Answered: 11. A beaker, partially filled with a…

11. A beaker, partially filled with a liquid is rotated by an angle 30° as shown. If the pressure at point B becomes 12 bar, what will be the height (in cm) of the beaker? A 30° B

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 9. A 15 kg mass is initially moving up a smooth incline at 10 m/s. What will be its acceleration…

A: Question is based on the mechanics . A body of certain mass is moving on incline surface . Mass and…

Q: A ball of mass 5kg and a block of 12 kg are attached by a light weight cord that passes over a…

A: Given, The ball of mass m1 is 5 Kg, The block of mass m2 is 12 Kg, g=9.8 m/sec2

Q: water surface 1.0 m 2.0 m

Q: SITUATION: The tank shown in figure is accelerated to the right. Determine the pressure at point Bin…

Q: A sphere 900mm-diameter floats half submerged in a tank of oil (sg=0.90) What is the total vertical…

Q: SITUATION: An open cylindrical vessel 1.3 m in diameter and 2.1 m high is 2/3 full of water. If…

Q: Activity 2. In the figure, the coefficients of friction are as follows: 0.25 between blocks, 0.20 at…

A: Given data: Coefficient of friction between blocks = fb=0.25 Coefficient of friction at the floor,…

Q: b ▼ 2m 2m 2m 15m a

A: Given:- Coefficient of friction=0.60γconcrete=23.5a=28 mb=25 m Different types of forces acts on a…

Q: A vertical conduit is carrying oil (S = 0.95). A differential mercury manometer is tapped into the…

A: Given: The specific gravity of the oil is 0.95. Consider the figure,

Q: 10. A couple parked in a car on a moonlit evening find that there is stuck in the sand. The woman,…

Q: In the figure shown, determine the weight that can be carried by the 1.5 kN force acting on the…

A: To determine the weight that the piston can carry. Given, Load acting on the piston (F) = 1.5 kN…

Q: H.W An inverted right circular conical tank, as shown in the figure, is initially filled with water.…

A: Given:- Ht = h Radius = r To find:- height of water function of time v(t)=2gh(t)Between the points A…

Q: QI A closed tank is filled with water and has a 1.8m diameter hemispherical dome as shown in Figure.…

A: Draw FBD: Where,

Q: Moving Question 37 A pressure gage 10.82 m. above the bottom of a tank containing a liquid reads…

Q: Problem 2 Determine: (1) What is the torque in tube (G=100 GPa) and rod (G=45 GPa)? (2) What is the…

A: Given data: Gtube = 100 GPa Grod = 45 GPa L = 1m D = 60 mm

Q: A sphere 850mm-diameter floats half submerged in a tank of oil (sg=0.90) 4. What is the total…

Q: A sphere 900mm-diameter floats half submerged in a tank of oil (sg=0.90) 4. What is the total…

Q: To what height will the jet of fluid rise for the conditions shown in the figure?

Q: Please help with solving

Q: The figure shows the water pressure acting on the sides of a dam that is 20-m long. Determine the…

Q: Example 4.11.A weight of 100 KN is moved through a distance of 8 metres across the deck of a pontoon…

Q: A vertical conduit is carrying oil (S=0.95) as shown in figure 2. A differential mercury manometer…

A: Given data, the specific gravity of the oil is 0.95. we have to Determine the difference in…

Q: A Pitot tube in the pipe in which air s flowing is connected to a manometer containing water as…

A: Given : The difference water level in the manometer x=87.5mm = 0.875m Tube coefficient Cp=0.99 Now,…

Q: 1. Starting from rest, an elevator weighing 8.9kN attains an upward velocity of 5m/s in 4 seconds…

Q: On the ceiling, a spring is attached with a 3 kg mass to the other end. Here on earth, the…

A: The mass of the object is m=3 kg. On Earth, The acceleration due to gravity is ge=9.81 m/s2. The…

Q: A 0.133 kg body undergoes simple harmonic motion of amplitude 6.23 cm and period 0.100 s. (a) What…

