R1 ● www R3 www. C1 L12 • For the circuit shown above, calculate the energy stored in the capacitor C1. Assume 11 =16 A, R1 = 24 Ohms, R2 = 12 Ohms, R3 = 31 Ohms, L1 = 18 H, and C1 = 30 F. For the circuit shown above, calculate the energy stored in the inductor L1. Assume 11 = 26 A, R1 = 16 Ohms, R2 = 29 Ohms, R3 = 48 Ohms, L1 = 14 H, and C1 = 41 F.

R1 ● www R3 www. C1 L12 • For the circuit shown above, calculate the energy stored in the capacitor C1. Assume 11 =16 A, R1 = 24 Ohms, R2 = 12 Ohms, R3 = 31 Ohms, L1 = 18 H, and C1 = 30 F. For the circuit shown above, calculate the energy stored in the inductor L1. Assume 11 = 26 A, R1 = 16 Ohms, R2 = 29 Ohms, R3 = 48 Ohms, L1 = 14 H, and C1 = 41 F.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A battery of emf 30.0 V is connected to a switch, an inductor of inductance ? = 0.600 ? and two resistors, R1 = 10.0 ? and R2 = 6.00?. The switch is initially open. A. What are the values of currents ?1, ?2, ?3 just after the switch is closed? (Just give an answer) ?1 = ?2 = ?3 = B.)Which point, a or b, is at higher potential or are they at the same potential, just after switch S is closed? (Just give an answer) C. What is the value of current ?1 through the battery a long time after the switch is closed? Show your work and briefly explain your logic
By means of a battery, a capacitor C1 of 3.55 μf is charged until it reaches a potential difference △V0 = 6.3 volts. Then the battery is removed and as shown in the figure below, the capacitor is connected to another discharged capacitor C2 of 5 μf until equilibrium is achieved, with both capacitors at the same charge. a) What is the potential difference in each? b) What is the energy stored in the electric field before and after closing the switch?
Calculate the gravimetric capacitance of a carbon based electrode with an aqueous electrolyte solution. Assume the surface area of the carbon electrode is 1200 m2/g, and the relative static permittivity of the aqueous electrolyte solution is 80. The permittivity of free space is 8.85 × 10−12 F/m. Indicate any other assumptions you have to make.
Derive an expression for the electrical energy stored in a capacitor of capacitance C when charged to a potential difference V. If C = 2µF and V= 4V, calculate(l.) the final energy stored in the capacitor,(II.) the work done by the battery in the charging process Account for any difference between your answers in parts (I) and (II) above
A 500 ohm resistor, an 1.5 F uncharged capacitor, and a 6.16-V emf are connected in series. (a) What is the initial current? (b) What is the time constant? (c) What is the final voltage on the capacitor? (d) what is the final charge on the capacitor? What is the final energy stored in the capacitor? (e) Express (i) Current in the circuit, (ii) Voltage on the capacitor, (iii) Charge accumulated on either plate of capacitor, (iv) energy stored in the capacitor as a function of time. (must include all the value calculated in the earlier part). (f) What is the i) current ii) charge on capacitor, iii) voltage on capacitor & iv) Energy stored in the capacitor after one time constant?
4- Can value of the string efficiency being equal to 100%. Explain your answer.5- Outline methods used to equalize the potential across the units.6- Why an insulator is represented as a capacitor C? What are the assumptionmodes?
1. For the network shown in Figure 1:(a) Determine the mathematical expressions for the variation of the current in the inductor following the closure of the switch at t = 0 on to position 1.(b) When the switch is closed on to position 2 at t = 100 ms, determine the new expression for the inductor current and for the voltage across R.(c) Plot the current waveforms for t: 0 to t = 200 ms.
the emf source, E=3.2 V, of the circuit shown in the figure has negligible internal resistance. the resistors have resistances R1=3 ohm and R2=4.2 ohm. the capacitor has a capacitance C= 3.1uF. A) determine the time constant t , in units of microseconds for charging the capacitor. B) what is the charge Q on the capacitor in units of microcoulomb?
For the following circuit, do the following:a) Write the mathematical expressions for the voltage VC, VR1 and IC if the switch is on theposition 1.b) Find the voltage VC, VR1 and IC if the switch changes to a position 2 at t = 100ms.c) Determine the discharge time of the capacitor.d) Draw the charge and discharge waveforms.
A capacitor is made from two flat parallel plates placed 2 mm apart, .and its capacitance at vacuum is 10-12- F , if 200 volt applied in between then a Dielectric material was entered and its Dielectric constant Is 49 , Calculate : a) the new value of capacitance after the entrance of the Dielectric b) what is the value of charge on Dielectric material surface c) the polarization p of the Dielectric material d) calculate the displacement and the field inside the Dielectric
Sustainable energy folks are investigating the possibility of creating super sized banks of capacitors that store electrical energy during low demand times so that it can be used during peak demand times. Suppose such a capacitor was designed to deliver 3.50 Megawatts for a period of 8.00 hours. (1 Megawatt is 1 million Watts). By how much would this capacitor bank's mass decrease as it is discharged? ________ kg
A potential difference V(t) = V0sin ωt ismaintained across a parallel-plate capacitor withcapacitance C consisting of two circular parallel plates. Athin wire with resistance R connects the centers of the twoplates, allowing charge to leak between plates while theyare charging.(a) Obtain expressions for the leakage current Ires(t) in thethin wire. Use these results to obtain an expression for thecurrent Ireal(t) in the wires connected to the capacitor.(b) Find the displacement current in the space between theplates from the changing electric field between the plates.(c) Compare Ireal(t) with the sum of the displacementChapter 16 | Electromagnetic Waves 733current Id(t) and resistor current Ires(t) between theplates, and explain why the relationship you observe wouldbe expected.