10KN/m 5KNM A -5m

Q: Find a nondimensional relationship for the pressure drop.

A: This question has been taken from Fluid mechanics

Q: A soil sampling probe at D is supported by the mechanism shown which allows the probe to pivot up…

A: Given Data = 50lb angle =15deg

Q: If the velocity is not uniform in the plastic tube, what is the effect of this on the Bernoull…

A: The velocity is not uniform but the flow should be in streamline. Then Bernoullis equation can be…

Q: 25 kN/m A 4 m B 3 m El is constant

A: Solution:- Deflection in the section AB, of beam due to uniformly varying load is given by…

Q: Using Dim, solve for the following 40kN/m 30 kN-m 7.0 m 3.0 m 4.0 m a. Maximum Deflection b.…

A: Given simply supported beam with loading conditions and it is asked to find maximum deflection and…

Q: Bar AB of figure has a uniform cross section, a mass of 25 kg, and a length of 1 m. Determine the…

A: M=25kg L=1m

Q: 10KN/m 5KNM A 5m

A:

Q: If the potential function for a conservative onedegree- of-freedom system is V = (10 cos 2θ + 25 sin…

A: Given potential function:

Q: Briefly explain the Mazo's limit.

A: According to the question, we need to explain Mazo’s limit.

Q: A thin plate 2 m wide is placed in a uniform air stream of velocity 100 m/s, = 1.2 kg/m). If the…

A: Solution: Given Data: h=2mU∞=100 m/sδ=1.2 kg/m3FD=60 NuU∞=yδ1/6δ=B.L thickness at edge of plateWe…

Q: Using only the Equation Method. From the figure shown, 50 kN 30 kN/m 10 kN-m OD 10 m 2.5 m 2.5 m

A:

Q: Pressure in a pipe carrying oil (Specific Gravity 0.92) is 20 kN/m². A piezometer is connected to…

A: Given data : Pressure (P)=20 KN/m2Specific gravity (S.G)=0.92Density of water (ρWater)=1000 kg/m3

Q: A counterrotating eccentric mass exciter as shown below is used to determine the Problem 2.…

A:

Q: Ex.: Determine the forced response of the three degree-of-freedom system shown in Figure. X3 500 N/m…

A: Given :

Q: The P force of intensity 30N is applied perpendicular to the BC portion of a curved bar, as shown in…

A:

Q: use slope-deflection method to compute the reactions for the following structures 2. 2 m 4 m C ΕΙ…

A:

Q: Find the capillary rise ( h) in the tube shown in the figure for a water-air-glass interface with =…

A:

Q: Analyze the structure below using Double Integration Method. Compute for the 2nd arbitrary constant…

A:

Q: The submerged sector gate AB shown in the figure is 1/9 of a circle of radius 4 m. The length of the…

A: Radius of the circle = 4mLenght = 10m19th part of circle = 360×19⇒ θ = 40°

Q: A simple mass-spring oscillatory system consists of a mass m, suspended from a spring of stiffness…

A: given- mass of the system=mstiffness of spring=kdisplacement at time t=zequation of motion=mz+kz=0

Q: If the potential function for a conservative onedegree- of-freedom system is V = (12 sin 2θ +15 cos…

A: The given potential function is,

Q: 10KN/m 5KNM A 5m

A:

Q: The velocity distribution in an open channel could be approximated as in Figure: 2. Determine the…

A: From fig:let v be velocity at any positionvu=D-DaDv=u1-a

Q: A plate is 50 cm diameter and has a sharp-edged orifice at its center. A water jet strikes the plate…

A: Given data -

Q: 1. The Dam ABC has a width of 30 m into the paper and the dam bottom length is 60m. The dam material…

A: We will calculate each moment and find FOS.

Q: Blocks D and E have a mass of 4 kg and 6 kg,respectively. Suppose that F= equilibrium.Determine the…

A: Data Given :

Q: 5. Solve for Equilibrium. 3000# Wi 750#/ft W2 100#/ft R1 R2

A:

Q: Analyze the structure below using Double Integration Method. Compute for the 2nd arbitrary constant…

A: We will apply boundary conditions to get the values of constant C2

Q: 3. The beam AB in the Figure supports a load which varies an intensity of 220 N/m to 89O N/m.…

A:

Q: For the structure shown below, if E is constant, what is the distribution factor at ?joint B (DFBA)…

A: Finding out distribution factor of BA.

Q: Analyze the structure below using Double Integration Method. 10KN/m 5KNM A 5m- Compute for the 1st…

A: Using double integration method we will find the 2 equations of slope and deflection.  We will then…

Q: The cross section of the fixed free-end beam, whose loading condition is given below, is symmetrical…

A:

Q: sing Double Integration Method fo e deflection of beams analyze the ven structure below. 12KN/m 25KN…

A:

Q: 4. The schematic representation of a two-degree of freedom system is shown below. For the given…

A:

Q: 9.29 A laminar boundary layer velocity profile is approximated by u/U-[2-(v/8)](/8) for y s 8, and u…

A: uU=[2-yδ](yδ)For profile to be parbolic (i)Wall  velocity is zero  (at y=0)(ii) u=U(iii)dudy=0(i)at…

Q: Show that the motion of a critically damped system due to initial displacement u(0) and nitial…

A: Introduction- Damping is an impact inside or on an oscillating system and reduce or prevents its…

Q: For the flow of a thin layer of liquid down an inclined plane shown: a. Using the cross-hatched…

A: Note : Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: DISTRIBUTION METHOD. From the indeterminate frame shown, find the moment E in kNm. El is constant.…

A: The moment distribution method is generally a method to analyze the structural analysis method for…

Q: The submerged sector gate AB shown in the figure is 1/8 of a circle of radius 4 m. The length of the…

A: Given Data: Length of gate is L=10 m. Height of gate is H H=4 msin45°=2.828 m

Q: The submerged sector gate AB shown in the figure is 1/8 of a circle of radius 4 m. The length of the…

A:

Q: In the beam depicted above, ?A is a fixed support. The magnitude of ?=365?/?W=365N/m, ?=60?P=60N and…

A: To analyze the given cantilever beam for support reactions and internal forces and moments.   Given,…

Q: Which of the following nearly gives the value of 6Ab/L in kN-m^2.*

A:

Q: If the potential energy for a conservative onedegree- of-freedom system is expressed by the relation…

A: The potential energy function for a conservative one degree system is,

Q: Problem 3 An electric winch lifts a weight on the end of a 5-mn jib pole. Determine angle 0 for the…

A: We have to use cosine rule to solve this.a=5  b=7  c=8m and theeta=C So, c^2=a^2+b^2 -2ab × cosC

Q: A ship sails in sea-water (p = 1024 kg / m ) at a velocity of 25 m / s. A 1:10 model is sailing in…

A: given LpLm=101density ρp=1024 kg/m3ρm=1000 kg/m3velocity Vp=25 m/sFp=430 N

Q: An irrotational, incompressible velocity field is described by the stream function   (a) Plot…

A: Consider the given function a} Steam line ψ = 0 23r3/2sin32θ=0sin32θ=032θ=nπθ   =n2π3 So we have…

Q: A simple mass-spring oscillatory system consists of a mass m, suspended from a spring of stiffness…

A:

Q: 2. Determine the deflections at point A and point E using Double Integration Method (DIM). 10 k/ft 5…

A:

Q: 4. Determine the resultant of the three forces acting on the dam shown and locate its intersection…

A: