1. For a system with FM modulation, the amplitude of the unmodulated carrier is 12Vp, if the modulation index is 1.5 and the load resistance RL is 10 ohms, a) determine the power in the unmodulated carrier;  b) Determine the power at the carrier frequency and at each significant side frequency for the modulated wave. What value of power do you obtain when adding the values ​​obtained in question (b)?

Q: Find il and i 2

A: The given circuit should be converted into frequency domain and then apply mesh analysis to find the…

Q: In this circuit, assume R₁ = 1k, V₁ = 24V, VTRIG = 3V, VAK = 0.6V, VGK = 0.5v, IH = 15mA and RG =…

A: The Given values are RA=1kΩ, VA=24v, VTRIG=3v, VAK=0.6v, VGK=0.5v, IH=15mA The Given Circuit diagram…

Q: For the system shown below, design a lead compensator Ge(s) such that wn=4 rad/sec. and 3=0.5 for…

A: Given data : Gc(s)H(s)=4s(s+2) Natural  frequency ωn=4rad/sec Damping ratio ξ=0.5

Q: ми Tos R 3A 250 652 20V Find the Nortons equivalent circuit for the network to the resistor R of the…

A: Norton theorem states that  a two terminal network containing linear and bidirectional elements and…

Q: 30 V 3 Ω www 6Ω 8 Ω ww 20 252 4 Ω ww (16A 16 Α

A:

Q: stepper motor,

A:

Q: A 12 m x 8 m classroom with 4 m high ceiling will have an ambient lighting target illuminance of 800…

A: Given information, Length of classroom L=12 m. Width of classroom W=8 m. Height of ceiling HC=4 m.…

Q: If A = 5 i - 10 j, what is the unit vector in the direction of A ? O0.894 i-0.447 j O0.894 i +0.447…

A: This question belongs to basic electrical . It is based on the concept of basic laws of vector…

Q: The charge of an electron is -1.60 x 10 19 C. A current of 3.5 A flows in a wire carried by…

A: Given, Charge of an electron, e=-1.6×10-19 C Current, I=3.5 A

Q: The divergence of a vector D for rectangular coordinate is equal to [1/p a/ap (pDp)] + [1/p Dø/dø] +…

A: Ans :( false)  Rectangular co-ordinate system means Cartesian coordinate system .

Q: (a) Find the Q-point for the transistor in the circu in Fig. P4.114(a) if VDD = +12 V. (b) Repeat f…

A: Q point is a operating device it is also known as bias point. The steady state DC voltage &…

Q: A Y-connected balanced three-phase generator with an impedance of 0.4+ j0.32 per phase is connected…

A: The Given Y-connected balanced 3ϕgenerator with impedance of 0.4+j3Ω per phase The Y-connected…

Q: When two identical elements of a kettle are connected in series to a 240V supply, Power developed is…

A: To solve above problem understanding of voltage divider rule and Ohm’s law is required. Ohm's law…

Q: Find the polarization of dielectric material with dielectric constant 2.8 and electric flux density…

A: Given data : Dielectric constant εr=2.8  Electric flux density D=3×10-8cm2

Q: Q1/A: Sketch Fourier transform of the given signals: (Only sketch) 1. Xi(t)=A TA 2. f X3(t) 3. 4.…

A: As per the guidelines of bartleyby I need to answer first three questions only so kindly repost…

Q: A 1000 candela light source emits a beam of light. The source is held exactly 4 ft above a moveable…

A: Lumens refers to the higher number of brightness of a light bulb higher the lumen brighter the bulb…

Q: 10. A 4 pole, 250 V d.c. series motor has a wave connected armature with 496 conductors. Calculate…

A:

Q: Determine IE and VC for the network. +8 V 3.3 ΚΩ 3=110 VC 3.9 ΚΩ -12 V

A: Given here a electrical circuit and asked to find the IE ,VC.

Q: Find Laplace Transform of the following signals: 1- x₁(t) = t³ u(t) 2- x₂(t) = u(t-1) e-²t u(t-1) 3-…

A:

Q: Calculate the Power and RMS . 1. x(t) = 8 cos (4t) cos (6t)

A: Relation between RMS and Power-             power=RMS2

Q: Q6/ Charge is: is the rate of change of the charge, measured in Amper (A). an electrical property of…

A: here we have to define the charge and direct current.