A: The calculations for simple harmonic motion are as follows -

Q: water surface 1.0 m 2.0 m

Q: 5 = 500 N 5 = 300 N Ę = 200 N

Q: 13. A beaker of height 30 cm is partially filled with a liquid and is rotated by an angle 0 as…

A: Gauge pressure is pressure relative to atmospheric pressure; it is positive for pressures greater…

Q: Q7. If the surface tension at air - water interface is 0.069 N / m, what is the pressure difference…

A: The given data is: Surface tension between air-water interface (σ) = 0.069 N/m Diameter of air…

Q: 10. In case of spherical bodies with uniform mass distribution, what is the position of center of…

A: The unique location where the weighted relative position of the distributed mass adds to zero is…

Q: A ball weighing 1 kg is “floating" on a circular jet, as shown in the figure (ignore the wire, which…

Q: For Figure 9.2 as shown, determine the centroidal moment of inertia about x and y axis, -500 mm-…

A: Given:- A composite figure is given To determine:- The centroidal moment of inertia about the x and…

Q: A pressurized tank contains water with some air above it. As shown on figure below. Multi-fluid…

A: Absolute pressure:- absolute pressure is the sum of gauge pressure and atmospheric pressure. Gauge…

Q: Activity 1. In the figure shown, the coefficient of friction is 0.25 for all surfaces of contact.…

A: Hi there! since you have asked multiple questions, we will solve the first question for you. If you…

Q: In the figure shown, Given: B =1.3 m/s 0 = 60° Solve for: a) velocity of A (m/s) b) angular velocity…

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of…

Q: A 4 cm diameter water jet with a velocity of 40 m/s impinges tangentially onto a fixed vane…

Q: In the figure below, determine the force F (newton) to balance the weight of the cylinder. Cylinder…

Q: A concrete dam given in the figure has water 21 m deep acting on its vertical sides. The coefficient…

A: Given Data:Coefficient of friction= 0.60 γconcrete=23.5kN/m3a= 26mb=21m

Q: In a demonstration of the momentum of fluid flow, a circular plate was suspended in equilibrium on…

Q: Auniform ladder of length 2.1 m and mass 20 kg leans against a vertical wall to make an angle of a =…

A: What is the minimum value of P(N) required to prevent downward sliding of the ladder?

Q: Starting from rest, an elevator weighing 8.9kN attains an upward velocity of 5m/s in 4 seconds with…

Q: Determine the acceleration of the system shown. 30 30 12 kg 8 kg

Q: A mass weighing 9lb stretches a spring 4in. If the mass is pushed upward, contracting the spring a…

A: For the given conditions, the position u(t), frequency, period, amplitude, and phase of the motion…

Q: 5. The 1.5m diameter solid cylinder shown is 7m long perpendicular to the figure and rests in static…

A: Bouyancy vertical force is equal to weight of cylinder.

Q: Problem 1.2 Two water tanks are connected to each other through a mercury manometer with inclined…

A: Asked: To determine the value of angle theta θ. Given: Pressure in tank A (PA) = 20 kPa Pressure…

Q: Situation #3: A weight concentrated at the end of a cord forms a conical pendulum for which the…

A: To find Velocity of weight?

Q: In the shown figure, both the tank and the tube are open to the atmosphere. If A = 70 cm, B 80 cm,…

Concept explainers

Asphalt Binders and Mixtures

Asphalt binders are subsidiary products procured during the refining process of petroleum while manufacturing gasoline, diesel, and similar petroleum products. Asphalt binders are obtained from the residue that remains after the distillation of petroleum, this residue is further subjected to steam distillation and oxidation to remove the traces of gas oil present in the residue. Certain additives or modifiers are also added to asphalt binders to alter them to suit different applications.

