ex: also could you help explain if consider this as an op-amp circuit, why the 1k ohms resistance belongs inside the amplifier but not Rin? 1. For the circuits shown below, if A=∞, Calculatea) The overall input resistance, Rinb) The output resistance, Routc) Overall voltage gain (v/vs)I.+Vs100ΩWW1kQM-+AV1+V₁

Introduction Voltage gain is the measure of how much an amplifier increases the amplitude of an…

Answered: 1. For the circuits shown below, if…

1. For the circuits shown below, if A=∞, Calculate a) The overall input resistance, Rin b) The output resistance, Rout c) Overall voltage gain (v/vs)

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 8PP: In an R-L parallel circuit, ET=48 volts, IT=0.25 amps, R=320. Find XL.

See similar textbooks

Related questions

Q: 3. Derive an expression for output in terms of input, resistance and capacitance in frequency…

Q: 100 V + 千 560 0

Q: 4. Find node voltage V and current i. 8V 4k M 12k www www 4k

Q: [CLO-4] A lossless transmission line of length 50 cm with L-10 pH/m C= 40 pF /m is operated at 30…

Q: can you resubimt with better pics of k-map and circuit

A: The values of D=∑(1,4,5,6) taken from step 2 of previous solution.

Q: 5. V(s) = 5 + 6/(s+4)-7s/(s²+25) Find v(t) -4t A) v(t) = [5 8(t) + 6 e4 – 7 cos(5t)] u(t) V B) v(t)…

A: Inverese Laplace transform formulae used in this problem are as follows.

Q: Write a matrix equation that determines the loop currents. 45 V 2023 27 V www 492 ΣΩ 4 82 692 692/13…

A: It is given that:

Q: QUESTION ONE: Suppose the differential equation is as follows a2 + 24 + 8 = 0, know that for this…

Q: Q3 Given the signal x(t) = 10 cos(2000át) × cos(8000лt), then the minimum sampling rate based on the…

A: Given- A signal- xt=10 cos2000πt × cos8000πt To Find- The minimum sampling rate according to the…

Q: 001. a) Carefully sketch and label v (t), ig(t), ic(t), and V(t) given that h=100. RB www Vin…

A: The given question requires sketching and labelling the input voltage, base and collector current,…

Q: This answer is completely wrong

Q: For the circuit shown below, V, and I, using Mesh Analysis. Also find power associated with 21x…

Q: 9.30 (Inverse Fourier Transforms) Find x(t) corresponding to each X(f). (d) X (f) = u(f+2) − u(ƒ +…

A: Invesre Fourier transform of x(f-fo) is ej2πfot x(t) FT-1 [x(f-fo)] = ej2πfot x(t).

Q: Calculate the RRRV of 131 kV circuit breaker with neutral earthed. S.C. data as follows: Broken…

Q: 9.10 (Fourier Transforms and Convolution) Given the Fourier transforms X1(f) and X2(f) of two…

Q: When connected to a 120-V (rms), 60-Hz power line, a load absorbs 5 kW at a lagging power factor of…

Q: Determine the time of operation of a 5-ampere, 3-second overcurrent relay having a current setting…

A: Given data: Secondary rated current of C.T=5A Current setting= 125% Time setting multiplier= 0.6…

Q: s) A CT LTI system has impulse response h(t) = eu(-t) + e-tu(t). = system causal? (b) Is the system…

A: We need to check whether the given system is causal or stable .

Q: Example 13. Determine the currents I₁, I₂, and ID2 for the network of Figure 16. E Si ✈ D₁ + 20 V 12…

A: In this question We need to determine the currents I1 , I2 and ID2 as shown the circuit. Assume…

Q: 2. Use Lenzs law to determine the direction of induced current in each case. Please note that the…

A: Dear student, Answer to parts d,e & f are given below

Q: C. Remember that the concentration of free electrons in a metal with atomic mass A, density d and…

Q: VL (S) Problem 2. Find the transfer function, G(s) = for each network shown below. Solve the V(s)'…

Q: Consider the circuit in (Figure 1). Suppose that i = 4.0 A. Figure 25 Ω 502 ww {100 Ω la 2002 www 1…

Q: 9.22 (Fourier Transforms from Fourier Series) The Fourier series coefficients X[k] of a periodic…

A: This question involves finding the Fourier transform of a signal which is a periodic pulse train…

Q: find the voltage vout in symbolic form + R₁ + V₁ R₂ R3 R5 RG + V/₂ + R6 VouT

Q: Calculate the power output of the shown power supply by adding the power of all individual DC…

Q: 12. Simply the following expressions to a minimum number of literals. xx + xy' = (xyz) (xy' z) =

Q: Example 15. Determine the output level for the positive logic AND gate of Figure 17. (1) E₁ = 10 Vo…

A: Given:

Q: P4- Consider the bridge rectifier shown in the figure below; with an input voltage vs = 15 sin wt.…

Q: A 10 MVA, 11 kV, 3-phase star-connected alternator is protected by the Merz-Price balance-current…

Q: QUESTION I A 10-MVA three-phase Y-connected 13,800 V two-pole 60 Hz turbogenerator has an armature…

Q: In the figure the currents are I₁ =59mA and I2 =542m.A. The voltage V₁ = 6.8 V. Determine the…

A: The given circuit diagram is shown below, The current is I1=59 mA The current is I2=542 mA The…

Q: Shown below is a cascade of two LTI systems with impulse responses of h1[n] and h2[n]. The input to…

Q: This problem uses norton equivalent could I get some help with it?

A: In this question we need to find the voltage Vo using Norton equivalent circuit .

