1.000 volts is input into a microcontroller ADC which uses a reference of 3.3 volts. What is the ADC output if the ADC is set for 8 bit resolution? 0.333 78 1000 788 O O

Q: A 10 bit DAC has a Vref of 5.000 volts. What is 1 LSB or the smallest possible output change on the…

A: Given ==> ADC input = 0 - 5 V ADC output (10 bit) = 0 to 1111111111 in binary = 0 to 1023 in…

Q: A system can produce frequencies [1000 5000] Hz. Assume we need to convert the signal into digital…

A: Answer: THE SYSTEM PRODUCES [1000-5000]HZ .ACCORDING TO NYQUIST THEOREM TO CONVERT THE SIGNAL INTO…

Q: 1. ADC operates vithin a frequency range: 80kHz to 160kHz and the F_CPU=10MHZ. What will be the…

A: Answer:

Q: One Picoseconds (PS) is equivalent to a. 10-3 s b. 10-6 s c. 10-9 s d. 10-12 s

A: One Picoseconds (PS) is equivalent to

Q: One Picoseconds (PS) is equivalent to a. 10-3 s b. 10-6 s c. 10-9 s d. 10-12 s

A: Given: One Picoseconds (PS) is equivalent to a. 10-3 s b. 10-6 s c. 10-9 s d. 10-12 s

Q: One Picoseconds (PS) is equivalent to a. 10-3 s b. 10-6 s c. 10-9 s d. 10-12 s

A: Ans-: option (d) - 10-12 s

Q: hare 50 Kbps slotted ation outputs a 500bits once 5000 ms, even if pen sent What is the

A:

Q: 10.Assume the input frequency (fm) is 256kHz. The output frequency (fou) will be a. 16 Hz b. 1 kHz…

A: In digital electronics, a binary decoder is a combinational logic circuit that converts binary…

Q: What is the MIPS rating of the system, given a clock cycle time of 10ns (1s = 109 ns)?

A: Here first we need to find the total number of clock cycle required Total cycles required  = 0.55 +…

Q: If we want to send data at a speed of 3000 bps through a channel of bandwidth 1000 Hz, what is the…

A: Given data, Send speed of data = 3000 bps Bandwidth = 1000 Hz Find the minimum S/N ratio required.

Q: If we want to send data at a speed of 3000 bps through a channel of bandwidth 1000 Hz, what is the…

A: Given data, Speed of sending data = 3000 bps bandwidth = 1000 Hz

Q: if for 9bits ADC, VREF+=3V, VREF-=0 then the step size is O a. 5.10 mV O b. 6.64 mv O. 5.85 mV

A: Explanation: Given: ADC = 9bits VREF +=3V VREF -=0   Step size for this will be = 5.85 mV

Q: If data bits are transmitted serially at a 1 MHz rate, how many bits can be transmitted in 1 ms?

A: The data rate can be measured in terms of bits per second. It implies the number of bits transmitted…

Q: 30. An analog signal has a bit rate of 6000 bps and a baud rate of 2000 baud. How many data elements…

A: Answer: b. 3 bits baud

Q: Q9/ In a PCM system, the highest frequency component is 10 KHz. The signal is sampled at 40% above…

A: the correct answer is:-

Q: The number of bits per sample in a PCM system has SNqR=45 dB is None of them O 7 8 The 64 QAM…

A: Solution  1. the given SNqR.45 dB (SNqR)dB=6.02nb+1076 6.02nb+1.76=45 nb=45-1.76\6.02 nb=7.18 nb= 8…

Q: 101. If the bit rate for a 16-QAM signal is 4000 bps, what is the baud rate? a. 300 b. 400 c. 1000…

A: Baud rate is utilized to depict the greatest wavering pace of an electronic sign.

Q: A Multiplexer combines four 100-Kbps channels using a time slot of 2 bits. What is the bit rate ? a.…

A: Answer - (c) 400 Kbps

Q: DMA transfers 8 bits in 1 CPU cycle at regular intervals. For a 2 Mhz processor, if CPU uses 0.6%…

A: According to the given question, the answer solved below is correct and with explanation.  It is…

Q: Five sources, each with a bit rate of 1000 kbps are to be combined using synchronous TDM. Each…

A: In step 2, you will get the explanation.

Q: DMA transfers 8 bits in 1 CPU cycle at regular intervals. For a 2 Mhz processor, if CPU uses 0.7%…

A: Given processor speed : 2Mhz 0.7% of processor cycles is used for DMA. We need to determine data…

Q: An analog signal has a bit rate of 6000 bps and a baud rate of 2000 baud. How many data elements are…

A: Given bit rate=6000 bits per second baud rate=2000 bauds per second

Q: DMA transfers 8 bits in one CPU cycle at regular intervals. For a 2 Mhz processor, if CPU uses 0.4%…

A: The Answer is

Q: If the bit rate for a 16-QAM signal is 4000 bps, what is the baud rate? a. 300 b. 400 c. 1000 d.…

A: The answer is...

