10) For Newtonian fluids, the relation between the shear stress and the rate of deformation (du/dy) is------- (a) Non linear (b) linear (c) none of the above 11) he figure shown, the----- (a) Adhesion > Cohesion (b) Cohesion > Adhesion

Q: With the temperature maintained at 0°C, two moles of an ideal gas are allowed to expand reversibly…

A: Given: Isothermal process T = 0 °C

Q: Q1) An aqueous feed containing reactant A at a concentration (1 mole/litre), at a feed rate (50…

A:

Q: The volume flow rate,Q over a V-notch depends on fluid properties namely density, kinematic…

A: Volumetric flow rate of over a V-notch depends on given fluid properties.

Q: A PFR followed by CSTR of equal volumes are arranged in series so that the conversion of 15 M of A…

A:

Q: Air passes through a horizontal duct with steady state conditions. The air enters with parameters…

A:

Q: 4. If 6.5 m³ of oil weighs 46,800 N, calculate its density in kg/m³. (a) 285 (b) 258 (c) 82 (d) 734

A: WE KNOW THAT, 1 N = 0.10197 KG Weighs = 46800 N = 46800 N * 0.10197 KG1 N  = 4772.2 KG  VOLUME = 6.5…

Q: An ethyl alcohol (ethanol) and acetone mixture (60% acetone by mass) is combined with water to make…

A:

Q: Oil introduced into a coil immersed in a stirred vessel is used to provide heat that is being…

A: Given Q-Heat transferred=7320 kJ/hour U-Overall heat transfer coefficient=250W/m2-K Toil,o=100°C…

Q: What table from perry's handbook are the specific heat capacities and what edition

A: To solve material and energy balance and in question mention that we have to calculate the amount of…

Q: Q4/ A liquid stream (70% mol A & 30% mol inert) enters a CSTR at 27 °C, at a rate of 50 liter/min in…

A:

Q: Need the flow diagram and solution. Air at 42% relative humidity at 30C is cooled to 10C at a…

A:

Q: Camper between Sorption and Surface tension

A: Sorption is basically combination of absorption and adsorption. Absorption phenomenon is used for…

Q: 9. Glycerin (SG = 1.26) and u = 1.49 Pa.s) flows through a rectangular conduit 300 mm by 450 mm at…

A: Given that S.G of glycerin ρ= 1.26 or 1260 kg/m3 Viscosity μ 1.49 Pa.s Width of conduit W=300 mm or…

Q: A step change of magnitude 3 is introduced into the transfer function Y(s) 10 X(s) 16s²+2s +0.5…

A:

Q: Cone has top and bottom diameters of 10 and 20 cm and a height of 10 cm. Calculate the shape factor…

A:

Q: A step change of magnitude 3 is introduced into the transfer function Y(s) 10 X(s) 16s²+2s +0.5…

A: Given Information: Step change of magnitude, M= 3 X(s) = 3/s The transfer function Y(s) / X(s) =…

Q: Y₂ Y B In fig. if h1= 0.5 m, h2= 1.5 m and the fluid y2 S.G= 13.6, ylis water, ?what is the pressure…

A: From Manometer reading we get,  Patm + (S.Gγ2 * density of water)*   g *h2 =  density of waterγ1  g…

Q: What is the NORMALITY of a 30% w/v NaCl solution? Show your work, answer these questions about the…

A:

Q: in a 2-hour carburizing treatment, what temperature is required to obtain a 0.5% concentration of…

A: Given data: Time = 2 h Concentration at a depth of x m = 0.5 % Initial concentration = 0.2 % Surface…

Q: Example 4.11. Given the Rxn.: C₂H₂ + 2H₂ - C₂He At the beginning of the process, 20 kg-mol of…

A:

Q: Water spinach (Ipomoea aquatica) has been found to be an excellent low-cost feed to rabbits.…

A:

Q: What process is used to process bauxite to extract alumina? a.Bayer Process b.Marignac Process…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Refer to the figure. What is the thermodynamic efficiency of the engine? O 0.80 O 0.60 0.50 O 0.70…

A: From the figure we have, TH = 1000 K TC = 200 K QH = 10 J

Q: irreversible homogeneous reaction

A:

Q: Example 4.9. In the production of ammonia (NH3) according to the following chemical reaction: N2 +…

A: Given that, production of ammonia reaction- N2+3H2→2NH3 Feed composition of reactor- Mass of N2 =…

Q: Two pipes of identical diameter and material are connected in parallel. The length of pipe A is…

A: The material of both pipes and the flow in the pipes are turbulent. The lead loss will be equal as…

Q: Water (density 1000 kg/m³, viscosity 1 mNs/m²) is pumped through a 50 mm diameter pipeline at 4 kg/s…

A: Given, Diameter of pipe line= 50mm Refer moody chart and explanation is given below

Q: kinetics of a reaction.