Q: Electrical Engineering Given the RL circuit below. Use the Integrating Factor method to solve for…

A: Given:

Q: Given P(18.2, 85 deg, 124 deg) in spherical coordinate system, what is ρ (rho) in cylindrical…

Q: 7. The input waveforms applied to a 3-input AND gate are as indicated in Figure 3-80. Show the…

Q: An auto transformer starter is used to start a 3-phase squirrel cage induction motor against…

Q: 1.26. Consider a signal x (t). Show that a. If a (t) is even, then b. If x (t) is odd, then ₁x (1)…

Q: Determine the Thevenin equivalent with respect to the terminals a, b for the circuit shown in…

A: The thevenin's equivalent voltage can be calculated by using the nodal analysis and the equivalent…

Q: What is v(t) equal to for t> 0 if C=0.1 F? 4u(t) A 6523 THE Ov(t) = 24-25e¹ (1+0.5t) [V] Ov(t)=-et…

A: In this question we need to find the voltage v(t) for t>0

Q: 2. When the impulse train x[n] = Σ(28[n-7k]) is the input to a particular LTI system with frequency…

Q: It is expected that a parallel RLC resonant circuit has a midband admittance of 25 x 110 S, quality…

A: Given: In this question, the given details are, It is expected that a parallel RLC resonant circuit…

Q: How do you calculate the design of a transmission line? What equations?

Q: The magnetic field energy in an inductor changes from maximum value to minimum value in 5m sec when…

A: Introduction The energy of the magnetic field that an inductor retains is directly linked to both…

Q: R(S) Consider the closed-loop system in the following figure, where G(s) : Y(s) a) Determine the…

A: Given a closed loop system where G(s)=s+1s2+3s and H(s)=kα (a) To determine the closed loop…

Q: incorrect. it should be vth=-9v and req=3 ohms please redo correctly.

A: Thevenin equivalent,acros A-B terminal. In this circuit 1st we find Rth= Equivalent resistance…

Q: This problem uses superposition I am a little weak on this could I get some help?

Q: 2) Consider the below signal flow graph. Find, a) List all forward paths. b) List all feedback…

A: Forward path P_{1} = G_{1}*G_{2}*G_{3}*G_{4} P_{2} = G_{1}*G_{2}*G_{5} P_{3} = G_{1}*G_{2}*G_{9}…

Q: 6 (a) Is FM modulation a linear modulation? (b) Is VSB modulation a linear modulation? (c) Is AM…

A: (a) FM modulation is a non-linear modulation because there is non linear relation in received signal…

Question

ex: also could you help explain if consider this as an op-amp circuit, why the 1k ohms resistance belongs inside the amplifier but not Rin?

1. For the circuits shown below, if A=∞, Calculate
a) The overall input resistance, Rin
b) The output resistance, Rout
c) Overall voltage gain (v/vs)
I.
+
Vs
100Ω
WW
1kQ
M
-
+
AV1
+
V₁

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Find the voltage, voltage gain, input and output resistances of the circuit (RS=RC=RE=2k,RB1=150k,RB2=25k,β=100, VBE=0.6V, VT=26meV)
How to create a circuit that has three varying input voltages and one output voltage that is equal to the average of the three? Vin = V1, V2, V3Vout = (V1 + V2 + V3) / 3 Example:V1 = 750mV, V2 = 700mV, V3 = 800mVVo = 750mV You can only use resistors and OpAmps (operational amplifiers), show circuit schematic and computations/formulas used
Design a counter that counts repeatedly 0 to 7 if X=0 and counts down 7 to 0 if X=1 -Provide state diagram -Provide state table -Provide circuit diagram
(a) What are the two output currents and output resistances of the current source as shown if VEE = 12 V, βo = 125, VA = 50 V, R1 = 33 kΩ, R2 = 68 kΩ, R3 = 20 kΩ, and R4 = 100 kΩ? (b) Repeat for the circuit as shown.
A)Find the expression that gives the voltage transfer function k for V0 = k.Vs for the circuit given in the figure. B) Bölüm A'da elde ettiğiniz ifade için 1 kohm için tüm direnç değerlerini alarak k ifadesini hesaplayın.
Determine the overall Voltage Gain Av and Current Gain of the circuit below given = 100, gm = 20 us, IDss = 10 mA and Vp = - 4V.
Figure Q. 3(b) shows an op amp circuit for linear amplifier application. (i) Determine the value of current I3.(ii) Find the value of R if the output current, Io is given as 2 mA.(iii) Explain what will happen to output voltages, V01 and V02 if the supplyvoltages, +VCC and -VCC are connected to +10V and -10V.
In the circuit below, find the relationship between the output voltage ?0 and the input voltages ?1, ?2.
S2.2 Which of the following Common Source Amplifier's generalone of its features.A) The voltage gain of the circuit is always less than 1.B) There is no phase difference between the output signal and the input signal of the circuit.C) There is a phase difference of 1800 between the output signal and the input signal of the circuit.D) The voltage gain of the circuit is always less than 1.
Determine the output voltage of an op amp amplifier circuit with the following parameters: Differential voltage gain = 4522CMRR = 631Vi1 = 659 mV Vi2 = 659 mV Vi1 and Vi2 are in phase and have the same frequency. \ QUICKLY
Design a circuit that we gat Vo=2(v2-1) For differential amplifier
For a circuit shown below ?గ=1.5kΩ, β=110, RS=0.5kΩ, RL=2kΩ. Calculate: (a) Voltage gain AV= vC/vS. (b) Current gain Ai=iC/ib. (c) Power gain AP=pC/pS. (d) If RE= 200Ω is connected between terminals E and G, find the input resistance Rin between terminals B and G.