Q: Suppose that Fosc=40KHZ, what is the maximum delay (in milliseconds) that can be generated using…

A: - Given Fosc = 40KHz with 8-bit Timer0 and 1:2 prescaling . - The maximum delay can be calculated…

Q: A three bit LFSR is shown in figure below. Initially, the value of output Y = Y2Y1YO is set to 110.…

A: This question is from Linear Feedback Shift Registers (LFSR) using three bit with XOR gate and…

Q: A device is sending out data at the rate of 1000 bps. How long does it take to send out (a)10 bits,…

A: We can calculate this by dividing the data rate by the amount of data we want to send. Below is the…

Q: When a 24MHZ crystal oscillator used in the 8086 computer system. The bus cycle duration of system…

A: the answer is given below:-

Q: In the 8086 computer system using 15MHZ crystal oscillator, The time required to writing a word to…

A: Each timer needs a clock to work. In earlier processors the main source of clock used to be an…

Q: The highest hex address decoded by the circuit below is H. A8 A7 A6 A10- A9 ET dE2 B ROM LS 138 dcs…

A: A8 -> C, A7 -> B, A6 -> A { these are the iputs from first } A10 -> E1, A9->E2 {…

Q: 1. If binary data are transferred on a USB at the rate of 480 million bits per second (480 Mbps),…

A: Answer :- Given that, If binary data are transferred on a USB at the rate = 480 Mbps   transfer…

Q: 17. In _______ transmission, bits are transmitted over a single wire, one at a time. a. asynchronous…

A: I will be discussing In which transmission, bits are transmitted over a single wire, one at a time.…

Q: 89. Communication circuits that transmit data in both directions but not at the same time are…

A: Asked: Communication circuits that transmit data in both directions but not at the same time are…

Q: 5. A 10 bit DẶC has a step-size of a 10mV. Determine the full scale output voltage and percentage…

A: Question:-

Q: A system is using NRZ-I to transfer 10-Mbps data. What would be minimum bandwidth a. 500 kHz. b.…

A: Given that: The topic is about A system is using NRZ-I to transfer 10-Mbps data. What would be…

Q: A multiplexer combines four 100-Kbps channels using a time slot of 2 bits. What is the bit rate?

A: Introduction :Given , 4 channels Bandwidth = 100 Kbps Time slot = 2 bits we have to calculate bit…

Q: 3. Suppose that Two -7-segment displays is connected to PORTB and PORTA of a microcontroller…

A:

Q: A microcontroller DAC uses a 5 volt reference and 12 bit resolution. What code should be written to…

A: 1) DAC uses 5V reference and 12 bit resolution 12-bit can accomodate FFF in hex = 4096 in decimal…

Q: What will be the clock cycle time for a given clock rate of 8GHZ? Select one: O a. None O b. 125 ns…

A: What will be the clock cycle time for a given clock rate of 8GHz?

Q: If the symbol rate for 8PSK is 8Kbaud, the bit interval of the binary input is approximately a. 40…

A: If the symbol rate for 8PSK is 8Kbaud, the bit interval of the binary input is approximately a. 40…

Q: Five sources, each with a bit rate of 1000 kbps are to be combined using synchronous TDM. Each…

A: Java is a programming language. It contains extensive libraries (package). It can be used to create…

Q: V.90 modems with a bit rate of 56,000 bps are called a. 56K modem b. 56000 modem c. 56 modem d. 5600…

A: V.90 modems with a bit rate of 56,000 bps are calleda. 56K modemb. 56000 modemc. 56 modemd. 5600…

Q: The maximum data rate that a medium of 10 KHz and S/N ratio of 30 dB is roughly: Select one: О а.…

A: The maximum data rate that a medium of 10 Khz and S/N ratio of 30 dB is roughly

Q: Single tone signal frequency 3300hz a PCM is generated with a sampling rate of 8000 sample/sec. The…

A: Answer is given below .

Q: Calculate the theoretical highest bit rate of a regular telephone line. The signal-to-noise ratio is…

A: basically, your question is to Calculate the theoretical highest bit rate of a regular telephone…

Q: Q/ Design (2Mx16) SRAM by using (1Mbyte) SRAM.

A: Pre-charge Circuit  The pre-charge circuit is one of the imperative parts that is continually used…

Q: b-For a PCM system the number of bits that represents each sample is 5bits and the bandwidth is 0.75…

A: Given : Number of bits = 5  Bandwidth = 0.75 * Maximum Bandwidth Bandwidth = 45Khz Erfc = 0.001

Q: Q3: For a certain transistor if «dc= 0.99 and IE = 2 mA. The base current IB is? %3D

A: For a transistor, Ie = (Beta  + 1) Ib

Q: 4. S-boxes in DES map O a. 4 to 6 bits O b. 2 to 4 bits

A: S-boxes in DES map

Q: A temperature monitoring system has been developed by a local company which is RACOM SDN. BHD. The…

A: Answer