1. Determine the value of R₁ for maximum power transfer. Also, determine the maximum power. 180V( 1 902 W 501 W 300 400 + ЗА W RL

Q: As shown in Figure, Eryener and Kuscu proposed a hybrid transpired solar chimney consisting of solar…

A: Given data, Diameter of solar collector=30m The efficiency of the PV module=40% Vmax=12V Imax=4A…

Q: 85[1+0.4432/1-.85(sqrt(48.2625/V))]=100 Solve for V

A:

Q: Convert the octal number 714g to the decimal number.

A: It is given that: 7148

Q: Find the voltage across each inductor for the given circuit using the voltage divider rule.

A: The given circuit diagram is shown below,

Q: Determine V₁(s), Z₁ (s), Z₂(s) and the transfer function (Vout/Vin) for the electrical system given…

A:

Q: Problem D continued b. Determine Vout for the given input signal

A: Need to analyze the circuit to find the output waveform. The given circuit is an inverting Schmitt…

Q: Plot the dc bias line for this circuit. www R₁ · 1.5 ΜΩ R₂ · 1.5 ΜΩ VGS (V) +30 V RD 1.1 ΚΩ 2N5459…

A:

Q: 4. Find voltage across the capacitor in s-domain V(s) when initial values of vc(0) = 1.5V and it (0)…

A: In this question we need to find the voltage across capacitor in a domain

Q: In the circuit shown in the figure, the switch #2 can be toggled to either position a or b. In…

A:

Q: Q1 + 1.5kQ Vcc= = 2.25 V Determine the small-signal model of Q1 for the circuit above. (Is = 8 x…

A:

Q: Consider the circuit shown in. Suppose that v = 170 cos 10, 000t V, where t is in seconds. Part A Z₁…

A: MAXIMUM POWER TRANSFER THEOREM: In any linear bilateral 2-terminal network consists of linear…

Q: 10 Ω 12+15cos(8t) V +- 40 Ω + v(t) - 1+ sin(5t) A

A:

Q: 9. If the beam width of an antenna in two orthogonal planes are 30⁰ and 60°. Then the directivity of…

A:

Q: D) Find Break-Out points on Real Axis? E) Find Angle of Departure? F) Find cross Imaginary Axis?

A: For the given system we have to find the break-out point, Angle of departure and point at which the…

Q: For the circuit, draw the VIN-VOUT characteristic over the range −10V < 270. The zener diode has…

A: input voltage range is -10 V &lt; vin &lt;+10 V resistance R1 = 270 ohms forward voltage  vf = 0.63…

Q: VB Q₁ Consider the circuit shown above, assuming B = 150and Is = 7 x 10-16 A. If R₁ = 10.5k,…

A: We need to find out the unknown voltage for given circuit.

Q: 6. A signal with wavelength of 10 cm travel through a twin lead transmission line with the following…

A:

Q: Problem 5: Find a Fourier sine series for f(x) = ex on (0, π). Then, find a Fourier cosine series…

A: given that function   f(x) = ex , defined for interval [0, π] To find the Fourier series…

Q: 5 V 5 V 100 02 www 100 0 w \t=0 + 81 uF 1H 1=0 Find the voltage across the capacitor ve(t) for time…

A:

Q: 1. A rectangular loop carrying current is placed parallel to an infinitely long filamentary wire…

A: A rectangular current carrying loop is placed parallel to an infinitely long filamentary wire…

Q: A source free second order series R-L-C circuit It R-100 QL-5H and C-2roF. The general natural…

A: Resistance R=100 Ω. Inductance L = 5 H. Capacitance C = 2 mF.

Q: a 2o MHz carrier is frequency modulated by a sinusoidal signal such that the peak frequency…

A: carrier frequency = 20MHz, Peak Frequency Deviation = 100kHz need to calculate the modulation index…

Q: 7.2.16 Use the step-by-step method to find vo(t) for t> 0 in the given circuit.

