[10 pts.] Without using trigonometric identities, express the following in phasor form. DO NOT SIMPLIFY IT! Just write a complex expression by inspection- do not follow up with any complex arithmetic! V2 cos (wot – T/4) + 5 cos wt - 4 sin wt

[10 pts.] Without using trigonometric identities, express the following in phasor form. DO NOT SIMPLIFY IT! Just write a complex expression by inspection- do not follow up with any complex arithmetic! V2 cos (wot – T/4) + 5 cos wt - 4 sin wt

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.2MCQ: If the rms phasor of a voltage is given by V=12060 volts, then the corresponding v(t) is given by...

See similar textbooks

Related questions

Q: A sinusoidal signal generator operates on 150 KHz frequency; if a T.L is used to deliver the energy…

A: We need to calculate length of transmission line for which losses are minimum means line matched .

Q: According to the image answer the following questions. a) Determine the system function H(z). b)…

Q: ASAP

Q: (b) Given that a total impedance of a series circuit is Z = 10 – j13 Q and the operating frequency…

A: In this question, Total impedance Z= 10-13j Operating frequency f= 60Hz. Sketch the series and…

Q: The expressions for the steady-state voltage and current at the terminals of the circuit seen in the…

A: Given ,Vg=350 cos 5000πt+84°Vg=350∠84°ig=6 Sin 5000+127°ig=6 Sin 90+5000πt+37°ig=6 cos 5000πt+37°…

Q: Prove the following expression by using phasors: 10 cos(@t)+10sin(@t) = 14.14 cos(@t – 45°)…

A: The solution is given below

Q: Let x(t) = E=-, S(t – nT). Then x(t) can be written in a 2n trigonometric form as (wo =) A. E1, sin…

A: We need to calculate trigonometric Fourier series coefficient.

Q: 5. A voltage v(t) = 230 sin wt when applied to a circuit supplies a current given by the %3! 14…

Q: V, 39 I, -j16 N V = 150 /0° V V = (78 – j104) V V, = (72 + j104) V I, = (-26 – |52) A I, = (-2 + j6)…

Q: In this example, you shall see that the entire row is zero. We're going to form auxiliary equation…

A: In this question we need to form RH table for the given system.

Q: Simplify the following expression: Y=ABC + ABC +ABC + ABC

Q: For the circuit illustrated in Fig. 10.59, (a) redraw, labeling appropriate phasor and impedance…

Q: A circuit branch is found to have an equivalent impedance of Z=120−j45Ω. It is given that this…

A: Impedance: Impedance of a circuit is the combination of all the resistance as well as reactance. It…

Q: Determine all the branch currents in this circuit using Kirchhoff's Analysis. Problem Requirement:…

A: Given circuit :

Q: If a current of I = 30 cos(1000t + 60°) mA was found to be flowing through an impedance found…

A: according to the ohm's law if the impedance is Z and current i I then value of the votlage is given…

Q: Example-Series-1: For the RL circuit, find (1) w, T, L, ZT (2) I†, VR, V L (3) Average power of each…

Q: Given: P.Q. 04 Find the phasor voltage V, that corresponds to the difference of the time-domain…

Q: I RLC Series Circuit wi V=10V, R=1kΩ, XL1=2kΩ, XL2=2kΩ, & XC=7.5kΩ. a. Find Z in rectangular and…

A: (b)

Q: if y=sin(x), z=cos(x), v3y+x, where (-100 <x< 100) could you plot y, z, v as shown below:

A: Given,

Q: 1 Given f(z) (z + n (n: odd)). Then cos (z) f(z)=? O None of these -1 (cos (z))2 O -sin (z) (cos…

A: For the given question we have to find the value of f'(z)

Q: Compose the mesh equations. 10 Q j10 O j10 2 ll ell 10 V [11] [12] :-10 2 sine sine

Q: A 0.875 A section of 50 S252 Tossless line is driven by a source with…

A: The value of the input voltage vi can be calculated as: vi=vg×ZinZg+Zin Now the value of Zg(=Z0) is…

