1. ) For the square foundation below determine: a) ultimate settlement and b) settlement after 140 days due to consolidation of the clay layer. Base your calculations on the values at the midpoint of the layer. 8 ft 12 ft 8 ft 16 ft q=2200 psf SAND (COARSE) Yo 110 pcf w=0.08 G,= 2.65 e=0.6 CLAY (NORM.CONSOL.) c,= 0.15 ft/day C₂ = 0.42 e₂ = 1.2 ROCK G₂ =2.57 Sult=D.126 ft 5140 = 0,087 ft

1. ) For the square foundation below determine: a) ultimate settlement and b) settlement after 140 days due to consolidation of the clay layer. Base your calculations on the values at the midpoint of the layer. 8 ft 12 ft 8 ft 16 ft q=2200 psf SAND (COARSE) Yo 110 pcf w=0.08 G,= 2.65 e=0.6 CLAY (NORM.CONSOL.) c,= 0.15 ft/day C₂ = 0.42 e₂ = 1.2 ROCK G₂ =2.57 Sult=D.126 ft 5140 = 0,087 ft

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter8: Mat Foundations

Section: Chapter Questions

Problem 8.7P

See similar textbooks

Similar questions

Refer to Figure 5.12. For a rectangular foundation on layered sand, given:●● B = 4 ft, L = 6 ft, H = 2 ft, Df = 3 ft●● γ1 = 98 lb/ft3, Φ'1 = 30º, c'1 = 0●● γ2 = 108 lb/ft3, Φ'2 = 38º, c'2 = 0Using a factor of safety of 4, determine the gross allowable load the foundation can carry.
The subgrade reaction of a sandy soil obtained from the plate load test (plate dimensions 1 m × 0.7 m) is 18 MN/m3. What will be the value of k on the same soil for a foundation measuring 5 m × 3.5 m?
Consider a continuous foundation of width B = 1.4 m on a sand deposit with c = 0, = 38, and = 17.5 kN/m3. The foundation is subjected to an eccentrically inclined load (see Figure 6.33). Given: load eccentricity e = 0.15 m, Df = 1 m, and load inclination = 18. Estimate the failure load Qu(ei) per unit length of the foundation a. for a partially compensated type of loading [Eq. (6.89)] b. for a reinforced type of loading [Eq. (6.90)]
A 300 mm 450 mm plate was used in carrying out a plate loading test in a sand, during which the plate settled 5 mm under the applied pressure of 250 kN/m2. a. What is the coefficient of subgrade reaction for a 300 mm wide square plate? b. What would be the coefficient of subgrade reaction of a 2 m 3 m foundation?
A footing 3 m x 3 m is supporting a concentric load of 1100 kN. Calculate the settlement in mm of the layer of clay considering the preconsolidation. CHOICES A. 8.37 mm B. 6.12 mm C. 7.28 mm D. 5.56 mm
A flexible foundation is 2 m x 4 m rests on granular soil at ground level. It carries a uniformly distributed load of 160 kN/m2. The sand has an elastic modulus of 39 MPa , a Poisson's Ratio of 0.3 and is 5 m thick. Estimate the elastic settlement below the center of the loaded foundation. Give your answer in cm rounded to 2 decimal places.
An oil storage tank 35min diameter is located 2m below the surface of a deposit of clay 32mthick, which overliesa firm stratum, as shown in the scheme below. The net foundation pressures at the foundation level equal105 kN/m2. The average values of mv and pore pressure coefficient A for the clay are 0.14 m2/MN and 0.65,respectively. The undrained value of Young’s modulus is estimated to be 40 MN/m2. Determine the total settlement(excluding settlement due to secondary compression or creep) under the centre of the tank.
The soil arrangement shown carries 1.88-meter square footing with a column load of 596 kN. Properties of sand: Above water table = 17.04 kN/m3, Below water table = 18.19 kN/m3. Properties of clay: 17.10 kN/m3, Cc = 0.383, void ratio = 0.65. Use H1 = 6 m., H2 = 7 m., H3 = 5 m., Df = 1 m. Determine the settlement of the normally consolidated clay in mm. Round off to three decimal places.
A rectangular footing (4.89 x 4.38 m.) is placed 1.21 m. below the ground surface. The soil arrangement is composed of sand (ground) for the first 6.52 meters and followed by clay for the next 6.98 meters. The force acting on the footing is 10,293 kN. Determine the resulting stress increase at the midheight of the consolidating layer in kPa. Assume a 2V:1H pressure diagram. Unit weight of sand = 16.1 kN/m3. Unit weight of clay = 18.7 kN/m3. Use stored value. Answer in five decimal places.
A rectangular footing (4.14 x 4.43 m) is placed 1.38 m below the ground surface. The soil arrangement is composed of sand (ground) for the first 6.29 m and followed by clay for the next 5.94 m. The force acting on the footing is 10581 kN. Determine the resulting stress increase at the midheight of the consolidating layer in kPa. Assume 2V:1H pressure diagram. Unit weight of sand = 16.8 kn/m3. Unit weight of clay = 18.4 kn/m3
A 1.8 m square, 2 m deep footing supports a service load of 570 kN. It is supported on a clayeysand. A dilatometer test run at the site has returned the following modulus profile.Depth (m) 2 3 4 5 6 7 8 9 10 11 12M (MPa) 7.7 8.8 10.2 14.8 15.4 10.8 11.6 11.6 13.1 13.8 13.4Compute the footing settlement.
A rectangular footing (4.55 x 4.8 m.) is placed 1.42 m. below the ground surface. The soil arrangement is composed of sand (ground) for the first 5.55 meters and followed by clay for the next 5.98 meters. The force acting on the footing is 10,647 kN. Determine the settlement of the consolidating layer in mm. Assume a 2V:1H pressure diagram. Unit weight of sand = 16.7 kN/m3. Clay has the following properties: unit weight = 18.9 kN/m^3, void ratio=30, liquid limit = 43