1. A water solution containing 10% acetic acid is added to a water solution containing 30% acetic acid flowing at the rate of 20 kg/min. The product P of the combination leaves the rate of 100 kg/min. What is the composition of P? For this process, a. Determine how many independent balances can be written. b. List the names of the balances. c. Determine how many unknown variables can be solved for. d. List their names and symbols. e. Determine the composition of P.

Q: Book: Process Dynamics and Control, Third Edition or Fourth Edition, by D. E. Seborg, T. F. Edgar, D...

A:

Q: The diffusion coefficient of water (B) in ethanol (A) at 25oC is 2,4x10-5 cm2 s-1 and the viscosity ...

A: Given that, Temperature T = 25oC = 298.15 K The diffusion coefficient of water in ethanol D = 2.4×10...

Q: The exhaust gas components of an engine running on acetylene (C2H2) were measured as 8.8% CO2, 0.1% ...

A: Fuel is C2H2 Exhaust gas composition on a dry basis: 8.8% CO2, 0.1% CO, and 10.2% O2. Rest is nitrog...

Q: Consider the reaction 2CIF3 (g) + 2NH3 (g) → N2 (g) + 6HF (g) + Cl2 (g) △H° = - 1196 KJ  Calculate △...

A: The given reaction is:   The standard heat of the reaction is given as:

Q: In the process control system given below schematic drawing; to advanced equipmenta temperature sens...

A: Given a system of advanced equipment which has a temperature sensor installed in the pipe to control...

Q: A cylinder fitted with a moveable piston contains 2L of oxygen at 25°C and 3 bar. The piston is push...

A: following values are given in the question the initial volume of oxygen (V1)=2L the initial temperat...

Q: micro filtration, Ultrafiltration ,Reverse Osmosis and Nanofiltration describe in details and please...

A: Given processes are to be explained.

Q: A researcher will use a water bath to extract from Escherichia coli bacteria. He wants to use the 13...

A: Given Data : The amount of ice cube the researcher planned to use (m) = 135 g The initial temperatur...

Q: Q2 ): A forward feed double effect standard vertical evaporator with equal heating areas in each eff...

A: In an multi effect evaporator feed is introduced at 14 kg.s-1 as a forward feed. A evaporator is use...

Q: Solids soaked with liquid hexane are dried by being contacted with nitrogen at an elevated temperatu...

A:

Q: Compressed gases are typically contained in cylinder-shaped containers instead of any other shape, b...

A: Compressed gases are typically contained in cylinder-shaped containers instead of any other shape, b...

Q: Chemical Engineering Question

A: Note: Since we are entitled to answer only 1 question, we’ll answer the first one. Please resubmit o...

Q:

A:

Q: A reaction of carbon monoxide and hydrogen is conducted to produce methanol. The reactor effluent fl...

A:

Q: The standard enthalpy of combustion of ethene gas, C2H4(g), is-1411.1 kJ/mol at 298 K. Given the fol...

A: Given data: Standard enthalpy of combustion of ethene gas = -1411.1 kJ/mol Standard enthalpy of form...

Q: Experimental data for the reaction A → 2B + C have been plotted in the following three different way...

A: data for the reaction A → 2B + C have been plotted here we can use by trail and error of order of re...

Q: Butane, C4H10, burns with the oxygen in air to give carbon dioxide and water. 2C4H10(g) + l3O2 (g) +...

A: The reaction of butane with oxygen is given as:   2C4H10(g) + 13O2 (g) + → 8CO2 + 10H2O(g)   Moles o...

Q: Lithium nitride, an ionic compound containing the Li+ and N3-ions, is prepared by the reaction of li...

A: Given data: Mass of nitrogen gas = 56 g Mass of lithium metal = 56 g

Q: answer both

A:

Q: Substance A reacts according to a second order kinetics and conversion of 95 % is achieve in a singl...

A: A continous stirred tank reactor is a batch reactor , attached with a mechanical agitator and which ...

Q: A large quantity of a highly viscous monomer solution with a specific gravity of 0.944 and viscosity...

A: To find a) power requirement of the pump b) Reynolds number and identify flow pattern in pipe sectio...

Q: H.W 4.2: A furnace is to be designed for a heat duty of 30 x 10 Btu/hr and efficiency of 75%. The fu...

A: according to data Heat duty Q=3x106 Btu/hr Efficiency=75% Furnace is fired with gaseous fuel at a r...

Q: There are two separate phases, one with a composition of 12% phenol and the other with a composition...

A: Given that, The mass fraction of phenol in phase 1 x1 = 0.12 The mass fraction of phenol in phase 2 ...

