Answered: 1. Find the density of an oil filled in…

1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute pressure at the bottom is 650 kPa, atmosphere pressure is 1.0132 bar. where X=4m; Y = 4m, Z=1.5m.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.5P: Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen,...

See similar textbooks

Related questions

Q: The uniform 5-m-long round wooden rod is tied to the bottom by a string. find the tension in the…

A: the rod weight acts at the middle 2.5m from the point C while the buoyancy is 2m from C W is the…

Q: 4. The barometer reads 29.0 inches of mercury. What is the absolute pressure if a vacuum gage reads…

A: Given Data: Q-4) Pb=29 in of mercury, Pg= -9.5 psi Q-5) W=5 N, V=200 cm3

Q: 2. A tank that weighs 5kg is filled with 3 liquids shown below. What is the force at the bottom of…

Q: If in figure , the pressure at m is 20 lb per sq.in., what when z = 8 in? the corresponding pressure…

A: Given data

Q: Assuming the specific weight of the air to be 12N/cu.m, what is the approximate height of Mt.…

Q: An open tank contains water up to a depth of 1.2m from the bottom and above it mercury for a depth…

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

A: Given Data: The absolute pressure at the bottom is, P=625 kPa=625 kPa×1000 PakPa=625000 Pa. The…

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

A: The pressure increases as we move deep down in the fluid. For static fluid this pressure is termed…

Q: 5. The barometer reads 29.0 inches (737 mm) of mercuy. What is the absohite pressure if a vacuum…

Q: Set the barometric pressure in Pa. b. If the ambient temperature is increased to 29 ° C but the…

A: batometer is instrument use for measure the atmospheric (barometric) pressure.here inverted U tube…

Q: 1) We want to measure the density Q2 of the fluid in the tank depicted in the figure by attaching a…

Q: For a vertical rectangular gate, one side has linseed oil (0.938) and the other has two…

A: Given data: SGLo=0.938SGCo=0.96 Need to determine the hydrostatic force due to each fluid.

Q: Consider a water droplet resting on a 3D spherical surface with a radius of curvature R. Assume the…

Q: A circular plate of diameter 3.25 m is vertically placed in water in such a way that the centre of…

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

A: Given A container contain three fluid placed over one another of different thickness and density…

Q: : Determine the pressure difference between the two points in figure below Oil (S=0.75) X- S =1 S,=1…

A: It is required to determine pressure difference between two points A and B

Q: 3. Determine the gauge pressure at P in the figure below which shows a compound manometer. Take all…

Q: 4. As shown in Fig. 2.41, pipe A contains carbon tetrachloride of specific gravity 1.594 under a…

A: Given For pipe A Specific gravity, SGA = 1.594 Pressure, PA = 103 kN/m2 For pipe B…

Q: Q-2 A U-tube manometer is connected to a closed tank as shown in Fig. The air pressure in the tank…

Q: he Titanic ship’s lost sister named Britannic sank off the coast of Greece 400 ft below the sea…

A: Givendepth H=400ft =400×0.3048 m=121.92mdensity ρ=63.9 lbm/ft3 =63.9×16.0185 kg/m3=1023.58 kg/m3

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

Q: If a = 2 in, and the density of the fluid is 60 lbm/ft^3, what is the pressure at point B in psia?

Q: What is the pressure acting on the water at a depth of 1m at 4°C? What is the pressure acting on the…

A: As per the guidelines we will answer the first three subparts for you, for the remaining subpart…

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

A: Given Absolute pressure = 550 kPa

Q: 1. If the pressure at a point in the ocean is 75 kPa, what is the pressure 27 meters below this…

Q: Question (3):- Find the pressure difference (PA-PB) in the figure shown. Oil (s=0.8) 200 mm 100 mm…

A: The manometer with line MN is given below,

Q: A glass 12 cm tall filled with water is inverted. The bottom is open. What is the pressure at the…

A: The gauge pressure at the bottom of a column of water which is open to atmosphere can be calculated…

Q: 1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute…

A: Given that the absolute pressure at the bottom is 700 kPa = 700 x 103 Pa Atmospheric pressure is…

Q: Find the hydrostatic pressure on one side of the plate submerged in water (p = 1.00 8/mL) shown in…

A: give data;density of water (ρ)=1g/ml =1000kg/m3 AB=8mAD=6m

Q: An open tank contains water up to a depth of 1.2m from the bottom and above it mercury for a depth…

Q: Air Question 5. 1,2 m wide AB gate is articulated from point A shown in the figure. The heights of…

Q: What is the absolute pressure inside a water drop having radius 1mm and surface tension as 0.1 N/m?…

Q: For a vertical rectangular gate, one side has linseed oil (0.938) and the other has two…

Q: Problem 1: One end of a U-tube that contains water is open to the atmosphere, but the other end is…

A: ...

