Answered: 10. When there is 12 mA of current…

Engineering

Electrical Engineering

10. When there is 12 mA of current through a 1.2 kn resistor, the voltage across the resistor is

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter27: Service-entrance Equipment

Section: Chapter Questions

Problem 32R

See similar textbooks

Related questions

Q: Vc = -3.50 Vo = 8.50 C positive half cycle 1.5 Vo = -1.50 KHH negative half cycle 4

A: Given circuit, Graph,

Q: 1.You are synthesizing a chip composed of some logic with an average activity factor of 0.1. You are…

Q: Q5) For the waveform shown below, find Vrms v(t) A 2 LAA: 4 6 l10 t -1

A: The given waveform is shown below. Find Vrms.

Q: Simplify the Boolean function F(w, x, y, z)=Σ(4, 5, 6, 7, 12) with don’t-care function d(w, x, y,…

A: from given function construct K map and simplify the function.

Q: (c) x(t) = cos( 2 = t Je™¹u(1-3). os(n) sin(2/2). mon (d) x[n]=c =cos

Q: Consider the system shown in Figure (1). This is a PID control of a second-order plant G(s). For the…

Q: 21) State FIVE of the followings: 1- Discriminator circuit 5- Sampling theory 2-TDM 6- Nyquist rate…

A: Since you have posted a question with multiple subparts, we will solve first three subparts for you.…

Q: 1.You are synthesizing a chip composed of some logic with an average activity factor of 0.1. You are…

A: Given Date average activity factor = 0.1 average Switching capacitance= 450 PF/mm2 area = 70 mm2…

Q: The equivalent capacitance at terminals a-b in the given circuit is 10 μ F. Calculate the value of…

A: The given circuit is, Where the equivalent capacitance between terminal a and b is 10 μF.

Q: Calculate the actual sag and vertical sag from the following information (1) Carrying capacity of…

Q: Calculate the distribution factor for a single-phase alternator having 8 slots/pole (1) when all the…

A: We have been asked to find the distribution factor (Kd) of the a single-phase alternator having 8…

Q: The system that has the transfer function G(s) = Underdamped system Undamped System Critically…

A: Given data, Transfer function is given as, Gs=144s2+6s+144

Q: c) The superheterodyne receiver (SuperHet) is an architecture that enables the same receiver to…

A: BLOCK DIAGRAM OF SINGLE STAGE SUPERHETERODYNE RECEIVER

Q: What is a spike in noise term

A: ANSWER NOISE---> Noise is a…

Q: Simplify F(A, B₁C₁D₁E) = {m (0.4, 7, 8, 9, 12, 16, 18, 20, 22, 23, 24, 25, 26, 27, 28, 30) woing а)…

A: Given data: FA,B,C,D,E=∑M0,4,7,8,9,12,16,18,20,22,23,24,25,26,27,28,30 Find (a) K-map.

Q: A single phase transmission line has two parallel conductors 6 m apart, the ra dius of each…

A: We have an single phase transmission line which has two parallel conductor and given data as,…

Q: Simplify the following Boolean expressions, using three variable K-maps: F(x,y,z)=xy+x′y′z′+x′yz′

A: Given: Simplify the following Boolean expressions, using three variable K-maps: F(x, y,…

Q: 23. A 75 load uses 2 W of power. The output voltage of the power supply is approximately A. 120 V B.…

Q: What is settle time?

A: Settle time: The time that has passed between the application of an ideal instantaneous step input…

Q: In the network below, find the power associated to the current source, for V1 = 8 V. V₁ 24 Select…

Q: In the following circuit, find the current Ix, and the power associated to the dependent source.…

A: Given data, V=5 V, Vx=1 V Circuit diagram is given as,

Q: Design a 18 person voter system using 4 bit parallel adder(s) only. Use a minimum number of…

A: Given components: 4-bit parallel adders To design: An 18-person voter system using a minimum…

Q: 25. A 68 resistor is connected across the terminals of battery. The power dissipation of the…

A: Given data: R=68ΩV=3V

Q: PROBLEM 3: DETERMINE THE CURRENTS USING KCL IN THE во сошель, сets . Із SA LOA CRTA | 2 97 Туза 12…

A: We need to find out current for given circuit

Q: A coil 250 turns is connected to a 50 V DC source. If the coil resistance is 10 ohm, the mmf…

A: Given a coil having, Total number of turns, N = 250 Connected across voltage source, V = 50 V (dc)…

Q: • Calculate the average and rms values of the following periodic voltage signal. V(1) in volt 300…

Q: Design a binary counter that counts from 0 to 5. At each clock pulse, 3 lights will be ON and 3…

A: According to the question, the given binary counter counts digits from 0 to 5. Also by using JK…

Q: The two wattmeter method is used to measure the power in a three-phase load. The wattmeter readings…

A: Given- Three phase load-Wattmeter readings=400W & (-35) WTo Find-The total active power Pactive

Q: 4.40 Use the mesh-current method to find the power PSPICE developed in the dependent voltage source…

A: First we will assign mesh current then we will apply mesh current method that is Kirchhoff voltage…

Q: 1₁-1₂ 1₁ + 1₂ Adding eqs. (i) and (ii), we have, 1₁ + 1₂ On solving eqs. (iii) and (in = j5 1₁-1₂ =…

A: The required current can be calculated by solving the given two equations and then convert the…

Q: Find the equivalent Inductance for the following circuit shown below. L oooo 0.5 H elle 2 H oooo…

A: Given circuit:

Q: b. Find the current I, e. Draw the power triangle. d. Find the type of elements and their impedance…

Q: 1. A lighting load of 600 kW and a motor load of 707 kW at 0.707 lag are supplied by two alternators…

A: I am attaching detailed solution image of this question.