Q: Voltage Output (Vo)

A: The diode is conducts when it is forward bias mode. In the reverse bias mode the diode  doesn't…

Q: Determine the z parameters for the circuit shown in below. 6Ω 592 ww www + V₁ 0.66V 422 + V₂

A: Given Circuit:-

Q: the currents 11

A:

Q: The electric flux density is measured in

A: FALSE

Q: The volume of the cylindrical is? Ods = r de dr Ods=r de dz Odv = dx dy dz Odvr dr de dz

A:

Q: (1) List 3 characteristics of an ideal op-amp. (ii) Name 2 basic circuit applications for linear and…

A: NOTE- As per the rules we can answer only sub-parts from the first question part, please post the…

Q: 3. You are given voltage across capacitor in the above circuit for various time points. Which of the…

A: The voltage across capacitor decays exponentially so the equation is  V(t)=V0e^-t/RC

Q: The integral of the normal component of any vector field over a closed surface is equal to the…

A: In this question we will write about divergence theorem......

Q: Q91 For the Logic Circuit shown in figure (6) write the SOP logical expression of the function (F)…

A:

Q: What is the ac current flowing in the circuit shown below? 12 v 1.5kHz 0.1 μF

A:

Q: A series type ohmmeter, designed to operate with a 9-V battery, the meter movement has an internal…

A: Given data : Battery Voltage Vb=9V Resistance R1=49kΩ Full scale deflection current ifsd=100μA…

Q: The conductor has a large energy gap? O True O False

A: Materials can be classified as conductors, insulators and semiconductors. Conductors for example…

Q: 1. Is hydro power a renewable Energy? Draw a schematic diagram to explain the Electricity generation…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: The drain current in a p-channel E-MOSFET with V GS(th) -3V at V=0 is GS Select one: a. maximum

A: Given a p-channel E-MOSFET with, VGSth=-3 V At, VGS=0 The drain current, ID=?

Q: Zener diode is widely used as I

A: In this question we will write about zener diodes....

Q: I need the answer as soon as possible

A:

Q: The function of zener diode is to provide a constant output voltage to a load. this process is…

A: Function of Zener Diode:

Q: VDS is + 1 MQ 2 V 16 v 4.75v 24 V 8.1 V + + VGS 916 V • 2 ΚΩ OD S IDSS = 10 mA Vp=-8 V

A:

Q: The integral of the normal component of any vector field over a closed surface is equal to the…

A: Given  The integral of the normal component of any vector field over a closed surface is equal to…

Q: D +10 V R 2.0 ΚΩ Assume the diode is a practical diode with Vy= 0.7 V. If the diode is reversed, the…

A: Given circuit,

Q: The resistance of a wire with length of 6.7 mile and diameter of 0.5 in and conductivity of 3.20 S/m…

A: Ans (d) none

Q: Find X(z) and the region of convergence (ROC) for the signals below, Using Z-transform: 1. x₁[n]=…

A: Given data : X1n=12nun+-13nunX2n=-13nu-n-1+12nu-n-1

Q: Given the transfer function of the first order below, the value of K from the standard form is: G(s)…

A: Given data, Transfer function is given, Gs=810s+2.....................eqn 1

Q: The magnetic field intensity outside the solenoid is? OH = 0 OH = NI/d OH = NI/2 OHNI//2 p

A: We need to find out magnetic field at out side of solenoid

Q: 5.2. Identify the circ

A:

Q: Q.2: The parameters of a 200/3000V, 50Hz single phase transformer are given below: R₁-0.018 02,…

A: It is given that: R1=0.018  ΩX1=0.004  ΩR2=0.018  ΩX2=10  ΩRo=150 ΩXo=800  ΩZL=50-j75  Ω

Q: Q91 For the Logic Circuit shown in figure (6) write the SOP logical expression of the function (F)…

A:

Q: b. Choose the suitable choice for nine of the following sentences. 1. In order to tune a parallel…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Convert (-2, 2, 3) from Cartesian coordinate to cylindrical coordinate ? O(1.5, 3.46,-4) O(2√2,…

A: Conversion from Cartesian coordinates to cylindrical coordinates.

Frequency Modulation

Frequency modulation is a method or process of encoding the data of a specific signal (analog or digital) by modulating the carrier wave frequency according to the frequency of the modulated signal. Modulated signals are nothing more than information or data that should be conveyed after being converted into electronic signals.