Q: 2.) A sinusoidal voltage source is represented by the vector pointing to 6 + j4 on the complex…

Q: Plot a Root locus of the system 12 005 K²009 10? G(s)H(s) = thot S ( 5 + 2 + 2 j ) ( S + 2 − 2jj…

Q: 11 Q 33 mH 128 322230° Z13 mH Z2 5Ω. 66 µF

A: Let the value of frequency is f = 50 Hz. The expression for the impedance Z1 is given by,…

Q: Find Z,Z2. Z1/ Z2, Z¡ + Z2, Z, - Z2 and write your answers in both polar and rectangular format…

A: The values of the impedances is given as: Z1=10+j5Z2=20-j20 The calculations of the above…

Q: Find Z₁ for maximum average power transfer and the maximum average power transferred. 1 Ω 1Ω…

Q: 3) Plot the root locus for the characteristic equation Por a system K so, when as K varies for it…

A: In this question, Characteristics equation is given. 1+GH= 0. Draw the root locus for the K>0.…

Q: Q.20: For the circuit shown, find the transient mesh currents i, & iz as a function of time by using…

A: In case of inductor IL0- = IL0+ In case of capacitor VC0-=VC0+ At T=0- So due to open circuit…

Q: Problem #1 Find the phasor transform in rms of each trigonometric function: a) v(t) = 170 cos (377t…

Q: In the given expression below, what is the resulting computed value (in rectangular form)? Z = (2 +…

Q: Questions 25 Given: ZL, Zc Find the Thévenin equivalent voltage VTh and impedance ZTh at terminals…

Q: 1) In a certain region J = (2ya, + xza, + z*a,)sin10*t A/m, Find p, if P„(x,y, 0, t) = 0.

Q: Problem # 1 Find the phasor transform in rms of each trigonometric function: v(t) = 170 cos (377t -…

A: According to question: c) The PHASOR transform in RMS is calculated as…

Q: Solve the equation using Cramer's rule (10 + j20)I, -+ j10I, = 60/30° (13.3.1 For mesh 2, j101, +…

Q: Without using trigonometric identities, express the following in phasor form. DO NOT SIMPLIFY IT!…

A: The given expression in the question is to be solved in the phasor form. Ewe will derive the phasor…

Q: A delta-connected impedance is given by Za = Determine Za in both Cartesian and polar form given z,…

Q: H.W.: Given the phasor voltage V = 115V245 V across an impedance Z = 16.2619.3 Q, obtain an…

A: Given, V=1152∠45°Z=16.26∠19.3°ω=50 rad/s

Q: Use the phasor analysis method to solve for the AC steady-state mesh currents, and then express each…

Q: Find the admittance YabYab in the circuit seen in the figure. Take that R1 = 5 Ω , 2R = 2Ω , R3 = 7…

Q: Transform G = (2x+y) ax − (y−4x) ay in cylindrical form at point Q (ρ, φ, z). Hint: use x = ρ Cos φ…

Q: Compose the mesh equations. 10 Q j10 Ω j10 Ω ... ell A) 10 v [1] sine ) i5 v j5 V sine -j10 O [12]…

A: In this question, We need to determine the current I1 and I2 as shown the circuit?

Q: V=20/150° -302-60° V. Represent V in single phasor and find the time domain expression v(t) when the…

Q: Consider the circuit diagram where Vs = 230020 Vrms Z, Z, Z, Find: 1. The apparent power delivered…

Q: What is the result of the following in time domain? 20 sin 400t + 10 cos(400t + 60) – 5sin(400t –…

Q: Problem #2 Zn the Circuit Shown below if Ve = 8 145, Calculate Ÿs ' -jz sz I, 22 R, V Vs V.

A: we need to find out Vs in the given circuit.

