1. What is the 3rd band color of a five-band resistor having a resistance rating of 73.4 mega ohms and tolerance of 2%? NOTE: Write you answer in capital letters (GOLD)

Q: 1. By combining the resistors in the circuit below, find REo- 2Ω 3Ω 4Ω Rea 6Ω 5Ω 3 Ω 2. Calculate th...

A:

Q: j42 le a I2 j22 0.5Ix 1020°v I3 d I1 b 62 -j307 I4 8 20°v A 62 1220° v Ix ell

A:

Q: 5. Refer to the graphic in the Appendix (C). Determine the total capacitance in the circuit

A:

Q: ana 8. The power output, P, in Watts of an electric generator varies sinusoidally over the course of...

A: We need to find out average power and expression for power .

Q: A sample of pure Ge, has (2 mm) length, (1 mm) width, and (0.5 mm) thickness, the intrinsic resistiv...

A: We need to find required voltage for given current and resistance

Q: Q19: Choose the correct answer: i. The thyristor is turned off by: (a) Applying negative gate-cathod...

A: 1. Thyrister is a semiconductor device which act like a swtich in thyristor there are four layer and...

Q: EXPERIMENT 01 V(n002) 10V- 8V- 6V- 4V- 2V- ov- 2V- 4V- 6V- 8V- 10V- 0.00ms 150.00ms 30.00ms 60.00ms ...

A: The given circuit is a simple diode circuit. Diode: Generally it is a two terminal device which allo...

Q: Problem 2 Use impulse invariant method and a sampling period of 0.1 sec. to find the digital transfe...

A: GivenH(s)=s+3s2+4s+5T=0.1 sec

Q: 10. What unit is Inductance is measured in? Faraday Lenz Choke Henry

A: Resistance is measured in ohms Capacitance is measured in farads

Q: 10 K The diodes in the circuit are Silicon with forward voltage of 0.7 V. Fill up the table showing ...

A: In this given circuit,  Find the voltage across the diode and current in the diode?  Assume forward ...

Q: Three equal parallel resistors A, B, and C are connected in series with three equal series resistors...

A:

Q: 200 k2 20 ka V2 V = 0.2 V 200 k2 10 k2

A:

Q: A. Use this graphic for question 3 C1 C2 C3 0.47µF 0.22µF 0.27µF

A:

Q: In the figure, calculate: a) I, 1, 12 b) Construct the phasor diagram showing all the currents and t...

A:

Q: Use SUPERPOSITION THEOREM to determine io. Note: Do not remove the dependent current source, analyze...

A:

Q: Find vo in volts and io in mA

A:

Q: + V j12 -j12 2Vx I4 I3 12 I2 220°A 1220°v 12 220°A I1 ll

A:

Q: , each transmission line of the three-phase system has an impedance of 0.2/90° Q. In the

A: NOTE- “Since you have posted a question with multiple sub-parts, we will solve first three subparts ...

Q: A 3-phase wye connected 240V 60 hz 6-poles induction motor draws a total power input of 27 kW at 0.8...

A:

Q: What is the speed of an electromagnetic wave in free space?

A: Electromagnetic Waves: A alterrnating electric field produces a alternating magnetic field and vice ...

Q: An emergency system of feeders and branch circuits intended to provide power to task illumination, s...

A: Three types of circuits are there that are used in hospitals. They are  Appliance branch circuit Cr...

Q: Determine the total potential energy, in microjoules, stored in a parallelepiped of dimensions are 9...

A: We are supposed to be answer of first question as per guldlines.  

Q: K(s+1) Q2: Given the unity feedback system with G(s) = s(s+2)(s+3)(s+4) Do the following: a). Sketch...

A: In this question,  Unity feedback system is given.  Find the Asymptotes and draw the root locus.  Fi...

Q: Find the trigonometric Fourier series for the function f(x) = 0 if -2 <x <-1 and f(r) = COS I if -1<...

A:

Q: 2. Two vectors are defined at point P as F = 10a, – 3a, + 5as and G = 2a, + 5a,+ 3as. Determine the ...

A:

Q: What are the collector currents in the four transistors in the given figure for if ßF= 120 and VA = ...

A: Given the circuit as shown below: Given the values of parameters as given below: VCC=VEE=3.3 V,n=8 ...

Q: Subject: Electronics Engineering Draw the circuits of integrator and differentiator using op-amp. D...

A:

Q: 10-12 For an RF bandwidth of 1 MHz, determine the maxi- mum information rate that can be transmitted...

A:

Q: A coil of 1000 turns is uniformly wound on a ring type non-magnetic material. The mean diameter and ...

A: It is given that: N=1000I=2 Al=20 cmA=4 cm2

Q: Find State diagram in signal flow and block diagram format

A:

Q: 1. Consider a single-phase transformer with the following specifications. 20 kVA, 1200 V/120 V, 60 H...

A: NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the se...

Q: Design and implement using either Tina or LogiSim the following synchronous binary counter that coun...

A: Procedure to design synchronous binary counter: (1) Identify the number of flip flops, input, and ou...

Q: +10 V 3 V Vi ov 1.0 kn Vout -10 V

A:

Q: Design a 5-ELEMENT YAGI-UDA antenna for a 545 GHz frequency, with the following contents: a. Operati...

A: 5 Element YAGI-UDA antenna is an antenna which are fixed on a pole with 5 perpendicular metal rods o...

Q: Subject: Electronics Engineering With neat sketches explain the operation of a center tapped full-w...

A:

Q: bipolar junction transistor

A: NOTE- “Since you have asked multiple questions, we will solve the first question for you. If you wan...

Q: Develop an electro-pneumatics circuit for the following sequences. A+ A- A+ B+ B- A-

A: The electro-pneumatic action is a control system by the mean of air pressure for pipe organs, whereb...

Q: 1000 resistors are connected in parallel, and their total resistance is 2 milli ohms. If the resisto...

A:

Q: What is the output and output and state equations that describe this ?clocked sequential circuit

A:

Q: 4. I=_HA R=1 MO E=460 V

A:

Q: = 1.75A lying on the The two dipole antennas with corresponding length L, = 12, L2 xz-plane in Fig. ...

A: According to the question, for the given antenna arrangement as shown below We need to determine wh...

Q: Explain the construction and operation of CRO with diagram.

A:

Q: 2. What is the collector-emitter voltage. Use the ideal transistor. Given: R3= Yellow, Violet, Yello...

A: For the given CE amplifier the voltage between collector to emitter can be calculated by applying ki...

Q: Explain ADC and DAC with block diagram.

A: The digital circuits can be sequential or combinational circuits. The combinational circuits depend ...

Q: statement 1. overcurrent cuts the line of electricity in case of exc current. statement 2: overcurre...

A: Over-current devices are tripped in short circuit, grounding, and also OVERLOAD, so statement 2 is f...

Q: A d.c. distributor is fed at both the ends. At feeding point A, the voltage is maintained at 235 V a...

A:

Q: Three equal parallel resistors are to a 10 volts dc source. If the total current of the circuit is 2...

A: Given, Three parallel equal resistors are connected to supply voltage VT. Total current (IT) = 2 A S...

Q: 3. Two points are defined in rectangular coordinates as P(8, 2,1) and Q(-2,7, 4). (a) Give the cylin...

A:

Q: 7. If the time constant (tau) is .000033 s, and R = %3D 3.3 kOhm, then C = ? %3D .01 nF .01 uF .01 F...

A: Time constant of RC circuit is RC Where R is the resistance  And C is the capacitance. 

Q: Use only KIRCHHOFF'S LAWS to find the branch currents. Thank you!

A:

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.