1.By using NODAL ANALYSIS solve the following electric circuit. 201 1ov E (a)Calculate the current in 4 ohms. (b)Calculate the voltage Vo and current i (c)Calculate the power supplied by the 10 volt voltage source (diCalculate the noworr cunplin

1.By using NODAL ANALYSIS solve the following electric circuit. 201 1ov E (a)Calculate the current in 4 ohms. (b)Calculate the voltage Vo and current i (c)Calculate the power supplied by the 10 volt voltage source (diCalculate the noworr cunplin

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter15: Residential Air-conditioning Control Systems

Section: Chapter Questions

Problem 23RQ

See similar textbooks

Related questions

Q: in a work environment 50 Hz 220V Find the following hardware in the power system 1. .piece 100W…

A: Given f = 50Hz Vrms =220V Since all the loads work at a rated voltage of the supply we will…

Q: A 500: 10, current transformer is used and an ammeter is connected in secondary. If ammeter reading…

A: Current Transformer In high voltage Ac system, we can not use ordinary instruments ( low rating…

Q: 8 Ω VI www Figure Link 292 W 10 V (+ 4Ω V2 A Calculate V (in volts) in the circuit above using nodal…

A: Given circuit, Ammeter reads, A = 58 A

Q: 23. In the circuit shown, the voltmeter, ammeter, and wattmeter read as follows: 230V, 1.9A, 345W.…

A: Given data, Input current = 1.9 A. Input voltage = 230 V. Input power = 345 W.

Q: Q2: the efficiency of 3 discs insulation system is 85% for a 33kv transmission line and the voltage…

Q: Design a multi range ammeter to give the following ranges 100mA, 1A, 5A, and 50A. If d'Arsonval…

Q: Use nodal analysis to compute for the voltage across each current source. 20 10 3Ω 5Ω. (1)7A 3 A…

A: Use nodal analysis to find voltage across 3A current source and 7A current source ?

Q: Suppose that each headlight of your car uses 3A and that you accidentally left the headlights on.…

A: Car one headlight consume = 3 A There are two headlights so total consumption = 6 A Battery = 12 V…

Q: Design a multi range ammeter to give the following ranges 100mA, 1A, 5A, and 5OA. If d'Arsonval…

Q: For the current divider circuit shown, calculate the following: a. The current io, in amperes b.…

Q: Calculate the direction and magnitude of the current through the 5-ohm resistor between points A and…

A: The given circuit is

Q: For the given Figure 3 , determine the following points i - calculate the value of V0

A: The turn-on voltages for Ge is 0.3 V, and Si is 0.7 V The lowest voltage diode will open up because…

Q: Which of the following is an integrating instrument? a. Ammeter b. Voltmeter c. Watthour meter d.…

A: Integrating instruments are those which are used for recording continuously some measurements for…

Q: A 15 KVA, 440/230 V, 50 Hz, transtormer gave the following test results: Open Circuit (LV side) 250…

A: The open and short circuit parameters of the transformer are given . Find the transformer…

Q: Using Mesh Analysis, determine the current "I" in the circuit. Also, determine the power absorbed by…

A: The required current I can be calculated by applying kirchhoff's voltage law to the meshes and then…

Q: Calculate the power dissipated by a 560 Ω resistor, when connected to a v = 35 sin 314 t volt supply

Q: Calculate the current flowing in the 10-ohm resistor using combination circuits and equivalent…

Q: In the circuit shown, calculate the nodal voltages ,V & V 2A V2 Vi 10 Q 20 2 4A

A: Consider the given circuit diagram and the direction of currents.

Q: Using the bottom node as reference, a) determine the voltages of all the other nodes in the circuit,…

Q: A 230/230V, 3 KVA transtormer gave the following results: O.C Test 230 V, 2amp, 100 W 04 S.c.…

A: Given: Transformer of rating 230 V/ 230 V, 3KVA Open circuit test : 230 V, 2 A, 100 W Short circuit…

Q: 4. The open circuit voltage across the output terminals of an AC power supply is 15.2 V. When these…

Q: 6. Determine the power supplied by the dependent source. 20 15 A 3is Ref.

A: We have to determine the power supplied by the dependent source

Q: (ii) Three coils each having resistance 6 2 and inductance are connected in star with 415V. If the…

A: The given R-L load is connected in star whose impedance value is calculated by dividing the phase…

Q: QUESTION 2 (a) Analyze the circuit supplied by V, = 24045°V in Figure 2(a). (i) Compute the total…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A 500 : 25, current transformer is used along with an ammeter. If ammeter reading is 5.6 A, estimate…

A: We have an current transformer which is used along with an ammeter means ammeter is connected in…

Q: 2. Three similar coils each having resistance of 23 Q and reactance of 7 2 are connected in star…

Q: Determine the current if the power rating of a particular instrument is 675 W that is connected to a…

A: Given To determine current of an instrument If Power rating, P = 675W Voltage, V = 225V

Q: What is the total cost of using the following electrical equipment's, while the 400-W cooker for…

Q: A 1000 Watt (1kW) heating element is connected to a 250v AC supply voltage. Calculate the impedance…

A: Given, Power, P=1000 WVoltage, V = 250V

Q: Use Nodal analysis to compute the voltage, Vo, across the 40 resistor in Circuit 1.

