission line has two parallel conductors 3.2 meters apart, radius of each…

Q: A three phase transmission line is made up of aluminum conductor wires 80 km long. Find the dc and…

A: Length of conductor is L=80 km = 80×103 m Diameter of conductor d = 480 miles Radius of conductor is…

Q: A transmission line has a span of 180 m between level supports. The conductor has a cross- sectional…

Q: The conductor of one phase of a three- phase transmission line operating at a line voltage of 258 kV…

A: Given: Line voltage=258 kV Rated VA=510 MVA CT ratio of current transformer=1000/5

Q: In an over head transmission line the weight on the conductor due to wind is 2.35 kg. The total…

A: In overhead line weight on the conductor due to wind = 2.35kg Total weight = 3.45kg No ice loading…

Q: A transmission line has a span of 150 m between level supports. The tension in the conductor is 2000…

A: Sag in transmission line is defined as the distance between maximum bending point to tower plane.…

Q: 400MVA power is transmitted with 380kV voltage and 18.1948 degree power angle with the help of a 500…

Q: 4. A 3-phase bundled transmission line of 200 km length consists of three ACSRconductors as shown O…

Q: If a transmission line has to be designed with an ultimate strength 6000 kg and a safety factor of…

Q: a) Discus why the transmission systems are mostly overhead systems. b) Discuss why all overhead…

A: a) The transmission systems are mostly overhead systems: Electrical power transmission is the…

Q: Q2: Estimate the distance over which a load of 15000 KW at p.f=0.8 lagging can be delivered by a…

A: The line current in the transmission line is determined by the given below expression,

Q: Q1(b) Using sketch discuss the impact of following terms occurred in the transmission line…

A: Here is the answer

Q: Question 1) A 154 kV transmission line has a length of 100 km. The line and the conductors are given…

Q: 04. A Transmission Line has a span of 250 meters between two level supports. The conductor has a…

A: The given data's are, Life span is 250 m, Cross sectional area is 1.29 cm2, Weight is W=1170…

Q: In a power system having three conductors A, B and C of a 3-phase line carrying currents IA, IB and…

A: The three-phase line is represented by the phase A, B, and C, the current across the given conductor…

Q: An overhead transmission line has a span of 260 m. The weight of the conductor is 0.68 kg/m. The…

A: Given an overhead transmission line has, Span, l = 260 m Weight of the conductor, w = 0.68 kg/m…

Q: If a transmission line has to be designed with an ultimate strength 8000 kg and a safety factor of…

A: Given, l=275 m T=8000 kg w=2 kgmwi=0.7 kgmww=0.95 kgm where, l is the length of span, w is the…

Q: 1. A 10km Overhead transmission line is supported by two towers of 80 meters and 62 meters at a…

Q: What is the maximum length in km for 3 phase transmission line having conductor of 0.775 square…

Q: 3. A transmission line has a span of 150 m between level supports. The cross-sectional area of the…

A: Given:Span, L=150 mCross-sectional area=1.25 cm2Weight of conductor, 100 kg/100 mWc=1 Kg/mBreaking…

Q: 4. A 3-phase bundled transmission line of 200 km length consists of three ACSR conductors as shown |…

Q: 3. A single-phase transmission line has two parallel conductors 3.2 meters apart, radius of each…

Q: 4.3 A transmission-line cable with a length of 2 km consists of 19 strands of identical copper…

A: To determine the resistance of conductor

Q: spectively per mile. Find the percent efficiency of the line.

Q: If the per-phase line loss in a 60-km-long transmission line is not to exceed 60 KW while it is…

A: Considering the given data:

Q: 1. Three conductors for a 3-phase 60 Hz transmission line are placed in a horizontal plane with…

A: We will use formula of inductance to find distance between phase conductors.

Q: QI. A transmission line has a conductor weight of 1200 kg/km and stress of 1110 kg. The sag was 9m.…

A: For a transmission line,The weight of the conductor is,W=1200kg/kmThe stress is,T=1110kgThe sag…

Q: i) Discuss the essence of the mechanical design of a transmission line. ii) Discuss the advantages…

A: (i) Mechanical design of a transmission line (a) Height of tower The height of the tower depends on…

Q: A single phase transmission line having copper conductor of 0.775 cm2 cross section over which 300…

A: A 1-ph transmission line has, Copper conductor cross sectional area (A)=0.775 square cm. Specific…

Q: Single Phase Transmission Line has two parallel conductors 2 meters apart. The diameter of each…

Q: 05/ A transmission line over a hillside where the angle is (0 = 2.2924°), is supported by two 22 m…

Q: The horizontal component of the tension in the conductor is constant throughout the length of the…

A: In this question we will write about horizontal component of tension of conductor ....