Q: 9. Find the two square roots of 16(cos - jsin) using De moivre's theorem. Express in rectangular…

Q: 1. In what quadrant of the complex plane are these numbers located? -12+j7 -10-j50 8-j2 1+j100 2.…

A: In general, a complex number is represented by x+jy. According to the values of x and y, the number…

Q: In the Transmission Line Simulator, th Transmission Line is composed of wh parameter/s? O A. The…

A: Transmission line simulator useful to know behaviour of transmission line under various load…

Q: At o=600 rad/s , Y=0.3+j0.2, then Z at 300 rad/sec is Z- Z/ q where Z= .2, p=... a- 1.97,-20.4 b-…

Question

[10 pts.] Without using trigonometric identities, express the following in phasor form.
DO NOT SIMPLIFY IT! Just write a complex expression by inspection- do not follow
up with any complex arithmetic!
V2 cos (wot – T/4) + 5 cos wt - 4 sin wt

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Answer is j11.56
A circuit branch is found to have an equivalent impedance of Z=120−j45Ω. It is given that this impedance is a series combination of a 120Ω resistor and another passive component. If the circuit has a sinusoidal voltage source whose frequency is 120 Hz. What is the value of the component in series with the 120Ω resistor? (Note: Express the value assuming a metric scaling of μ(10-6). Provide your answer in decimal form, up to 3 decimal places.)
A series circuit of RLC with following parameters, R=15 ohm, L=20 m H & C=100 micro Farad. VT=169.7 sin (337t-30) Volt. Find the following: Zt, , It, Voltage across each element, Power factor, apparent power, real or average power and reactive power and the total phasor diagram and power phasor diagram
Suppose that the modulating signal m (t) is sinusoid of the formm (t) = 10 COS ( 2π103t) and the carrier signal C(t) is sinusoid of the form C(t) = 4 COS ( 2π106t + Ɵ)1. According to the previous results which type of AM is the best in respect toa. Power transmitted b. band widthJustify your answers2. Draw the block diagram for both DSBSC and DSBFC with all parameters.
Given the voltage v(t) = Vmax cos(ωt + θV) and current i(t) = Imax cos(ωt + θI) signals. (2b-1) Derive the instantaneous power equationp(t). Note: The desired expression will only have cosine functions. (2b-2) Identified the frequency component from p(t) and identifythe radian frequency present on this signal. (2b-3) Identified the DC component of p(t).
x(t)= C0 + C1*sin(w*t+theta1) + C2*sin(2*w*t+theta2) x(t)= A0 + A1*cos(w*t) + B1*sin(w*t) + A2*cos(2*w*t) + B2*sin(2*w*t) A0=-1, A1= 5, B1= 6, A2=-3, B2= 4, w=500 rad/sec. Express all angles between plus and minus 180 degrees. Determine C0, C1, theta1 (deg), C2, theta2 (deg)
A resistor of 100 Ω, a coil of 4.50 uH and a capacitor of 220 pH are in parallel. What is the impedance vector at8.50 MHz?A. 100 + j 240 ohms C. 100 – j 240 ohmsB. 258u + j160.6 m ohms D. 258u - j160.6m ohms
Write a Matlab code to sketch using plot function, y(t)=3 sin(t) for 3 periods
NEED ASAP Pleas answer this problem Maximum Average Power Transfer Pls show full and complete solution
What is the product of two complex numbers 4 + 3j and 2+ 2j where j = sqrt (1-) in phasor notation? Write the answer in the form, to make it easy to type, magnitude AT angle in radians.
The total capacitance and inductance are C=2x10^(-6) F and L=3x10^(-6) H. The physical length of the line is 900 m. (up to 4 decimal places) >time delay t_d >velocity factor k >velocity of propagation v_p in m/s using the distributed parameters >velocity of propagation v_p in m/s using the relative dielectric constant.
Determine the time-domain expressions for the line-to-line voltages vAB, vBC, and vCA. Please report your answer so the magnitude is positive and all angles are in the range of negative 180 degrees to positive 180 degrees