A: Given circuit,

Q: V₂ VD,on = 800mV for the constant-voltage diode model. (1) Plot the input/output characteristics of…

A:

Q: For a single phase full wave controlled bridge rectifier with a resistive load if the input voltage…

A: Supply RMS voltage; VRMS=150 V Supply frequency; f=50 Hz Resistance value; R=25 Ω Firing angle;…

Q: Calcule la potencia disipada por la resistencia de 8.002 en el circuito ilustrado en la figura de…

A: The circuit diagram,

Q: A series generator is connected in series to a feeder having 0.5 resistance to boost the voltage.…

A: Given a series generator connected in series with feeder having resistance of 0.5 Ω. The induced…

Q: A=7,3 â, +2,3 ây+ 3,3 â, ve B=2,6 â+ 5,2 â+ 8,5 â, ise A. B=? az if A=7,3 â+2,3 ay+ 3,3 â and B= 2,6…

A:

Q: di nden sayfa uyurular For uncontrolled half wave rectifier, R=80ohm, L=0.15H, f=50Hz and Vm=311V.…

A: We need to find out the average value of current for given rectifier.

Q: Vx Ix + O R2 IRIVR₁ VB D₁ Ideal In the circuit above, plot Ix and IR1 as a function of Vx for two…

A: Given: circut To do: We have to plot Ix and IR1 as function of Vx.  a) When VB= -1 V, b) When VB=…

Q: For controlled half wave rectifier, R=44ohm, f=50Hz and Vm=280V and x=0,9 rad. Calculate the power…

A: In this question we need to find the power absorbed by the load

Q: A simple slide wire is used for measurement of current in a circuit. The voltage drop across a…

A: Voltage drop across 0.1-ohm resistor is balanced at 75 cm, Standard cell emf=1.45 V balanced at 50…

Q: Q2 Consider the unity feedback system with the open-loop transfor fruction K S(S + 1) [ (5²/₂25…

A:

Q: (a) Find Vs in the network in the figure below if V, = 4/0°V. 1 Ω -j1 Ω HH 1Ω + V Σ2Ω + = -j1 Ω ΖΩ

A:

Q: 2. A combinational circuit is defined by the following three Boolean functions F = x'y' + z G=xy'z'…

A: The given boolean function should be implemented by using multiplexer and decoder. The given…

Q: In the circuit above, plot lx and IR1 as a function of Vx for two cases: VB = -1.5V and VB = +1.25V.…

A: Given: A circuit,  To do: We have to plot Ix and IR1 as function of Vx.  a) When VB= -1 V, b) When…

Q: 24. Find the Fourier sine and cosine transformations of f(t) = e-k for t > 0.

A: given function is     f(t) =  e-kt   for t&gt;0

Q: Plot the Odd component on your answer sheet and then define the amplitudes (place the values onto…

A:

Q: Draw the signal flow graph of the following diagram. R is the input and C is the s² output. Blocks…

A:

Q: For the Transfer Function 100 (s + 1) s² + 110s + 1000 A) Find the factors of Bode stander transfer…

A:

Q: How can you shield your device from potential dangers like power surges?

A: We need to write methods to  shield device from potential dangers like power surges.

Q: A synchronous generator of reactance 1.3 p.u. is connected to an infinite bus bar through…

A: A synchronous generator- Reactance=1.3 p.u. Transmission line reactance=0.2 p.u. &amp; 0.5 p.u. H=4…

Q: A modern elevator Con Determine the transfer function of the control system, show all steps clearly.…

A:

Q: 10. Design a single-phase inverter used to control 12 ohm induction heater that generates a 60Hz…

A: In this question we need design a single phase inverter .

Q: For the circuit below, given Vcc = 15 V, answer the following: (a) Choose component values such that…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: In the figure  is shown:

A:

Q: The circuit you should use to find the short circuit current, fac, is shown here. Note that the load…

A: The circuit you should use to find the short circuit current, isc , is given in the diagram. Note…

Q: The 10-cm-wide, zero-resistance slide wire shown in (Figure 1) is pushed toward the 2.5 12 resistor…

A: In this question we need to find the following Pushing force How much power does the pushing force…

Q: In the magnetic circuit shown below, what is the flux density produced if the relative permeability…

A: A magnetic circuit- Number of turns N=100, Current I = 5 A, Relative permeability μr=1000,

Q: Find the transfer function G(S)= Y(s)/R(s) for the following system represented in the state space:

A: The state space matrix is  A=010001-3-2-5,B=0010 and C=100 Need to find the transfer function from…

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.