A:

Q: Oil flowing at the rate of 0.001 m³/s through an 8 cm diameter pipe has a kinematic viscosity (U) is…

A: Oil flow rate Q = 0.001 m³/s  Diameter of pipe D = 8 cm = 0.08 m Kinematics viscosity v = 2 × 10-5…

Q: An oxygen tank has a volume of 100 ft³. When one pound of gas is expelled from the tank, the…

A: Given that- Initial volume of oxygen tank V1= 100 ft3 Volume of oxygen expelled, V0 =1 lb (pound)…

Q: The solid shaft of radius r is subjected to a torque T. Determine the radius r' of the inner core of…

A:

Q: Show that the continuity equation of adiabatic horizontal flow can be given in the V-V²_kP₁…

A:

Q: What is the melting point of commercial sulfuric acid, in °C? Also cite your specific reference in…

A: Answer the following questions. Find the melting point of commercial sulfuric acid in C.

Q: Formaldehyde is produced industrially by the catalytic oxidation of methanol following this…

A: Given details: Reaction:            CH3OH → HCHO + H2 Mass flow rate of formaldehyde in the reactor…

Q: The Power (P) required to drive the pump depends upon the diameter (D), the angular velocity (w),…

A: Given, The variables are  Power, P Diameter, D Angular velocity, ω Discharge, Q Fluid density, ρ…

Q: In the two-tank mixing process shown in Figure below, x varies from 0 lb salt/ft3 to 1 lb salt/ft3…

A:

Q: A step change of magnitude 3 is introduced into the transfer function Y(s) 10 X(s) 16s² +2s +0.5…

A:

Q: Liquid methanol is pumped from a large storage tank through a 1-cm. ID pipe at a rate of 6.00 L/min.…

A:

Q: Q2/ Calculate the standard heat of reaction at 800 K for the complete combustion of pentane gas…

A:

Q: A solid 0.6-in.-diameter cold-rolled steel rod is pinned to fixed supports at A and B. The length of…

A: Given data: Diameter of rod = 0.6 in Length of rod = 22 in Elastic modulus = 29000 ksi Coefficient…

Q: Which is correct for the figure ? below System Square edge pipe entrance 90° elbow 50 ft Globe valve…

A: According to the diagram, there are only one Valves which is Globe valve (Fully Open), Therefore,…

Q: Amount of benzene in Still pot: ABW=W·xwABW=200 mol   Can you explain why did you write 200 mol…

A: Overall material balance: F = D + W  1000 = 600 + W  W = 400    According to question, composition…

Q: The van Laar constants A and B for the system ethanol (1) and benzene (2) at 500C are 1.79 and 1.83,…

A:

Q: A cylinder with a movable piston contains 4.00 liters of a gas at 30o C and 5.00 bar. The piston is…

A: The system is not moving and there is only minimal change in height. The potential energy and…

Q: Determine the enthalpy change when 1 mol of SO2 gas is cooled  from 538OC to -101OC at atmospheric…

A:

Q: In fig., if L= 100 cm and the angle ?--- == 25°, h Palm α 0.422 cm O 0.422 m O 0.422 mm O

A:

Q: Explain briefly the difference between crystalline and amorphous regions in a polymer.

A: Introduction: Polymers: A polymer is a big molecule or a macromolecule which essentially is a…

Q: A fuel consisting of 60% ethane and the balance propane is burned using 191% excess air. Complete…

A:

Q: Situation 1: The mass of glycerin is 500 kg with a total volume of 0.315 m³. 1. Compute the unit…

A: Mass of glycerine = 500 kg  Total volume of glycerine = 0.315 m³

Q: A tank shaped like a vertical cylinder initially contains water to a depth of 9m. The bottom plug is…

A: