10 kips 3 kips/ft D B. 3 ft 4 ft 3 ft

Q: d) What is the equivalent permeability which will govern the productivity of the following well? re=…

A: given- ke=500 m/dka=5 m/d

Q: ..... If the link AB is connected to the beam BC, as shown, the horizontal reaction at C equals You…

A:

Q: hezy’s constant. For a bed slope of 1/2500, find the flow rat

A: Hydraulic radius is R=Wetted AreaWetted perimeterWetted Area=B×y=3×1=3m2Wetted…

Q: Problem 2 Compute the shear and moment diagram of the given figure below. Show complete values in…

A:

Q: Question It is required to design a collector road pavement in an urban area composed of 3 layers…

A: Flexible pavement  Flexible asphalt pavements or roads bend or deflect in response to traffic loads,…

Q: Tinet 2m B 8.

A:

Q: The truss shown in the figure has a uniform cross – sectional area of A and modulus elasticity E. 4.…

A:

Q: In a horizontal highway curve, if the width of the highway is 10 m and the outer edge is 40 cm…

A: Given data- width of highway W=10 m=1000 cmrise of outer edge=40 cm

Q: 4. From the previous problem, compute for the Reynolds Number. a. 145.692 b. 219.953 c. 89.901 d.…

A: Aa there is no question given lets take suitable data: Given Data:take Fluid viscosity μ=…

Q: Table Q2: Result of Standard Proctor Test Mass of wet soil in the mold (kg) Moisture content (%)…

A: Weight Moisture content Unit weight Dry Unit weight 1.68 9.9 1780.98166 1620.547461 1.71 10.6…

Q: The present population of a community is 20,000 w ith an average w ater consumption of 4200 m³/day.…

A:

Q: A reversed curve with diverging tangents is to pass through three lines to form a centerline of a…

A: Given: The bearing of line AB is N 88o E. The distance of AB is 120 m. The bearing of line BC is N…

Q: W hen the galvanized ion sheets com e w ith dim ensioans (2x1)m.Caaulate the num ber of sheets…

A: Given Data:Sheet dimensions = 2×1mFrictional Pressure drop=1pa/mAllowable Height =300mm

Q: Att = 0, a projectile is located at the origin and has a velocity of 20 m/s at 40° above the…

A:

Q: Student Portal : FEU.. EG8245H5 Das Google M Inbox (258) - 20191... Mga Klase ? Student Login…

A:

Q: If safety is really important, then why most construction workers we have in the country did not go…

A: Yes, Safety is really important. Below has the explanation

Q: determine the (a)depth in m and (b) area in sqm of the economical trapezoidal brick lined channel…

A:

Q: the computed depth of the rectangular section

A: Efficient channel: - It is defined as a channel which provide maximum discharge for a given…

Q: h + b/2 b/2 P.

A:

Q: What are the production process of steel and other similar products of steel-describe the process

A: Steel is produced from iron ore or residues. Iron ore is an aggregate of minerals that can be…

Q: What is the minimum “B” for the base of a dam 30m high if upward pressure beneath the dam is assumed…

A: Solution: Given: H = 30 m a = 6 m b= ? water thrust = 3700 kg/m weight of the concrete = 2.5

Q: 30 it 50 100 100 50 50 8. Calculate the area subjected for tensile on the pattern above due to block…

A:

Q: Question 6. If the required moment (M») for a fully braced A992 steel beam is 440 k-ft, pick the…

A: Given data:- The ultimate Moment (Mu) = 440 k-ft Grade of steel = A992

Q: Y수 45 CM 20 CM 100 CM

A: this question is from basic mechanics of solids and this question a shaded area is given and we are…

Q: 35 At the construction site, 3 m thick clay layer is followed by 4 m thick gravel layer which rest…

A:

Q: Find the volume to be excavated if the ground surface is to be leveled to elevation 3.3m.

A:

Q: 1. 100 mm, 225 mm 75 mm 50 mm 125 mm

A:

Q: Find importance on the fire protection and prevention regulations and in what manner can you assure…

A: Workplace fire safety is essential in order to avoid or minimize the damage caused by fire. Fire…

Q: Determine the oil surface elevation at section 1. Elevation = ? 60 m k,- 0.040 mm 8-0.1 m Elevation…

A:

Q: what are the engineering solution to reduce accident??

A: Accidents are very unfortunate incidents that may lead to the loss of lives and properties. The risk…

Q: the river flow passes through a 2.08 wide rectangular sharp crested weir. If the water level several…

A: Given,  Coefficient if weir Cw = 0.637 Width of river  B = 2.08 m Depth of water in channel H = 1.4…

Q: 20kalm 100 KN D bm

A:

Q: A subway train travels between two of its station stops with the acceleration schedule shown. (a)…

A: Given: Acceleration- time graph of a subway train   Find (i)  velocity after 14 sec (ii) time…

Q: An underpass crossing a reinforced concrete bridge along the Shaw Blvd. has a downward grade of - 4%…

A:

Q: PROBLEM: A rectangular beam has a clear span of 8.0 m and carries a working live load of 14.0 kN/m…

A:

Q: A 300 mm square bearing plate settles by 15 mm in a plate load test on a cohesive soil when the…

A:

Q: Q-14: A soil has a void ratio of 0.70, degree of saturation 50% and G =2.7. Find the water content,…

A:

Q: A jet from the nozzle, 30mm in diameter, is directed against a stationary flat plate. The velocity…

A: Given: Vjet = 20m/s, Vplate = 5m/s, d = 30mm

Q: Why is the failure envelope flat in a UU triaxial test or an unconfined compression test

A: It has been asked in the question why failure envelope is flat in UU triaxial test

Q: Determine the discharge in MLD of a 2800 mm gravity flow concrete aqueduct with a hydraulic gradient…

A:

Q: effective stress for the soll at point A

A: Given: To find: Effective stress at A

Q: value of Chezy constant i

A: Given:  Manning's coefficient, N=0.023 Hydraulic Radius , R=3 m   To find: value of Chezy's constant

Q: A rectangular log of wood is floating in water with a load of 100 N at its centre. The maximum shear…

A: A rectangular log of wood is floating in water with load of 100N at its centre. It has been asked in…

Q: | Engineering he ordinates at 1-hr intervals of a 1-hr unit drograph are 15, 33, 56, 72, 44, 23, and…

A: Given that 1 hr intervals of 1 hr unit hydrograph R1 = 2 mm R2 = 1 mm R3 = 1.5 mm

Q: A circular highway curve has the following design elements: . I = 65°32'17" D = 3°52'00" • Pl…

A: Solution-The given values are as follows,I=65°32'17''D=3°52'00''PI sataion=36+4500PI…

Q: A vertical rectangular gate 2 m wide and 1.2 m high has water on one side with surface 3 m above its…

A:

Q: 80 11 B 10 mm 10 mm 80 10 mm

A:

Q: Find the normal and shear stresses

A: This question has been taken from solid mechanics

Q: For a V-shaped concrete lined channel with total included angle of 80°, and a depth of 3 m if the…

A:

Q: Homework 1-2.2: Find the Reactions 136k 5k/ft 6/ft 3k/ft 2k/ft B-Q 15' 3' 6' 3' 1' 3-1-1 3-1-2…

A:

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.