Q: Sketch Vo for the network of Figure below and determine the de voltage available. 14 Meal Dide Meal…

A: To analysis, the circuit containing more than one diode, check the diode state on/off states in each…

Q: the efficiency of 3 discs insulation system is 85% for a 33kv transmission line and the voltage of…

Q: Calculate all the voltages, currents, and total power in this balanced Y – A system: Load Source +…

Q: 2. To distribute the power at 415V over 3 phase 3 wire line, _____________ substation is used.

Q: A 200:5 current transformer is used in conjunction with 5 if the ammeter reads 1.02 find the actual…

Q: 2.By using MESH ANALYSIS solve the following electric circuit. 201 lon lov (a)Calculate the current…

A: As per our guidelines we are supposed to the first 3 subparts,if a student asks multiple subparts.…

Q: A 415 V, 3 phase, 4 wire star connected system supplies three resistive loads of 40 ohms each. The…

A: Given: A 3 phase, 4 wire star connected system VL=415 VRL=40 Ω each

Q: For the current divider circuit shown, calculate the following: a. The current io, in amperes. b.…

Q: By reducing the run time of the fans, what is the approximate savings per year?

Q: 6 mA 4 kn V1 2 6 kn 4 mA V2 3 kn 6 kn ww

Q: From the circuit diagram of power measurement using two wattmeter for delta connected load in…

A: In Wattmeter method, Instrument to measure the current is called?

Q: An electric boiler has two heating elements each of 230V, 3.5kW rating and contains 8L of water at…

A: Given: V=230 VP=3.5 kWTi=30°CTf=100°C Calculate the resistance of the boiler; R=V2PR=23023500R=15.11…

Q: Q2: the efficiency of 3 dises insulation system is 85% for a 33kv transmission line and the voltage…

Q: (i) Estimate the equivalent resistance of the circuit (ii) Compute the value of current supplied to…

Q: QUESTION 2 (a) Analyze the circuit supplied by V, = 24045'V in Figure 2(a). (i) Compute the total…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Find out the current flowing through 1k ohms resistor using Nodal method.

Q: Calculate the voltage and current at 6k-ohm resistor using nodal analysis

A: This question belongs to circuit theory . It is based on the concept of nodal analysis in the…

Q: In the circuit shown below, the external resistance connected across the terminals of the battery is…

Q: A 50kW motor is used to drive a fan that has a total head of 110m. If fan efficiency is 70%,…

A: Given, Bp=50 kWHT=110 mηf=70 %

Concept explainers

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.

Question

1.By using NODAL ANALYSIS solve the following electric circuit.
201
tov E
zi
(a)Calculate the current in 4 ohms.
(b)Calculate the voltage Vo and current i
(c)Calculate the power supplied by the 10 volt voltage source
(d)Calculate the powers supplied by the dependent current and voltage sources

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A room 8 m x 12 m is to be lighted by 18 lamps to a fairly uniform illumination of 100 lux. The maintenance factor is 0.80. If the lumen output of each lamp is 1,600, calculate the coefficient of utilization. Show detailed solution
1.6 Calculate the power and voltage of the dependent source of the following circuit.
A 50kW motor is used to drive a fan that has a total head of 110m. If fan efficiency is 70%, what is the maximum capacity of the fan? Provide solutions and schematic diagram.
The PT of a 220kV transmission line has a ratio of 100kV: 300V. A voltmeter connected line to ground reads 134V. What is the actual line voltage? Answer must be in kV and use two decimal places if necessary.
4.1. Using the “Watt” method, calculate and assess the illumination in a 40 m2 classroom, illuminated by 6 incandescent lamps (each lamp is 200 Wt).
If 2 ohm resistor is connected across the open circuit terminal. Using Nodal principle determine the current flowing through it.
It is required to provide an illumination of 100 lux in a workshop hall 40 m x 10 m and efficiency of lamp is 14 lm/W for 750 W lamp. Calculate the number and rating of lamps when trusses are provided at mutual distance of 5 m. Take coefficient of utilization as 0.4 and maintenance factor as 0.8. [12 lamps]
The dwelling unit has a floor area of 145 square meters. It has the typical household appliance including one 8 kW electrical range, two 1 hp room air conditioning unit, one 1.5 hp room air conditioning unit and one 1 hp water pump. find a.) Short Circuit current, b.) Voltage drop
The best way to draw Electrical block diagram for the following. Device 1 , 230V , 20A, 1phase Device 2, 120 V Device 3, 100 V Device 4, 12V How many outlet do I need for the whole system? Thanks.
Which of the following is not considered when finalizing the location of substation? A)availability of space B)nearness to load center C)cost of the land D)cost of the substation
By using Nodal Analysis method, calculate: - i) The value of node voltage, V1 and V2. ii) The value of current, Io Write your answer in 4 decimal places. The value of A is 59.
19/ The Impedance in a Circuit determines the amount of Current flowing in the Circuit for any given amount of Voltage according to Ohm's Law. Select one: True False