Q: Problem 4. A tank with vertical ends contain oil (0.82) and is 8m long nomal to the plane. The…

Q: The figure shows a vertical cross section of a container filled with water. Find the hydrostatic…

Q: Q2: A cubical tank has sides of 3.75m which contains three immiscible liquids at same depths. A…

A: Given data Side length of the cube L = 3.75m Height of water Hw = 1.25m from base Height of liquid…

Q: containing Oxygen (initially at sea level) has a diameter of 8in. If the uniform density of air is…

Q: The figure shows three fluid columns, each with a different cross-sectional area. The fluid is the…

A: Given

Q: A tall glass cylinder is filled with a layer of water 18.0 cm deep, and floating on top of the…

Q: Consider the pressure and force acting on the pool retaining a reservoir of water. Suppose the pool…

Q: Express the hydrostatic force against one side of the plate as an integral and evaluate it.

A: Given: A hemispherical plate d=10 ft d=1 ft Density = 62.5 lb/ft3 To determine: The hydro-static…

Q: spherical contaln 5. A barrel contains a 150 mm layer of oil floating on water that is 300 mm deep.…

A: According to our guidelines, In case of multiple questions we are supposed to answer the first…

Q: *6. A drop of oil (y = 0.0320 N/m) has a radius of 0.0100 mm. The drop is located a distance of 2.55…

Concept explainers

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.

Question

1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute
pressure at the bottom is 650 kPa, atmosphere pressure is 1.0132 bar. where X=4m; Y = 4m,
Z=1.5m.
water
oil
Y
Mercury
The density of the oil = (unit in kg/m³) =

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Find the density of an oil filled in the liquid column as shown in figure. Given that absolute pressure at the bottom is 500 kPa, atmosphere pressure is 1.0132 bar. where X=4m; Y = 4m, Z=1.5m. The density of the oil = (unit in kg/m3) =
1. Given an air with a known temperature and pressure of 4 degree Celsius and 105 KPa, respectively, find the density of the air. 2. A rigid container is closed at one end and measures 7 inches diameter by 14 inches long. The container is held vertically and is slowly moved downward until the pressure in the container is 16.5 psia. What will be the depth of the water surface measure from the free water surface?
An open tank contains water up to a depth of 1.2m from the bottom and above it mercury for a depth of 0.8m and above it an oil of specific gravity 0.8 for a depth of 1m. Assume the atmospheric pressure is 1 bar. Find the gauge pressure and absolute pressure i) at the bottom of the container, ii) at the interface of water and mercury and iii) at the interface of an oil and mercury. ( i) At bottom Gauge Pressure = ________________N/m2 Absolute Pressure =_________________ N/m2 ii) At the interface of water and mercury Gauge Pressure =_______________ N/m2 Absolute pressure =_____________ N/m2 iii) At the interface of oil and mercury Gauge Pressure =_____________ N/m2 Absolute Pressure = _________________ N/m2
The depth of an oil well is 17,500 feet. The pressure of the oil at the bottom is the same as that of a 15,500-foot-deep column of saltwater. The oil has a density of 55 lbm/ft3. What is the pressure exerted on the oil in the well's surface? (Sea water density = 63.9 lbm/ft3).
An open manometer, shown in the figure, is installed to measure the pressure in a pipe carrying an oil (SG = 0.82). If the manometer liquid is carbon tetrachloride (SG = 1.60) determine the pressure in the pipe (in N/m2). Find the pressure head in meters of water column height.
What is the absolute pressure inside a water drop having radius 1mm and surface tension as 0.1 N/m? Assume atmospheric pressure as 1 bar.
Please answer neatly For a vertical rectangular gate, one side has linseed oil (0.938) and the other has two fluids—castor oil (0.96) and water. Considering a unit-width of the gate, apply the PRESSURE PRISM CONCEPT (Illustrate and label the pressure diagram/prism) to calculate the magnitude and direction of the following when z = 7m.a.The hydrostatic force due to linseed oil F1. b.The hydrostatic force due to castor oil F2. c.The hydrostatic force due to water. d.The net hydrostatic force acting on the gate Fnet
A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 4 inches of carbon tetrachloride (SG=1.59), 2 inches of water and 12 inches of syrup (SG=1.31). The air chamber in the tank is pressurized at 1296 psf. d. Apply the PANEL EQUATIONS to determine the magnitude, direction and location of the total hydrostatic force acting at the bottom of the tank.
1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute pressure at the bottom is 550 kPa, atmosphere pressure is 1.0132 bar. where X=4m; Y = 4m, Z=2m. The density of the oil = (unit in kg/m3) = Make sure of the solution, I don't want a mistake
An aeroplane flies at an altitude of 10 km, where the atmospheric pressure is 0.26 bar. If the cabin is pressurised to 0.63 bar, what is the force due to hydrostatic pressure acting on a window of area 0.065 m2?
For a vertical rectangular gate, one side has linseed oil (0.938) and the other has two fluids—castor oil (0.96) and water. Considering a unit-width of the gate, apply the PRESSURE PRISM CONCEPT (Illustrate and label the pressure diagram/prism) to calculate the magnitude and direction of the following when z = 7m. FIND: A. The hydrostatic force due to linseed oil F1. B. The hydrostatic force due to castor oil F2. C. The hydrostatic force due to water. D. The net hydrostatic force acting on the gate Fnet
5. The Hoover Dam, in Arizona, encloses Lake Mead, which contains 10 trillion gallons of water. The dam is 1200 ft wide and the lake is 500 ft deep. (a) Estimate the hydrostatic force on the dam, in MN. (b) Explain how you might analyze the stress in the dam due to this hydrostatic force?