Question

I need the answer as soon as possible

11. A beaker, partially filled with a liquid is
rotated by an angle 30° as shown. If the
pressure at point B becomes 12 bar, what will
be the height (in cm) of the beaker?
A
30°
B
a) 23.5
b) 24.5
c) 26.5
d) 27.5

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

8. Water flows into a vertical cylindrical tank at 12 ??³ /???; the surface rises in 6 ??/???. Find the radius of the tank.
A jet issues from the side of the tank under a head of a=4.36m. The orifice is positioned 5.94 meters above the bottom of the tank. Determine the point it strikes a horizontal plane c=1.17m below the bottom of the tank. Assume the jet will follow a projectile motion. The angle is 47 degrees and Cv=0.938.
A calibration test of a 2.5cm circular sharp-edged orifice in the vertical side of the large tank showed a discharge of 590 N of water collected in 81 seconds, when under a constant head of 4.70 m. In addition, measurement of the trajectory of the jet gave the following data: A point on the jet has the coordinates in cm (235, -30), with the orifice located at the origin of the rectangular coordinate system. Find the value of Cd. answers: a.0.989 b.0.636 c.0.629 d.0.98
ENGINEERING FLUID MECHANICS: open channel flow 1.) At what depth will water flow in a 4m wide rectangularchannel if n= 0.018, S0 = 0.0009 and Q = 7m3/s. 2.) In a rectangular channel, 4m wide with Q= 7.65m3 /s thedepth is 0.4m. If a hydraulic jump is produced, (a.) what willbe the depth immediately after it? (b.) what will be the lossof energy?
An open cylindrical tank 3m in diameter, 6m high filled with water at 4m depth. Determine the area uncovered at the bottom if its rotated at 10 rad/sec
A 75 mm horizontal pipe of circular cross section conveying water under a pressure of 0.75bars has its diameter reduced from 75 mm to 2 mm by means of a short transition 30 mm in length. The pipe empties into the atmosphere. The discharge is 0.14m3.s-1, what is the percentage change in mean velocities? The pipe is anchored to a pillar with the anchoring having a factor of safety of 1.5. What force must the anchor withstand to achieve the above?
27. Which of the following most nearly gives the rise above the ground surface when a piezometer is placed at point A?a. 5.42 mb. 3.08 mc. 4.83 m d. 3.67 m28. Which of the following most nearly gives the rate of seepage through the flow channel per m width a. 4.667 x10-5 m³/sec b. 1.866 x10-5 m³/sec c. 5.598 x10-5 m³/sec d. 2.333 x10-5 m³/sec29. Which of the following most nearly gives the total rate of seepage through the permeable layer per mwidth?a. 3.733 x10-5 m³/sec b. 4.667 x10-5 m³/sec c. 6.222 x10-5 m³/secd. 1.866 x10-5 m³/sec
In a rectangular channel 4m wide with Q=7.65m3/s the depth is 0.4m. If a hydraulic jump is produced, (a.) what will be the depth immediately after it? (b.) what will be the loss of energy?
11 A cylindrical caisson having an outside diameter of 9 m floats in sea water with its axis vertical and its lower end submerged 9 m, below the water surface. If its center of gravity is on the vertical axis and is 3.6 m above the bottom. a. Determine the value of ??? b. Find the true metacentric height. c. Find the righting couple when the caisson is tipped through an angle of 8°
A sight is taken with an Engineer's Level at rod held 200 meters away and an initial reading of 2.3 meters is observed. The bubble is then level through 7 spaces on the level tube, and the rod reading is 1.8 meters. One division in the level tube is equal to 0.6 mm. ASAP PLEASE What is the total distance moved by the bubble in seconds? What is the difference in rod readings in meters?
what size of pipe is required to carry 450 liters per second of water with a headloss of 3.5m for 5000m length? assume mannings coefficient = 0.011 choices 1. 934mm 2. 823mm 3. 832mm 4. 817mm
Water flows through an orifice at the vertical side of a large tank under a constant head of 2.2. How far in meters horizontally from the vena contracta will the jet strikes the ground 1.5 m below?