Answered: 1. pH is defined as -log[H"] where [H*]…

1. pH is defined as -log[H"] where [H*] is the molarity (M) of hydrogen ions in an aqueous solution. If the pH is 7.3(+0.2), find the molarity of hydrogen ions its error.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1P: Given the complex numbers A1=630 and A2=4+j5, (a) convert A1 to rectangular form: (b) convert A2 to...

See similar textbooks

Related questions

Q: plates is 4d, the area of the parallel plates is A / 2 and the energy stored in the system is 2W,…

Q: In an experiment done for a gas found the steady state current is 7 *10^(-8)at 8KV and distance…

A: The experimental formula as- I=I0eαd ..............(1) Here, I- current flowing in the device I0-…

Q: A barium titanate crystal is inserted in a parallel plate condenser of area 10mm x 10 mm. The plates…

A: Given; A=10mm×10mmd=2 mmC=10-9 Fε0=8.854×10-12 Fm-1

Q: A mineral water is pumped through a pipe of 15-cm diameter at a flow velocity of 3 m/s. Find the…

Q: Q1/A piece of metal is its length 5m and its cross-sectional area 0.5 mm^2 and the specific…

Q: Question 4 a Find the outer radius of a coaxial cable having a characteristic impedance of 12 and a…

Q: 7.13. Mutual inductance between a solenoid and rectangular loop. Assume that the length of the…

A: Here, we have to find the voltage between the terminals of the solenoids. So, in order to calculate…

Q: I believe the answer for part one of the question is 5 seconds. Need some help solving the other two…

Q: a parallel plates capacitor . the area of the one of ite plates A=5cm2 and the distance between…

A: electric field between the plates E=voltage difference across platedistance between plates.…

Q: Fig. 8 8) A cube with sides of length 0.750 m has a point charge of 10 uC at the center. What is the…

A: Given a = 0.750m , q = 10uC Electric flux through one of the faces of the cube

Q: (c) The energy, W (measured in joules, J) stored in an inductor, L = 7 mH + a %, can be expressed as…

Q: A channel with a rectangular cross section has a width of 3 m and a depth of 4.5 m. Determine the…

Q: Given that Rm = 2 Ohms, Imfs = 10mA, E=3 V, and assuming that R, = 300 Ohms, the Rh (half scale) for…

Q: The space between the plates of a parallel plate capacitor of area A is occupied by two blocks of…

Q: 1. A parallel-plate capacitor has a plate area of 0.2m² and a plate separation of 0.1 mm. If the…

Q: A chemist conducts an experiment in which 2.0 L of hydrogen gas is collected over water at 1 atm and…

A: Given data, vH2=2.0LT=298K Calculate PH2 Partial pressure of water vapourPH20=0.03 atm , By dalton's…

Q: b) Specify the interval of time for which the expression obtained in (a) is valid. a) Find the…

Q: Two capacitors C2 = 4uF, (C1 = 8F) are connected in parallel. If their group is charged with a total…

A: In this question Two capacitor C1 & C2 are connected in the parallel to voltage 600V. Charge Q=…

Q: The space between the plates of a flat capacitor is filled with a dielectric (porcelain, ɛ = 5), the…

A: Given data: ε=5 V=100 cm3 σ=8.85 nC/m2

Q: 3- The charge on the capacitor in the network of Fig. is 2 coulombs. If the switch K is closed at…

A: (a) E = 100 V The initial charge is q(0) = 2 C The initial voltage across the capacitor, VC(0) =…

Q: A piece of crystalline silicon (Si) is doped uniformly with 4 × 101“ phosphorus atoms/cm³. For Si, B…

Q: The distance between the plates of a capacitor, which consists of a square plate with a side length…

Q: A silicon solar cell behaves like a battery with a 0.40 V terminal voltage. Suppose that 1.0 W of…

Q: Q1: find the miller induces and d distance between plans if crystal constant for Si is 5.431 A

Q: Exercise 3.5) We want to design a 1-uF capacitor. Compute the length required for rectangular plates…

Q: h. 2 Review Consider a system with two different observables we can measure, hich we will denote A,…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: In the topic of follow instruments we need to compare and research between 2 systems Orifice plate…

Q: a) Calculate the drift velocity of electrons in aluminum wire with a diameter of 3.20 mm carrying a…

A: As per our policy, i have attempted 1 question Given I=5 AD=3.20 mm Calculating number of charges…

Q: Three points charges 3 mC, 7 mC, and -1.2 mC are located at (0,1,0),(0,0, 2), and ( 3,0,0),…

A: Given, Three points charges 3 mC, 7 mC, and -1.2 mC are located at (0,1,0),(0,0, 2), and ( 3,0,0),…

Q: Solar photovoltaic system requires charge controller to store generated electrical energy to the…

A: Given circuit is Maxwell bridge circuit. Let operating frequency as f, then ω=2πf and Z1=R1 Z2 =Rs +…