Q: Consider the following system X₁=x₂-1 X₁₂=X²₁²-x₁ - x₂ + 1 Find the equlbrium 2

A: Please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Q: DESCRIPTION OF SIMILARITIES AND DIFFERENCES OF DC AND AC CIRCUITS WITH RESISTIVE AND CAPACITIVE…

A: The resistance is the measure of the ability of an electric component to oppose the flow of electric…

Q: A fiber optic cable with a numerical aperture of 0.65 is to be spliced to a second fiber optic cable…

A: Given Numerical aperture of first fiber optic cable (NA1) = 0.65 Numerical aperture of second fiber…

Q: (e mra Given an amplifier with an effective noise temperature of 15,000 K and an 8MHZ bandwidth,…

A: Given- Temperature = 15000 K Bandwidth = 8 MHz To find- Thermal noise level =?

Q: The number of roots of s³ + 2s² +7s + 3 = 0 in the left half of the s-plane is : one two zero three

A: Given characteristics equation, s3+2s2+7s+3=0

Q: Part 1 Find the equivalent resistance Rab for the circuit shown in (Figure 1). Suppose that R1 =…

Q: is the hard limiter system is memory-less or memory system? (1, y = x ≥ 0 x < 0°

A: It is given that: y=1,x≥00,x<0

Q: 2. A current of 6 A flows for 10 minutes. What charge is transferred? [3600 C1

A: Given data Current I = 6A Time t= 10 minutes = 10 × 60 seconds = 600…

Q: A sequential circuit has one flip-flop Q, two inputs x and y, and one output S. It consists of a…

A: Considering the sequential circuit. Determining the truth table. x y Q(t) S C=D D=Q(t+1) 0 0 0…

Q: A 400 V, 6 pole d.c. The field and armature winding resistances of a shunt motor are 400 ohm and…

Q: Design an astable multivibrator using a 555 timer IC with an output of 800 Hz. Calculate also the…

Q: Electrical oscillations are initiated in a series circuit containing a capacitance C, inductance L,…

A: (a) The amplitude Q=Qmaxe-Rt/2L at time t, with Qmax being the initial amplitude When Q=12Qmax we…

Q: 2. A lighting load of 1500 kW and a motor load of 2200 kW at a p.f. of 0-707 lagging is supplied by…

Q: In an induction motor, if the rotor is locked, then the rotor frequency of induction motor will be:…

A: Given that The rotor of the induction motor is locked. Then the rotor frequency of the induction…

Q: A signal is sampled at 384 000 samples per second. The samples are encoded as 32-bit words a)…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 2. A current of 6 A flows for 10 minutes. What charge is transferred? [3600 C]

A: Given Current = I = 6A Time = T = 10 minutes Charge is a property of matter. The amount of charge…

Q: What is RG rating of coaxial cable? Give detailed answer please

Concept explainers

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.

Question

10. When there is 12 mA of current through a 1.2 kn resistor,
the voltage across the resistor is
A. 14.4 V
B. 1.4 V
C. 100 V
D. 10 V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three coils each having resistance 6  and inductance are connected in star with 415V. If the line current is 30 A, If θ = 45 then calculate the power dissipation in kW when it is connected in Delta?
A friend brought a 960 W electric coffee maker from Europe, designed to work with a 240 V. power supply (a) What should it do to connect the appliance in a 120 V source? (b) What should be the current that the coffee maker consumes from a 120 V line? (c) What is the strength of the coffee maker? (The value of each voltage is a effective value.)
Determine the voltages vx and the power absorbed by the dependent source
A distribution line supplies a load of 60∠300 A lagging at a voltage of 240∠ 150 V. What is the angle between voltage and current?
15KW coal power plant is transmitting power through 11KV transmission line calculate the current that will flow in 11KV transmission line. also calculate the losses if resistance of transmission line is 20 ohms?
A copper transmission line is to be replaced by one of aluminum having the same total resistance. If the cross sectional area of the copper wire is 0.005m2 , what would be the cross sectional area of the new aluminum wire? Note: DRAW THE DIAGRAM
Find the current flowing through the 10 Ohm resistor by using Norton's theorem.
1. A 300W electric heater at 110-V with a safety fuse in the circuit handling 15A of current. How many heaters can be safely operated in the circuit? 2.A heater uses 20A when used in a 110-V line. If electric power costs 11.50 per kilo watt hour, the cost for running the heater for 10 hour is? Give the given and solution as well. thank you so much
For the circuit shown, If G=200 μS and the power delivered to the conductance is 8 W,find ig and vg.
1. A 300W electric heater at 110-V with a safety fuse in the circuit handling 15A of current. How many heaters can be safely operated in the circuit? 2.A heater uses 20A when used in a 110-V line. If electric power costs 11.50 per kilo watt hour, the cost for running the heater for 10 hour is?
An electric cooker operates at 12A of current when connected to a 240 V supply for 1 hour a day. The electricity bill for a month (30 days) in OMR for a unit price of 20 baisa is..
A single-story house has average kilowatt-hour consumption per month is 4.75 kWh/m2/day. How many solar panels do you need to cover its electricity demands? Use a 250Watt solar panel with and a derate-factor of 85%.