Q: Pyrite containing 80% FeS2 and 20% gangue is burned in excess air to produce a gas with a complete a...

A:

Q:

A:

Q: I Q3. A PID controller has the transfer function G(s) = 5s + 10 + Find the values of 'PB', Tp, Tj.

A:

Q: A 318 mg of sample containing MgCO3 and CaCO3 only was decomposed completely to produce CO2. The gas...

A: Following values are given in the question total weight of the sample(M)=318mg the sample contains M...

Q:

A: A notch device used for the measuring rate of flow of liquid through a small channel. It is an openi...

Q: can you please answer question b

A: Given data:  P = Po * ekt   here, P = total population after time t (gram)           Po = initial po...

Q: Nitrogen and oxygen gases react reversibly to produce gaseous N2O4 in a 4.00 L container being held ...

A: Nitrogen and oxygen reacts reversibly to produce N2O4. N2 + 2O2 <----> N2O4 1 mole of nitrogen...

Q: a city of 150,000 people. Estimate: (1) the diameter of three equally sized mixing basins 10 ft deep...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for yo...

Q:

A:

Q: Eor the eguation: Na + H:O → NaQH + ½ H2 Uf 5 grams of sodium is placed into 100 grams of water, at ...

A:

Q: From the structure of the products expected to be obtained by dehydrohalogenation of2-bromo-2-methyl...

A: Dehydrohalogenation reaction : In dehydrogenation reaction hydrogen halides are removed from the sub...

Q: 2. It is proposed to heat a house using a heat pump. The heat transfer from the house is 15kW. The h...

A:

Q: 1. An insulated cylindrical storage tank of 80 m volume initially contains 75 m' of nonvolatile liqu...

A: Given Data : The tank is an insulated cylindrical tank of volume 89m3  The initial volume of nonvola...

Q: At 430 °C, Kp = 54.3 for the following reaction: H2(g) + 12(g)→2HI(g). A mixture of H2 at a pressure...

A:

Q: Book: Process Dynamics and Control, Third Edition or Fourth Edition, by D. E. Seborg, T. F. Edgar, D...

A: Here given the transfer function for the feedback control system comprising of the final control ele...

Q: Why is it important to determine the moisture content before it enters the mill

A: Introduction Milling is a term used to refer to mechanical techniques to reduce the particle-size of...

Q: . How many atoms of carbon are present in 1 .0 g of CH4O ?How many atoms of carbon are present in 1....

A: Given data: Mass of CH4O = 1 g Mass of CH3CH2OH = 1 g Mass of CO(NH2)2 = 25 g

Q: A groundwater sample has been determined to contain 100. ppm Ca. Са. Calculate the molarity of this ...

A: We know that 1ppm = 1 mg/L So 100 ppm = 100 mg/L Dividing by 1000 we get concentration in g/L= 100/1...

Q: which is the correct statement. a)In Coalescing, small oil droplets collide to form bigger dropletsI...

A: Emulsion is a class of two different phases of matter known as colloids. Emulsion is used when dispe...

Q: A baker's yeast factory in Turkey produces 12 tonnes of dry yeast per day. Fermentation media coming...

A:

Q: An endothermic elementary liquid phase reaction A+B—C is carried out in a CSTR which is heated by a ...

A: Liquid phase elementary reaction in CSTR is given as:   A + B → C   Equimolar concentrations of A an...

Q: ‘Water at 60° C flows over 2.5 cm square flat plate 90°C at a velocity of 4 m's. 1- Calculate the dr...

A: Water flows over a square flat plate maintained at 90oC drag force in the heat transfer taken in con...

Q:

A: Volume of CO2, V = 50 L Pressure, P = 5 MPa Temperature, T = 40ºC = 313 K        

Q: 1. A water solution containing 10% acetic acid is added to a water solution containing 30% acetic ac...

A: Given data: Composition of acetic acid in a water solution = 10 % Composition of acetic acid in anot...

Q: Explain path line in relation to fluid mechanics.

A:

Q: A bottle of phosphoric acid is labeled “85.0% H3PO4 by mass; density = 1. 689 g/cm 3." Calculate the...

A: Given: Phosphoric acid (H3PO4) is 85% by mass. Density = 1. 689 g/cm3 Required: Molarity Molality Mo...

Q: Q1) A 20-cm-square plate loses heat with rate of 5000 W/mz. Air at 1 atm and 300 K flows across the ...

A: Side of the square plate, a = 20 cm = 0.20 m Heat lost from the plate, Q = 5000 W/m2 Air flows at th...