Q: Quèstion 21 In dielectric material with ɛ=2.8 ɛ0, V= sin(3p). At point P (1, 10°, 4), the volumetric…

A: Volume charge density = divergence of flux density. Flux density = E0 *ER *Electric flux intensity.…

Q: Aline of lengthi camying acharge Q produces the following electric potential at a perpendicular…

A: According to the question we have to find, What is the approximate electric potential at…

Q: a. Find the amount of charge stored on either plate of 4.4 mF capacitor connected to a 12-volt…

A: The capacitor is an energy-storing device that stores energy in its electric field. The amount of…

Q: C, 2nF Using the given circuit, calculate: C, 2nF C Sn 2) Charge across each capacitor V 24V C 2nF

A: Given circuit diagram is shown below. We need to calculate charge across each capacitor.

Q: Oil flows full bore at a velocity of 2 m/s through a nest of 16 tubes in a single pass cooler. The…

A: we have givenOil flows full bore at a velocity of 2 m/snumber of tubes =16diameter of the tubes is…

Q: (c) The energy, W (measured in joules, J) stored in an inductor, L = 7 mH + a %, can be expressed as…

A: Given energy E = 1/2 × L I2. But inductor L = (2E)/(I2)

Q: Q2/Evaluate the state space representation of the below system, if you know:

A: The state space representation can be obtained by deriving the closed loop transfer function and…

Q: (· The electron concentration in a Si sample is given by n(x) = n(0) exp(--); x>0 %3D With n(0)= 107…

A: We need to find out current density

Q: Q1 : Fill the blanks by the right answer for the following: 1- This element, constructed simply of…

Q: Q2. In an experiment in a certain gas it was found that the steady state current is 5.5 x 108 A at 8…

A: Since the field is kept constant (i.e., if distance of separation is reduced, the voltage is also…

Q: If D = exsiny a,- excosy a,+ 2z az find div D at the origin and P(1,2,3)

A: Given: D=e-xsinyax-e-xcosyay+2zaz

Q: Let's practice Question 1: A charge particle moves with a uniform velocity 4î m/s in a region where…

Q: The distance between the plates of a capacitor, which consists of a square plate with a side length…

A: Given information: The distance between the two plates of the capacitor is d=2 mm. The capacitor…

Q: Let S = 120 cm², d = 4 mm, er = 12, and V. = 40 v, calculate the capacitance C and the total stored…

Q: 1. A well drilled with salt based mud (Rmf = 0.03 ohm-m @ T:) through a reservoir rock (R =0.03…

A: When we drill well the drilling mud enter the formation and form three separate layers called 1)…

Q: Consider an intrinsic two-dimensional semiconductor in the form of a square lattice with lattice…

Question

i need the answer quickly

1. pH is defined as -log[H] where [H'] is the molarity (M) of hydrogen ions
in an aqueous solution. If the pH is 7.3(+0.2), find the molarity of hydrogen
ions its error.
A L-
2
A 11

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

SHOW COMPLETE SOLUTION. X=1, Y=2,Z=3
The y- and z-axes, respectively, carry filamentary currents 10 A along ay and 20 A along -az. Find H at ( - 3 , 4, 5).
Minimize the following minterms using K-MAP Y= m (1, 3, 5 , 9, 11, 13)
kirchhoff's laws complex circuit (please type out explanation and answer, thanks!)
A microstrip line is used as a feed line to a microstrip patch atenna.the substrate of the line a is alumina (εr = 10), while the dimensions of the line are W/d =1.2 and t/h = 0. detrmine the effective dielectric constant and characteristic impedance of the line.compare the coumputed characteristics impedance to that of a 50 Ω line.
Starting position of an object is represented as5.1±0.2m and finishing position as y=6,9±0.3m.What will be the displacement and errorindisplacement?Select one a. Displacement = 1:8m. Error=0.5mb Displacement = 1.8m, Error= 0.3mc Displacement - 1.8m, Error = 0,36md Displacement = 1.8m, Error = 0.4m
Hey, I need the answers to these questions. It's urgent. Don't critically evaluate. but don't forget to suggest applications
Which statement best describes creating a circle? A. A place slices a double-napped cone parallel to the side (generator)B. A plane slices a double-napped cone parallel to the axis of symmetryC. A plane slices a double-napped cone paralell to the baseD. A plane slices a double napped cone neither parallel to the base nor perpendicular to the axis of symmetry
Find i(t) when t < 0 not ( Note, write my name in the solution) my name is ( Muath mohmed )
Solve for Ix
Hi need solved 7.79 sedra smith
A closed loop system with G(s) = k / [ (s+3)(s+4)(s+12) ] has its dominant poles placed so the ratio of the imaginary to real parts is -1.423. If the value of the real part is -3.3, what is the angle of the system. Draw the Root Locus showing all important points/data