Q: 3. A single-phase transmission line has two parallel conductors 3.2 meters apart, radius of each…

Q: Q3 The characteristic resistance of a loss-less transmission line is given by (a) 1/√LC (B)…

A: Q3 The characteristic resistance of a loss-less transmission line is given by (a) 1/√LC (B) √LC…

Q: A 400 kV 3-phase bundled conductor line with two sub-conductors per phase has a horizontal…

Q: (b) Discuss the proximity transmission line conductors of power in Oman using sketch. a

A: Proximity effect- Case-Suppose we have two conductors A and B placed each other as shown in fig.…

Q: In an overhead transmission line, if 'L' is the length of span in meters, 'w' is the weight of…

A: Given: In an overhead transmission line, Length of span in meter is L Weight of conductor per meter…

Q: What are the factors which governs the performance of transmission line? Subject Power Transmission…

A: The main performance metrics of transmission lines are -

Q: 2. A single phase transmission line has two parallel conductors 3 m apart, the diameter of each…

A: Given, Spacing between the conductors = 3 m = 300 cm diameter of conductor = 2.2 cm Radius of each…

Q: The conductor of one phase of a three- phase transmission line operating at a line voltage of 324 kV…

A: Given that MVA rating of VT (S) = 930 MVA Primary voltage of VT ,V1 =324 KV CT ratio = 1200/1…

Concept explainers

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.

Question

I need the answer as soon as possible

1. A transmission line has a conductor weight of 1200 kg/km and stress of I110
kg. The sag was 9m. find the span between towers if the vertical sag equal to 5.4 m.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 30 mile, 3-phase transmission line delivers 8,000 kW at 33 kV, p.f. 0.8 lagging. The resistance and reactance of single conductor are 0.6 ohm and 0.72 ohm respectively per mile. Find the voltage at the sending end in kV.
A transmission line has a span of 250 meters between the line supports. The conductors has a cross sectional area of 1.29 cm2 and weighs 1170 kg/km and has a breaking stress of 4218 kg/cm2. Calculate the sag and vertical sag with a safety factor of 5, with a wind pressure of 122 kg per square meter of the projected area.
A 30 mile, 3-phase transmission line delivers 8,000 kW at 33 kV, p.f. 0.8 lagging. The resistance and reactance of single conductor are 0.6 ohm and 0.72 ohm respectively per mile. Find the percent efficiency of the line.
Estimate the distance over which a load of 15000 kW at 0·85 p.f. can be delivered by a 3-phase transmission line having conductors of steel-cored aluminum each of resistance 0·905 Ω/phase per kilometer. The voltage at the receiving end is to be 132 kV and the loss in transmission is to be 7·5% of the load.
3. A transmission line has a span of 150 m between level supports. The cross-sectional area of the conductor is 1·25 cm2 and weighs 100 kg per 100 m. The breaking stress is 4220 kg/cm2. Calculate the factor of safety if the sag of the line is 3·5 m. Assume a maximum wind pressure of 100 kg per sq. metre. [4]
single phase overhead transmission line delivers 4000 KW at 11KV 8.8 power factor lion if resistance and reactance for conductor are 0.15 women 0.02 ohm respectively calculate percentage regulation sending and power factor line losses
2. A single phase transmission line has two parallel conductors 3 m apart, the diameter ofeach conductor being 2.2 cm. calculate the loop inductance per conductor per km length ofthe line if the material of the conductor is (i) copper (ii) steel with relative permeability of110.
An Overhead transmission line has a span of 115 m. Ultimate strength is 3600 Kg and factor of safety is 2. If the sag is 3 m, If the weight due to wind is 1.5 kg/m, Determine(a) weight of the conductor and(b) Length of the line
A 25 kilometer long three phase transmission line has conductors 2.5cm in diameter and are separated by a distance of 2 meter. The resistance of the line is 4 Ω and it delivers 15MW at 33kV, 0.7 power factor lagging. Estimate i. Inductive reactance ii. Sending end voltage iii. Voltage regulation iv. Transmission line efficiency
A single phase transmission line is delivering 490 kVA load at 14 kV. Its resistance is 6 Ω and inductive reactance is 7 Ω if the load power factor is 0.7 lagging. Determine the: A) Current through the line. B) Sending end voltage. C) Sending end power factor. D) Regulation of transmission line. E) Efficiency of transmission line.
100 km of single-phase transmission line, 800 kVA power 8 kV, is carried with 0.9 reverse power factor. The resistance of one kilometer of the line is 42 mΩ, and the reactance of one kilometer of the line is 0.646 Ω. Find the voltage at the beginning of the line and the efficiency of the line accordingly.
An overhead 3-phase transmission line delivers 1200KW at 22KV at 0.8 power factor lagging. The length of the line is 25 Km . The resistance and reactance of conductor are 0.25ohm per Km and 0.30ohm per Km. Determine: 1) Sending end voltage 2) Percentage regulations 3) Sending end power factor 4) Transmission efficiency